2001 TOYOTA AVALON speaker

BO2OS-01
H12120
Door Lock Striker
Rear Guide Bracket
Garnish
23 (230, 17)
Rear Door
Window Guide
Rear Door Weatherstrip
Rear Door Glass Run
Rear Door Glass
Outside Handle
5.4 (55, 48 in.´lbf)
5.4 (55, 48 in.´lbf)


Door Lock
Door Lock ProtectorRear Door Outside
Lower Moulding
Door Speaker Board
25 (260, 19)
25 (260, 19)25 (260, 19)
7.8 (80, 69 in.´lbf)
Door Check
25 (260, 19)
Door Hinge
Inside Handle
Inside Handle Bezel
Service Hole Cover
Rear Door Belt Moulding
Cover
Upper Armrest Base Panel
Power Window
Switch
Rear Door ArmrestRear Door
Inner Weatherstrip
Door Trimx13
x7
Window Regulator
Guide Assembly
Window Regulator Motor
5.4 (55, 48 in.´lbf)
Rear Door Trim Pocket
: Specified torqueN´m (kgf´cm, ft´lbf)

Precoated Part
5.4 (55, 48 in.´lbf)
4.9 (50, 43 in.´lbf)
Guide Piece Plate
BO-16
- BODYREAR DOOR
1801 Author
: Date
:
2001 AVALON (RM808U)
REAR DOOR
COMPONENTS

H12163
x13
x7
H06127
H12115
H12116
Protective Tape BO-18
- BODYREAR DOOR
1803 Author
: Date
:
2001 AVALON (RM808U)
(c) Using a screwdriver, remove the rear door inner weather-
strip.
(d) Remove the 13 screws and rear door armrest.
(e) Remove the 7 screws and rear door trim pocket.
5. REMOVE INSIDE HANDLE
(a) Remove the screw.
(b) Slide the inside handle backward to remove it.
(c) Disconnect the 2 cables from the inside handle as shown
in the illustration.
6. REMOVE DOOR SPEAKER BOARD
7. REMOVE SERVICE HOLE COVER
(a) Disconnect the 2 control cables from the link clamp.
(b) Using a clip remover, remove the grommets and link
clamp.
(c) Remove the service hole cover.
NOTICE:
Do not tear the cover.
HINT:
At the time of reassembly, please refer to the following item.
Bring out the 2 control cables and wire harness through the ser-
vice hole cover.
8. REMOVE REAR DOOR WEATHERSTRIP
(a) Remove the screw from the door check.
(b) Using a clip remover, remove the rear door weatherstrip.
(c) Reinstall the screw to the door check.
Torque: 25 N´m (260 kgf´cm, 19 ft´lbf)
9. REMOVE REAR DOOR BELT MOULDING
(a) Apply protective tape to the outer surface as shown in the
illustration, to keep the surface from being scratched.
(b) Using a moulding remover, remove the rear door belt
moulding.

H12222
Rear Seatback Assembly LH Rear Inner with
Center Belt Roof Side Inner Garnishw/o Speaker:
High-mounted Stop Light
RH Rear Seat
Inner with Center Beltw/ Speaker:
High-mounted Stop Light
Package Tray TrimRear Seat
Outer Belt
Rear Seat Outer Belt
Seat Belt
Retractor Cover
Rear Seat Cushion AssemblyRoof Side Inner Garnish
N´m (kgf´cm, ft´lbf): Specified torque
41 (420, 30)
41 (420, 30)
41 (420, 30)
41 (420, 30)
41 (420, 30)
18 (185, 13)
18 (185, 13)
41 (420, 30)
- BODYSEAT BELT
BO-125
1910 Author
: Date
:
2001 AVALON (RM808U)