2001 TOYOTA PRIUS fuse chart

2001 PRIUS (EWD414U)
B
The ºCurrent Flow Chartº section, describes which parts each power source (fuses, fusible links, and circuit breakers)
transmits current to. In the Power Source circuit diagram, the conditions when battery power is supplied to each system
are explained. Since all System Circuit diagrams start from the power source, the power source system must be fully
understood.
Theft Deterrent and Door Lock Control
J POWER SOURCE (Current Flow Chart)
11
1
EA1 1EA2 3
7
EB16
E 6
E 7I 2I 2
I 2
E 7
E 7
E 7
2
1
1
2
2
2
2
2
B
B
W W
B B B B BW±B
B
B
B B±O
B±W
W±B
B±W STARTER RELAY INJECTION RELAY15A HAZ±RADIO7.5A AM250A MAIN 1.25B FL MAIN
BATTERY
WWW
W W W
R W±L
W
W
G±W
G
15A TAIL
20A DEFOG
15A RAD CIGTA I L
RELAY 7.5A DOME 40A DOOR LOCK CB
2 1
1 2
4 8
2 3
3 4
G
W±R
P±L B±Y
B±Y
W±R
AM2 IG2
ACC
IG1AM1W W
W±R
W W
W±B
21
1
1
1
1
2
2
2
2
3
4
3
4 1
2
1
22
1
11
1
IGNITION SW I 8
Battery
30A AM2
2
Starter S 220A RADIO NO.1
10A HORN
15A EFI
7.5A DOMEShort Pin
10A HAZARD
The chart below shows the route by which current flows from the battery to each electrical source
(Fusible Link, Circuit Breaker, Fuse, etc.) and other parts.
Engine Room R/B (See Page 20)
ABS
ABS and Traction Control
Cruise Control
Electronically Controlled Transmission and A/T Indicator
Multiplex Communication System
Cigarette Lighter and Clock
Key Reminder and Seat Belt Warning STOP
Fuse Page
194
214
11 2
System
DOME 20A
10ACombination Meter
Headlight
Interior Light
2
2
6 100A ALT
EB1
POWER SOURCE
Light Auto Turn Off187
180
166
210
230
122
10A ECU±B
5 60A ABS
2
6 Fusible Link Block2
*The system shown here is an EXAMPLE ONLY. It is different to the actual circuit shown in the SYSTEM CIRCUITS SECTION.

2001 PRIUS (EWD414U)
J POWER SOURCE (Current Flow Chart)
Fusible Link Block No.1 (See Page 22)
FuseSystemPage
100ADC/DC
Illumination
Key Reminder and Light Reminder Buzzer
Light Auto Turn Off
Taillight
TOYOTA Hybrid System92
11 4
104
88
54
Fusible Link Block No.2 (See Page 23)
FuseSystemPage
5ADC/DC±STOYOTA Hybrid System54
120AMAIN
ABS
Engine Control
Headlight (w/o Daytime Running Light)
Hybrid Vehicle Immobiliser System
Illumination
Key Reminder and Light Reminder Buzzer
Light Auto Turn Off
SRS
Taillight
TOYOTA Hybrid System172
68
84
78
92
11 4
104
167
88
54
Engine Room R/B No.3 (See Page 24)
FuseSystemPage
7.5ADRLHeadlight (w/ Daytime Running Light)80
10AABS NO.4ABS172
30AHTR1Air Conditioning188
30AHTR2Air Conditioning188
40AABS NO.1ABS172
50AEMPSEMPS164
50AHTR3Air Conditioning188
Engine Room J/B (See Page 26)
FuseSystemPage
10ABATT FANTOYOTA Hybrid System54
10AHEAD (LH)Headlight (w/o Daytime Running Light)84
10AHEAD (RH)Headlight (w/o Daytime Running Light)84
10AHEAD HI (LH)Headlight (w/ Daytime Running Light)80
10AHEAD HI (RH)Headlight (w/ Daytime Running Light)80
10AHEAD LO (LH)Headlight (w/ Daytime Running Light)80
10AHEAD LO (RH)Headlight (w/ Daytime Running Light)80
10AHORNHorn
Theft Deterrent124
146
10ATURN±HAZTurn Signal and Hazard Warning Light96
*These are the page numbers of the first page on which the related system is shown.

2001 PRIUS (EWD414U)
J POWER SOURCE (Current Flow Chart)
FuseSystemPage
7.5AECU±B
Door Lock Control
EMPS
Gateway System
Headlight (w/ Daytime Running Light)
Hybrid Vehicle Immobiliser System
Interior Light
Key Reminder and Light Reminder Buzzer
Light Auto Turn Off
Power Window
Theft Deterrent
Wireless Door Lock Control134
164
160
80
78
108
11 4
104
126
146
140
7.5AOBDIIEngine Control
Theft Deterrent68
146
7.5ATAIL
Key Reminder and Light Reminder Buzzer
Light Auto Turn Off
Taillight11 4
104
88
10AACC
Combination Meter
Gateway System
Navigation System
Radio and Player
Remote Control Mirror
Shift Lock
SRS182
160
156
152
130
132
167
10AGAUGE
ABS
Air Conditioning
Back±Up Light
Combination Meter
Door Lock Control
EMPS
Engine Control
Headlight (w/ Daytime Running Light)
Key Reminder and Light Reminder Buzzer
Light Auto Turn Off
Navigation System
Power Window
Rear Window Defogger
Seat Belt Warning
Theft Deterrent
TOYOTA Hybrid System
Turn Signal and Hazard Warning Light
Wireless Door Lock Control172
188
102
182
134
164
68
80
11 4
104
156
126
180
11 8
146
54
96
140
10AHTRAir Conditioning188
10ASRS ACCSRS167
*These are the page numbers of the first page on which the related system is shown.

DI±6
± DIAGNOSTICSENGINE
2001 PRIUS (RM778U)

TOYOTA hand±held tester only:
When the diagnosis system is switched from normal
mode to check mode, it erases all DTCs and freezed
frame data recorded in normal mode. So before
switching modes, always check the DTCs and
freezed frame data, and note them down.
(1) Prepare the TOYOTA hand±held tester or OBDII
scan tool (complying with SAE J1978).
(2) Connect the TOYOTA hand±held tester or OBDII
scan tool to DLC3 under the instrument panel lower
pad.
(3) Turn the ignition switch ON and turn the TOYOTA
hand±held tester or OBDII scan tool switch ON.
(4) Use the TOYOTA hand±held tester or OBDII scan
tool to check the DTCs and freezed frame data;
note them down. (For operating instructions, see
the OBDII scan tool's instruction book.)
(5) See step 4 to confirm the details of the DTCs.
NOTICE:

When simulating symptoms with an OBDII scan tool
(excluding TOYOTA hand±held tester) to check the
DTCs, use normal mode. For code on the DTC chart
subject to º2 trip detection logicº, perform the follow-
ing either action.

Turn the ignition switch OFF after the symptom is
simulated the first time. Then repeat the simulation
process again. When the problem has been simulated
twice, the MIL lights up and the DTCs are recorded in
the ECM.

Check the 1st trip DTC using Mode 7 (Continuous Test
Results) for SAE J1979.
(c) Clear the DTC.
The DTCs and freezed frame data will be erased by either
action.
(1) Operating the TOYOTA hand±held tester or OBDII
scan tool (complying with SAE J1978) to erase the
codes. (See the OBDII scan tool's instruction book
for operating instructions.)
(2) Disconnecting the battery terminals or EFI fuse.
NOTICE:
If the TOYOTA hand±held tester switches the ECM from the
normal mode to the check mode or vice±versa, or if the
ignition switch is turned from ON to ACC or OFF during
check mode, the DTCs and freezed frame data will be
erased.

DI82L±02
± DIAGNOSTICSHYBRID VEHICLE CONTROL SYSTEM
DI±197
2001 PRIUS (RM778U)
DIAGNOSTIC TROUBLE CODE CHART
HINT:
Parameters listed in the chart may not be exactly the same as your reading due to the type of instrument
or other factors.
If a malfunction code is displayed during the DTC check in the check mode, check the circuit for that code
listed in the table below. For the details of each code, turn to the page referred to under the ''See page'' for
the respective ''DTC No.'' in the DTC chart.
DTC No.
(See page)Detection ItemTrouble Area
Hybrid
System
Warning
Light*
Memory
B2799
(DI±210)Immobilizer Malfunction
Wire Harness

Immobilizer System
C2692
(DI±212)Regenerative Brake Check±
C2693
(DI±212)Regenerative Brake Check±X
P1120
(DI±213)Accelerator Pedal Position
Sensor Circuit Malfunction
Accelerator Pedal Position Sensor

Wire Harness
P1520
(DI±215)Stop Light Switch (Cruise Con-
trol System) Malfunction
Stop Light Switch

Wire Harness

Brake ECU
X
P1566
(DI±217)Cruise Control System Malfunc-
tion
Stop Light Switch

Brake ECU

Wire Harness
X
P1600
(DI±219)BATT Malfunction
HV Fuse

Wire Harness
P1780
(DI±221)Park/Neutral Position Switch
System Malfunction
Park/Neutral Position Switch

Wire Harness
P3000
(DI±223)HV Battery Malfunction

HV Battery System

High Voltage Fuse

Power Cable

HV Battery Cooling System
/X
P3001
(DI±224)HV Battery ECU Malfunction
Battery ECU
P3004
(DI±225)Power Cable Malfunction

Power Cable

HV Battery System

Service Plug

System Main Relay

Converter & Inverter Assembly
/X
P3100
(DI±229)HV ECU Malfunction

Wire Harness

HV ECU

ECM

Crankshaft Position Sensor

Camshaft Position Sensor

Ignition Switch

P3101
(DI±237)Engine System Malfunction
Engine

HV Transaxle
P3105
(DI±238)Battery ECU Communication Cir-
cuit Malfunction
Wire Harness

Battery ECU
P3106
(DI±240)ECM Communication Circuit
Malfunction
Wire Harness

ECM/X

± DIAGNOSTICSHV BATTERY CONTROL SYSTEM
DI±329
2001 PRIUS (RM778U)
INSPECTION PROCEDURE
1 Are there any other codes (besides DTC P3005) and other ECU being output?
YES Go to relevant DTC chart.
NO
2 Check continuity of high voltage fuse in the service plug assembly and check
condition of service plug terminal (Loosened, poor contact, etc.).
OK Repair or replace the power cable.
NG
Repair or replace the service plug or the high
voltage fuse in the service plug assembly.

DI7XS±01
DI±674
± DIAGNOSTICSCOMBINATION METER SYSTEM
2001 PRIUS (RM778U)
PROBLEM SYMPTOMS TABLE
TROUBLESHOOTING:
Flow chart No.SymptomSee page
1Check the communication between the combination meter and the multiplex com-
munication circuit.DI±671
2The whole meter does not functionDI±672
3The margin of error in speedometer is large. Or it remains as 0 mph.DI±673
4Fuel receiver gauge is inoperative or improper.DI±674
5Indicators or warning lights do not light up.DI±676
Fuel gauge:
SymptomSuspect AreaSee page
Displayed level is higher or lower than the actual level.1. Inclination sensor resetting
2. Body ECUBE±47
IN±41
General:
SymptomSuspect area
Meter display does not properly function.3. Combination meter ECU
Entirely black screen appears.1. Fuse
2. Wire harness and connector
3. Combination meter ECU
Turning the light control switch ON does not dim the light.1. Illumination switch
2. Wire harness and connector
3. Combination meter ECU
Brightness cannot be changed by the illumination switch operation.1. Illumination switch
2. Wire harness and connector
3. Combination meter ECU
Speedometer:
SymptomSuspect area
Improper display (Remained as 0 km/h)1. Accessory that utilizes vehicle speed signals
2. Brake ECU
3. Combination meter ECU
4. Wire harness and connector
Speedometer only does not light up.1. Combination meter ECU
Abnormal display (Incomplete numbers displayed)1. Combination meter ECU
DIsplayed value changes frequently or sharply.1. Accessory that utilizes vehicle speed signals
2. Brake ECU
3. Combination meter ECU
4. Wire harness and connector
Margin of error in speedometer is large.1. Accessory that utilizes vehicle speed signals
2. Brake ECU
3. Combination meter ECU
4. Wire harness and connector
ODO/TRIP Meter:
SymptomSuspect area
ODO/TRIP only does not light up.1. Combination meter ECU
Abnormal display (Incomplete number displayed)1. Combination meter ECU
Both meters do not integrate values. (When speedometer is normal)1. Combination meter ECU
Trip meter only does not integrate values.1. ODO/TRIP switch
2. Combination meter ECU

I11582
(±) (+)
1
I11583
(±)
1 (+)
± DIAGNOSTICSBODY CONTROL SYSTEM
DI±705
2001 PRIUS (RM778U)
INSPECTION PROCEDURE
HINT:
The flow chart below is based on the premise that the horns blow normally whenever the horn switch is oper-
ated. If horn operation is not normal when the horn switch is operated, check the horn switch.
1 Check voltage between terminal 1 of theft deterrent horn connector and body
ground.
PREPARATION:
Remove the theft deterrent horn and disconnect the connector.
CHECK:
Measure voltage between terminal 1 of theft deterrent horn
connector and body ground.
OK:
Voltage: 10 ± 14 V
NG Check and repair harness and connector be-
tween HORN fuse and theft deterrent horn.
OK
2 Check theft deterrent horn.
CHECK:
Connect positive (+) lead to terminal 1 and negative (±) lead to
ground to theft deterrent horn connector.
OK:
Theft deterrent horn blows.
NG Replace theft deterrent horn.
OK