Page 39 of 317

36 Tow-away protection
Te ch n ica l
data Instruments 
and controlsOperationDrivingInstrument 
cluster displayPractical hints Car care Index
Tow-away alarm and glass breakage sensor
The switch is located in the overhead console.
The tow-away alarm and glass breakage sensor are part 
of the antitheft alarm system.
Once the alarm system has been armed, the turn signal 
lamps will flash rapidly and the horn will sound when 
someone attempts to raise the vehicle, or breaks a 
window and reaches into the passenger compartment.The alarm will last approximately 3 minutes in the form 
of rapidly flashing turn signal lamps. At the same time 
the horn will sound for approximately 30 seconds. The 
alarm will stay on even if the vehicle is immediately 
lowered.
If the alarm stays on for more than 20 seconds, an 
emergency call is initiated automatically. See Tele Aid 
on page 148.
To prevent triggering the tow-away alarm feature, switch 
off the tow-away alarm and glass breakage sensor before 
towing the vehicle, or when parking on a surface subject 
to movement, such as a ferry or auto train.
To do so, turn key in steering lock to position 1, then 
return it to position 0 and remove key from steering 
lock.
Within 30 seconds, push left or right button. (On 
vehicles equipped with optional trip computer, push 
RESET or MODE button, display shows OFF.)
Exit vehicle, and lock vehicle with remote control.
The tow-away alarm and glass breakage sensor remain 
switched off until the key is inserted in steering lock 
and turned to position 1. 
     
        
        Page 40 of 317

37 Seats
Te ch n ica l
data Instruments 
and controlsOperationDrivingInstrument 
cluster displayPractical hints Car care Index Seats, front
Caution!
Do not remove head restraints except when mounting 
seat covers. For removal see page 43. Whenever head 
restraints have been removed be sure to reinstall them 
before driving.
Wa r n i n g !
Do not adjust the driver’s seat while driving. 
Adjusting the seat while driving could cause the 
driver to lose control of the vehicle.Never ride in a moving vehicle with the backrest 
reclined. Sitting in an excessively reclined position 
can be dangerous. You could slide under the seat 
belt in a collision. If you slide under it, the belt 
would apply force at the abdomen or neck. That 
could cause serious or even fatal injuries. The 
backrest and seat belt provide the best restraint 
when the wearer is in an upright position and the 
belt is properly positioned on the body.Never place hands under seat or near any moving 
parts while a seat is being adjusted.
Wa r n i n g !
When leaving the vehicle always remove the key 
from the steering lock, and lock your vehicle.Do not leave children unattended in the vehicle or 
with access to an unlocked vehicle. Unsupervised 
use of vehicle equipment may cause serious 
personal injury. 
     
        
        Page 41 of 317

38 Seats
Te ch n ica l
data Instruments 
and controlsOperationDrivingInstrument 
cluster displayPractical hints Car care Index
Important!
Prior to operating the vehicle, the driver should adjust 
the seat height for proper vision as well as fore / aft 
placement and backrest angle to insure adequate 
control, reach, operation, and comfort. The head 
restraint should also be adjusted for proper height. See 
also airbag section on page 56 for proper seat 
positioning.
In addition, also adjust the steering wheel to ensure 
adequate control, reach, operation, and comfort.
Both the inside and outside rear view mirrors should be 
adjusted for adequate rearward vision.
Fasten seat belts. Infants and small children should be 
seated in a properly secured restraint system that 
complies with U.S. Federal Motor Vehicle Safety 
Standard 213 and Canadian Motor Vehicle Safety 
Standard 213.
All seat, head restraint, steering wheel, and rear view 
mirror adjustments as well as fastening of seat belts 
should be done before the vehicle is put into motion.
Wa r n i n g !
Children 12 years old and under must never ride in 
the front seat, except in a Mercedes-Benz 
authorized BabySmart
TM compatible child seat, 
which operates with the BabySmart
TM system 
installed in the vehicle to deactivate the passenger 
side front airbag when it is properly installed. 
Otherwise they will be struck by the airbag when it 
inflates in a crash. If this happens, serious or fatal 
injury can result.
According to accident statistics, children are safer 
when properly restrained in the rear seating 
positions than in the front seating positions. 
Infants and small children must ride in the back 
seats and be seated in an appropriate infant or 
child restraint system, which is properly secured 
with the vehicle’s seat belt, fully in accordance 
with the child seat manufacturer’s instructions.A child’s risk of serious or fatal injuries is 
significantly increased if the child restraints are 
not properly secured in the vehicle and the child is 
not properly secured in the child restraint. 
     
        
        Page 43 of 317

40 Seats
Te ch n ica l
data Instruments 
and controlsOperationDrivingInstrument 
cluster displayPractical hints Car care Index
Power seats (standard; optional on model ML 320)
The slide switches are located on the entry side of each 
front seat base.
Turn key in steering lock to position 1 or 2 (with the 
driver’s or passenger’s door open, the power seats can 
also be operated with the key removed or in steering 
lock position 0).We recommend to adjust the power seat in the following 
order:
1Seat, up / down
Press the switch (up/down direction) until 
comfortable seating position with still sufficient 
headroom is reached.
2Seat adjustment, fore / aft
Press the switch (fore / aft direction) until a 
comfortable seating position is reached that still 
allows you to reach the accelerator / brake pedal 
safely. The position should be as far rearward as 
possible, consistent with ability to properly operate 
controls.
3Seat cushion tilt
Press the switch in the direction of the arrow until 
your legs are lightly supported.
4Backrest tilt
Press the switch in the direction of the arrow until 
your arms are slightly angled when holding the 
steering wheel. 
     
        
        Page 44 of 317

41 Seats
Te ch n ica l
data Instruments 
and controlsOperationDrivingInstrument 
cluster displayPractical hints Car care Index Only minor personal adjustments, as described below, 
should then be required. 
For exterior rear view mirrors, see page 73; 
inside rear view mirror, see page 71; 
steering wheel adjustment, see page 70.
Note:
See page 42 for instructions on storing and recalling the 
seat position.Head restraint
Raising: 
Pull up on head restraint.
Lowering: 
Push button, located at top of seat back, and push down 
on head restraint, see also page 43.
Adjust head restraint to support the back of the head 
approximately at ear level. The head restraint angle can 
also be adjusted manually.
See page 43 for removing head restraints.
Wa r n i n g !
When leaving the vehicle always remove the key 
from the steering lock, and lock your vehicle.The power seats can also be operated with the 
driver’s or passenger door open. Do not leave 
children unattended in the vehicle or with access 
to an unlocked vehicle. Unsupervised use of vehicle 
equipment may cause serious personal injury. 
     
        
        Page 56 of 317

53 Restraint systems
Te ch n ica l
data Instruments 
and controlsOperationDrivingInstrument 
cluster displayPractical hints Car care Index BabySmart
TM airbag deactivation system
Special BabySmart
TM compatible child seats, designed 
for use with the Mercedes-Benz system and available at 
any authorized Mercedes-Benz Center are required for 
use with the BabySmart
TM airbag deactivation system.
With the special child seat properly installed, the 
passenger front airbag will not deploy. The 7 
indicator lamp located in the instrument cluster will be 
illuminated, except with key removed or in steering lock 
position 0. The system does not deactivate the door 
mounted side impact airbag.
Self-test BabySmart
TM 
without special child seat installed
After turning key in steering lock to position 1 or 2, the 
7 indicator lamp located in the instrument cluster 
comes on for approximately 6 seconds, extinguishes, 
then blinks once.
If the indicator lamp should not come on or is 
continuously lit, the system is not functioning. You must 
see an authorized Mercedes-Benz Center before seating 
any child on the front passenger seat.
BabySmart
TM is a trademark of Siemens Automotive Corp.
Wa r n i n g !
The BabySmart
TM Airbag Deactivation System will 
ONLY work with a special child seat designed to 
operate with it. It will not work with child seats 
which are not BabySmart
TM compatible.
Never place anything between seat cushion and 
child seat (e.g. pillow), since it reduces the 
effectiveness of the deactivation system.Follow the manufacturer’s instructions for 
installation of special child seats.
The passenger side front airbag will not deploy 
only if the 7 indicator lamp remains 
illuminated.Please be sure to check the indicator every time 
you use the special system child seat.Should the light go out while the restraint is 
installed, please check installation. If the light 
remains out, do not use the BabySmart
TM restraint 
to transport children on the front passenger seat 
until the system has been repaired. 
     
        
        Page 58 of 317

55 Restraint systems
Te ch n ica l
data Instruments 
and controlsOperationDrivingInstrument 
cluster displayPractical hints Car care Index Emergency tensioning retractor (ETR)
The seat belts for the outboard passenger seats (except 
in the optional 3rd row seats) are equipped with 
emergency tensioning retractors. These tensioning 
retractors are located in each belt’s inertia reel and 
become operationally ready with the key in steering 
lock position 1 or 2.
The emergency tensioning retractors are designed to 
activate only when the seat belts are fastened during 
frontal impacts exceeding the first threshold of the SRS 
and in rear impacts exceeding a preset severity level. 
They remove slack from the belts in such a way that the 
seat belts fit more snugly against the body restricting its 
forward movement as much as possible.In cases of other frontal impacts, angled impacts, roll-
overs, certain side impacts, or other accidents without 
sufficient frontal or rear impact forces, the emergency 
tensioning retractors will not be activated. The driver 
and passengers will then be protected by the fastened 
seat belts and inertia reel in the usual manner.
For seat belt and emergency tensioning retractor see 
page 63. 
     
        
        Page 59 of 317
56 Restraint systems
Te ch n ica l
data Instruments 
and controlsOperationDrivingInstrument 
cluster displayPractical hints Car care Index
Airbags
1Driver airbag
The most effective occupant restraint system yet 
developed for use in production vehicles is the seat belt. 
In some cases, however, the protective effect of a seat 
belt can be further enhanced by an airbag.
The driver airbag is located in the steering wheel hub. 2Front passenger airbag
The passenger front airbag is located in the dashboard 
ahead of the front passenger.