2001 Peugeot Partner VU wheel

17I-6SEATS
head restraint Slide to adjust the
height. The headrestsare fitted with a catch.
To remove them fromthe seat, pull fullyupwards, then press therelease catches.
Forwards-backwards Lift the bar on the left-hand side and adjust to the desired position. Handbook pack storage This is above the drawer under the driver's seat. Drawer under driver's seat
To open, raise the drawer slightly and pull it forwards. Heated seats*
(see ÒINSTRUMENTS AND CONTROLSÓ)
* According to specification or country. Backrest angle*
Turn the knurled wheel to adjust the angle of the seat back.

You can adjust the height of the steering wheel.
With the vehicle stationary,firstly adjust your seat to the best position.
Release the steering wheel by pushing the handle forwards.
18I-7ADJUSTING THE STEERING WHEEL
Adjust the steering wheel to the desired height, then lock it in position by pulling the handle fully towards you. Make sure that the instrument panel dials and indicator lights remain clear- ly visible.
IMPORTANT
For safety reasons, these manoeuvres must not be performed while driving.

1Left air vent
2 Left speaker
3 Upper glove box or passenger's airbag
4 Location of radio or glove compartment
5 Controls :
¥ Electric windows
¥ Rear screen /exterior mirror
demister
¥ Air-conditioning
¥ Hazard warning lights
¥ Heated seats
6 Location of radio / CB, car phone
7 Central air vents
8 Controls :
¥ Horn
¥ Headlamps
¥ Direction indicators
¥ Rear fog lamp
9 Instrument panel
10 Controls :
¥ Windscreen wipers
¥ Rear screen wiper
¥ Windscreen wash 11
Right speaker
12 Right air vent
13 Key-operated switch :
¥ Activation/de-activation of
the passengerÕs airbag
14 Controls :
¥ Passenger's side electric mirror
¥ Headlamp angle adjuster
15 Fusebox access flap
16 Ignition lock
17 Driver's airbag
18 Steering wheel adjustment
19 Heating controls
20 Handbrake
21 Ashtray
22 Gear lever
23 Lighter
24 Lower glove box
25 Courtesy light
* According to specification.
25I-13INSTRUMENTS AND CONTROLS *

Direction indicators Left: move the stalk downwards. Right: move the stalk upwards.
To signal a change of direction, move the stalk past the point of resistance. The signal will cancel automatically as the steering wheel returns.
36I-16SIGNALLING
Horn Press the end of the stalk. Headlamp flash Flick the stalk gently towards you.
It is possible to flash the headlamps when the engine is switched off. Hazard warning This operates all the direction indicators at the same time.
Use it only in case of danger,for an emergency stop or in exceptional dri-
ving circumstances.
It can also operate when the ignition is off.The direction indicators will not operate if the vehicle is driven with the hazard warning lights on.

These warning lights are tested with the key in the ignition on position : M
64III-1STEERING LOCK-IGNITION-STARTER
¥ S : Steering lock
To release the steering lock, turn the steering wheel slightly, without forcing it, at the
same time as turning the key.
¥ A : Accessories Allows operation of some electrical accessories (radio, electric windows, map rea-
ders, etc.). The battery charge light comes on. ¥ M : Ignition
The following warning lamps * should illuminate : ABS, preheating (Diesel), battery
charge, STOP, oil pressure, handbrake and brake fluid level, engine autodiagnosis,airbags, door closing. If any of these warning lamps do not illuminate, there is a malfunction. ¥ D : Starter Release the key as soon as the engine has started. Never operate the key with the
engine running (see ÒSTARTING THE ENGINEÓ).
* According to model or country

Steering lock SWith the key removed and the steering lock engaged, the steering is loc- ked; the lock will engage in a number of positions of the steering wheel.The key can only be removed in the Sposition.
A The steering lock is released (by turning the key to position A, turning the
steering wheel slightly, if necessary).
M Driving position.
D Starting position.
For starting and stopping the engine, see ÒSTARTING THE ENGINEÓ.
65III-1STEERING LOCK-IGNITION-STARTER
WARNING
Never remove the ignition key before the vehicle has come to a complete stop. Never attempt to move the
vehicle without the engine running. If the engine is not running, the vehicleÕs steering and braking systemswill not be power-assisted (there is a risk of the steering lock engaging and the safety features not opera-ting). After parking, remove the ignition key and turn the steering wheel until the steering column locking peg engages.

ABS system*
This system increases safety by preventing the wheels from locking in the event of harsh braking or in conditions of poor grip. It enables the driver to maintain control of the steering.
The operating capacity of all the essential electrical elements of the ABS system is controlled by an electronic moni-
toring system both before and during driving. The ABS light comes on when the ignition is switched on, and should
go out after approximately two seconds. If the light does not go out, this indicates that the ABS is disconnected due
to a fault. Likewise, if the light comes on while driving, this indicates that the ABS is not operating. In both cases,
the normal braking system remains effective, as on a vehicle without ABS. However, to avoid the occurrence of other
faults with unknown consequences, the ABS should be inspected as soon as possible by an approved dealer.
It is still necessary to drive carefully on slippery surfaces (loose stones, snow, ice, etc.)..
67III-3BRAKES
Handbrake
The handbrake is operated by pulling the lever upwards. The greater the slope you are on, the greater the force that should be applied in pulling the
lever.
To ease the action of the handbrake lever, it is recommended that you press the brake pedal at the same time. As a precaution, 1st gear should be engaged in all cases. On steep slopes, you should also turn the wheels towards the kerb.
To release the handbrake, pressthe button while pulling the lever up, then
lower the lever to the fully down position.The warning light comes on if the handbrake is on or not fully released, with the ignition on.
* According to model or country.

Air intake Make sure that the exterior air intake grille and intake chamber at the baseof the windscreen are kept clear(dead leaves, snow).
To ensure efficient heating to the rear seats, do not obstruct the air passa-ge under the front seats or the extra-ctors at the rear of the vehicle.
We recommend that a certain amount of air flow is maintained at alltimes.
70IV-1HEATING/VENTILATION
Air circulation
To maximise comfort, air should be well circulated through boththe front and back of the passen-ger compartment. Air vents The air vents have knurled wheels to open and close the airflow and grilles to direct the airflow (up/down, right/left).