2001 TOYOTA MR2 SPYDER Owners Manual (in English)

01MY MR2(U) L/O 0008
2182001 MR2 (OM17482U)
CLUTCH
Pedal free play, mm (in.):515 (0.20.6)
Fluid type: SAE J1703 or FMVSS No.116 DOT 3
MANUAL TRANSAXLE
Oil capacity, L (qt., Imp. qt.): Vehicle with limited−slip differential
1.8 (1.9, 1.6)
Vehicle without limited−slip differential 1.9 (2.0, 1.7)
Oil type: Gear oil API GL−4 or GL−5
Recommended oil viscosity: SAE 75W−90 BRAKES
Minimum pedal clearance when depressed
with the force of 490 N (50 kgf, 110 lbf)
with the engine running, mm (in.):
85 (3.4)
Pedal free play, mm (in.): 16 (0.040.24)
Pad wear limit, mm (in.): 1.0 (0.04)
Parking brake adjustment when pulled with
the force of 196 N (20 kgf, 44 lbf): 58 clicks
Fluid type: SAE J1703 or FMVSS No.116 DOT 3 STEERING
Wheel free play:
Less than 30 mm (1.2 in.)
Power steering fluid type: Toyota P.S fluid EH or equivalent

01MY MR2(U) L/O 0008
2192001 MR2 (OM17482U)
Tires
Tire size and pressure:
Except compact spare tire
Tire sizeTire pressure
kPa (kgf/cm2 or bar, psi)Wheel size
Front185/55R15 81V180(1.8,26)15 6JJ
Rear205/50R15 85V220(2.2,32)1561/2JJ
Compact spare tire
Tire size
Tire pressure kPa (kgf/cm2 or bar, psi)Wheel size
T125/70D16420(4.2,60)164T
Wheel nut torque, N·m (kgf·m, ft·Ibf):
103(10.5,76)
NOTE: For a complete information on tires (e.g. replacing tires or replacing wheels), see Checking tire pressure" through Alum inum
wheel precautions", page 194 through 199 in Section 7−2.

01MY MR2(U) L/O 0008
2202001 MR2 (OM17482U)
Fuses
SB73024
Trunk room
Fuses (type A)1. 30 A: Spare fuse
2. 15 A: Spare fuse
3. 20 A: Spare fuse
4. RDI FAN 30 A: Electric cooling fans
5. ABS1 20 A: Anti−lock brake system
6. CDS FAN 30 A: Electric cooling fans
SB73025
Trunk room
7. HEAD LH UPR 10 A: Left−hand head-
light (high beam)
8. HEAD RH UPR 10 A: Right−hand
headlight (high beam)
9. HEAD LH LWR 10 A: Left−hand head-
light (low beam)
10. HEAD RH LWR 10 A: Right−hand
headlight (low beam)
11. WASHER 10 A: Windshield wiper and
washer
12. HTR 10 A: Air conditioning system
SB73026
Instrument panel
13. WIPER 20 A: Windshield wiper and
washer
14. ECU−IG 7.5 A: Power Steering system,
anti−lock brake system
15. FAN−IG 7.5 A: Electric cooling fans
16. TURN 7.5 A: Turn signal lights, emer-
gency flashers
17. GAUGE 7.5 A: Power window system,
gauges and meters, back−up lights,
charging system, rear window defogger
system
18. SRS 7.5 A: SRS airbag system
19. DEF 25 A: Rear window defogger sys-
tem

01MY MR2(U) L/O 0008
2212001 MR2 (OM17482U)
SB73027
Engine compartment
20. OBD 7.5 A: On−board diagnosis sys-
tem
21. AM1 7.5 A: GAUGE" ACC" TURN"
ECU−IG" WIPER" WASHER" SRS"
HTR 10A" FAN−IG" fuses
22. ACC 25 A: RADIO2" CIG" fuses
23. DOOR 15 A: Power door lock system
24. STOP 15 A: Stop lights, high mounted
stop light
25. TAIL1 20 A: TAIL2" PANEL" fuses
26. D P/W 20 A: Power window system
27. P P/W 20 A: Power window system
28. RADIO1 15 A: Power antenna, radio 29. DOME 10 A:
Clock
30. ECU−B 10 A: Daytime running light
system, g auges and meters
31. TAIL2 10 A: Taillights, parking lights,
license plate lights, gauges and meters
32. PANEL 7.5 A: Clock, illuminations
33. RADIO2 7.5 A: Gauges and meters,
outside rear view mirror system, clock
34. CIG 15 A: Cigarette lighter
35. I/UP 7.5 A: Engine idle up system
36. ALT−S 7.5 A: Charging system
37. ECU−B1 25 A: ECU−B" DOME" fuses
38. HORN 10 A: Horn
39. HAZ 15 A: Turn signal lights, emergen-
cy flashers
40. AM2 15 A: Starter system, multiport
fuel injection system/sequential multi-
port fuel injection system, SRS airbag
system
41. IG2 15 A: Ignition system, multiport
fuel injection system/sequential multi-
port fuel injection system
42. EFI1 15 A: Multiport fuel injection sys-
tem/sequential multiport fuel injection
system, engine immobiliser system
43. DRL NO.1 7.5 A: Daytime running light
system 44. DRL NO.2 20 A:
HEAD LH LWR"
HEAD RH LWR" HEAD LH UPR"
HEAD RH UPR" fuses
45. EFI2 7.5 A: Multiport fuel injection sys-
tem/sequential multiport fuel injection
system
46. ST 7.5 A: Starter system
Fuses (type B)
47. ABS2 40 A: Anti−lock brake system
48. EHPS 50 A: Power steering system
49. MAIN 40 A: Starter system, DRL"
DRL NO.2" fuses
50. HTR 40 A: Air conditioning system
Fuses (type C)
51. ALT 100 A: AM1" D P/W" P P/W"
DOOR" STOP" EHPS" DEF" TAIL1"
OBD" HTR 40A" fuses

01MY MR2(U) L/O 0008
2222001 MR2 (OM17482U)

01MY MR2(U) L/O 0008
2232001 MR2 (OM17482U)
REPORTING SAFETY DEFECTS FOR U.S.
OWNERS AND UNIFORM TIRE QUALITY
GRADING
Reporting safety defects for U.S. owners224
. . . . . . . . . . . . . . . . . . . . . .
Uniform tire quality grading 224
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
SECTION 9

01MY MR2(U) L/O 0008
2242001 MR2 (OM17482U)
If you believe that your vehicle has a defect
which could cause a crash or could cause
injury or death, you should immediately in-
form the National Highway Traffic Safety
Administration (NHTSA) in addition to noti-
fying Toyota Motor Sales, U.S.A., Inc.
(Tollfree: 18003314331).
If NHTSA receives similar complaints, it may
open an investigation, and if it finds that a
safety defect exists in a group of vehicles, it
may order a recall and remedy campaign.
However, NHTSA cannot become involved in
individual problems between you, your deal-
er, or Toyota Motor Sales, U.S.A., Inc. To contact NHTSA, you may either call the
Auto Safety Ho
tline tollfree at
18004249393 (or 3660123 in Washing-
ton, D.C. area) or write to: NHTSA, U.S. De-
partment of Transportation, Washington, D.C.
20590. You can also obtain other information
about motor vehicle safety from the Hotline.
Uniform tire quality grading
This information has been prepared in ac-
cordance with regulations issued by the
National Highway Traffic Safety Adminis-
tration of the U.S. Department of Trans-
portation. It provides the purchasers and/
or prospective purchasers of Toyota
vehicles with information on uniform tire
quality grading.
Your Toyota dealer will help answer any
questions you may have as you read this
information.
DOT quality gradesAll passenger car
tires must conform to Federal Safety
Requirements in addition to these
grades. Quality grades can be found
where applicable on the tire sidewall
between tread shoulder and maximum
section width. For example: Treadwear
200 Traction AA Temperature A
Reporting safety defects
for U.S. owners

01MY MR2(U) L/O 0008
2252001 MR2 (OM17482U)
TreadwearThe treadwear grade is a
comparative rating based on the wear rate
of the tire when tested under controlled
conditions on a specified government test
course. For example, a tire graded 150
would wear one and a half (1 1/2) times
as well on the government course as a
tire graded 100. The relative performance
of tires depends upon the actual condi-
tions of their use, however, and may de-
part significantly from the norm due to
variations in driving habits, service prac-
tices and differences in road characteris-
tics and climate.
Traction AA, A, B, C The traction
grades, from highest to lowest, are AA, A,
B, and C, and they represent the tire’s
ability to stop on wet pavement as mea-
sured under controlled conditions on spe-
cified government test surfaces of asphalt
and concrete. A tire marked C may have
poor traction performance.
Warning: The traction grade assigned to
this tire is based on braking (straighta-
head) traction tests and does not include
cornering (turning) traction. Temperature A, B, C
The temperature
grades are A (the highest), B, and C,
representing the tire’s resistance to the
generation of heat and its ability to dissi-
pate heat when tested under controlled
conditions on a specified indoor laboratory
test wheel. Sustained high temperature
can cause the material of the tire to de-
generate and reduce tire life, and exces-
sive temperature can lead to sudden tire
failure. The grade C corresponds to a lev-
el of performance which all passenger car
tires must meet under the Federal Motor
Vehicle Safety Standard No.109. Grades B
and A represent higher levels of perfor-
mance on the laboratory test wheel than
the minimum required by law.
Warning: The temperature grades for this
tire are established for a tire that is prop-
erly inflated and not overloaded. Exces-
sive speed, underinflation, or excessive
loading, either separately or in combina-
tion, can cause heat buildup and possible
tire failure.