2001 Peugeot Partner VU oil

Display :¥ Digital clock.
¥ Maintenance indicator.
¥ Engine oil level indicator (Diesel).
¥ Total mileage recorder.
26I-14INSTRUMENT PANEL*
Tachometer
Coolant temperature gauge Fuel gauge
Display control : ¥ Total mileage recorder.
¥ Trip mileage recorder
¥ Resetting the trip mileage recorder to zero.
Dashboard lighting rheostat see ÒI-14Ó Changing the time see ÒI-14Ó
* According to model or country

1
11
Maintenance intervals If your vehicle is used in particular- ly harsh conditions, it is necessaryto select the maintenance sche-dules for arduous conditions (seethe Maintenance Guide) whichconsist of more frequent services.Note : if the maximum time bet-
ween two oil changes is reachedbefore the mileage is up, the span-ner symbol lights. To change the maintenanceintervals :
- Switch off the ignition. - Press and hold down button
1.
- Switch on the ignition
- The distance remaining until the next service flashes.
- Release the button immediately.
- The maintenance interval is dis- played.
- Pressing button 1briefly allows
the maintenance intervals to be alternated - When the desired maintenance
interval is displayed, press but-ton 1for ten seconds to validate
(the selected maintenance inter-val will flash for ten seconds).
Release the button to validatewhen the display stops flashing. Resetting the maintenance indi- cator to zero
Your dealer will perform this ope-
ration after each service. However,if you intend to service the vehicleyourself, the procedure for reset-ting the maintenance indicator isas follows:
- Switch off the ignition.- Press and hold down button 1.
- Switch on the ignition.
- The distance remaining until the next service flashes.
- Holdbutton 1down for ten
seconds.
- The display will read Ò=0Óand
the spanner will disappear.
29I-14INSTRUMENT PANEL*
* According to model or country.

Engine oil level indicator (Diesel)
When the ignition is switched on, the maintenance indicator is displayed for several seconds followed by the engine oil level for approximately 10 seconds. Max Min Check using the oil dipstick.
Check with the vehicle on level ground, and the engine off for at least 10 minutes. Lack of oil (flashing of the lines) The oil level must be topped up. If it is not, the engine may be destroyed.
A flashing of the indicator informs you there is an operating fault .
Contact your network dealer.
30I-14INSTRUMENT PANEL*
Multifunction Display
On switching the ignition on, the display shows in turn :
- Maintenance indicator.- Engine oil level indicator (Diesel).
- Total mileage recorder.
- Indication of the time.
* According to model or country

Engine oil level indicator (Diesel)
When the ignition is switched on, the maintenance indicator is displayed for several seconds followed by the engine oil level for approximately 10 seconds. Max Min Check using the oil dipstick.
Check with the vehicle on level ground, and the engine off for at least 10 minutes. Lack of oil (flashing of the lines) The oil level must be topped up. If it is not, the engine may be destroyed.
A flashing of the indicator informs you there is an operating fault .
Contact your network dealer.
30I-14INSTRUMENT PANEL*
Multifunction Display
On switching the ignition on, the display shows in turn :
- Maintenance indicator.- Engine oil level indicator (Diesel).
- Total mileage recorder.
- Indication of the time.
* According to model or country

1
11
Maintenance intervals If your vehicle is used in particular- ly harsh conditions, it is necessaryto select the maintenance sche-dules for arduous conditions (seethe Maintenance Guide) whichconsist of more frequent services.Note : if the maximum time bet-
ween two oil changes is reachedbefore the mileage is up, the span-ner symbol lights. To change the maintenanceintervals :
- Switch off the ignition. - Press and hold down button
1.
- Switch on the ignition
- The distance remaining until the next service flashes.
- Release the button immediately.
- The maintenance interval is dis- played.
- Pressing button 1briefly allows
the maintenance intervals to be alternated - When the desired maintenance
interval is displayed, press but-ton 1for ten seconds to validate
(the selected maintenance inter-val will flash for ten seconds).
Release the button to validatewhen the display stops flashing. Resetting the maintenance indi- cator to zero
Your dealer will perform this ope-
ration after each service. However,if you intend to service the vehicleyourself, the procedure for reset-ting the maintenance indicator isas follows:
- Switch off the ignition.- Press and hold down button 1.
- Switch on the ignition.
- The distance remaining until the next service flashes.
- Holdbutton 1down for ten
seconds.
- The display will read Ò=0Óand
the spanner will disappear.
29I-14INSTRUMENT PANEL*
* According to model or country.

Electronic key warning lamp Lights up when switching
on ignition if the key is not recogni- sed
* Depending on version or country.
35I-15WARNING LAMPS *
Minimum coolant fluid level warning lamp If the warning lamp lights
up, it is imperative to stop the vehicle. Check the level and takethe precautions detailed in chapter
ÒLEVELS AND CHECKSÓ).
Battery charge warninglamp Should not be on when the engine is running. If it
comes permanently on, contact
your nearest approved Dealer.
Imperative stopwarning lamp Lights up at the same time as ano-
ther visual warning or if the maxi-mum permissible coolant fluid tem-perature is reached.
Engine oil pressurewarning lamp If it lights up while you are
driving, stop the engine, check the
level, (See ÒLEVELS ANDCHECKSÓ). If it remains lit despite the level being correct, contact your nearest
approved Dealer. Warning lamp for hand-brake and for brakefluid level Indicates that the brake
is applied or incorrectly released. Also that the brake fluid level is
insufficient. See ÒBRAKESÓ,
ÒLEVELS AND CHECKSÓ . The warning lamp may also indica- te a malfunction of the electronicbraking distribution.
Engine operation war-ning lamp (autodiagno-sis)
If it flashes or lights up, this indi-cates a malfunctioning of either theinjection, ignition or emissioncontrol systems (depending oncountry). Quickly consult your nearest
approved dealer.
AIRBAG operation war-ning lamp
See ÒTHE AIRBAG SYSTEMÓ. Doors open warninglamp Lights up when swit- ching on ignition.
Goes out when all the doors are
closed correctly.

1
2Manual repriming pump
See ÒDIESEL INJECTION SYSTEMÓ.
78
Power steering reservoir
Level: see ÒLEVELS AND
CHECKSÓ. Topping up engine oil
See ÒCAPACITYÓ. Finish by checking the oil level using the manual dipstick.
Battery
See ÒBATTERYÓ. Air filter Follow the instructions in the Maintenance Guide.
Engine oil dipstick Check with the vehicle on a level surface and at leastten minutes after having
switched off the engine. Never exceed the maxi- mum level.
Check the level regularly.Maxi Mini
Caution
Take care when carrying out checks under the bonnet when theengine is hot, even if the engine is
switched off, as the cooling fancan start up at any time. The engine oil should be checked regularly between the servicevisits recommended by the manu-
facturer, as well as before longjourneys.
Topping up brake fluid
See ÒLEVELS AND CHECKSÓ.
Front and rear screenwash and headlampwash* reservoir
See ÒCAPACITYÓ.
Topping up enginecoolant
See ÒLEVELS AND CHECKSÓ. Note : If it is necessary to top up
the coolant frequently this indi- cates a fault which should bechecked as soon as possible.V- 1LEVELS

Front and rear screen wash
and headlamp wash reservoir 3,5 or 7,5 litres
88V- 5CAPACITIES *
Engine typeOil capacity (litres)
(1)
Without air conditioning With air conditioning
1.1i Engines 3,50 Ñ
1.4i Engines 3,50 3,50
1.9D Engines 4,75 4,50
2.0 HDi Engines 4,50 4,25
(1)Oil change with filter cartridge.
* According to specification.