2001 HONDA ODYSSEY service schedule

µ
The SAE numbers tell you the oil’s
viscosity or weight. Select the oil f or
your vehicle according to this chart.
An oil with a viscosity of 5W-30 is
pref erred f or improved f uel economy
and year-round protection in your
Honda.Youmayusea10W-30oilif
the temperature in your area never
goes below 20°F ( 7°C).
The oil container may also display
the API Certif ication seal. Make sure
it says ‘‘For Gasoline Engines.’’
You may use a synthetic motor oil if
it meets the same requirements
given f or conventional motor oil:
energy conserving, a service
classif ication of SJ, and the proper
weightasshownonthechart.When
using synthetic oil, you must f ollow
the oil and f ilter change intervals
given in the maintenance schedule.
Synthetic Oil
Engine Oil
Maint enance
250
AAmmbbiieennttTTeemmppeerraattuurree
AAPPIICCEERRTTIIFFIICCAATTIIOONNSSEEAALL

Your Honda does not need any oil
additives. Purchasing additives f or
the engine or transmission will not
increase your vehicle’s perf ormance
or longevity. It only increases the
cost of operating your vehicle.Always change the oil and f ilter
accordingtothetimeanddistance
(miles/kilometers) recommenda-
tions in the maintenance schedule.
The oil and f ilter collect contami-
nants that can damage your engine if
they are not removed regularly.
Changing the oil and f ilter requires
special tools and access f rom
underneath the vehicle. The vehicle
should be raised on a service station-
type hydraulic lif t f or this service.
Unless you have the knowledge and
proper equipment, you should have
this maintenance done by a skilled
mechanic.
Run the engine until it reaches
normal operating temperature,
then shut it off. Open the hood and remove the
engine oil f ill cap. Remove the oil
drain bolt and washer f rom the
bottom of the engine. Drain the oil
into an appropriate container.
1. 2.
CONT INUED
Additives Changing the Oil and Filter
Engine Oil
Maint enance
251
DDRRAAIINNBBOOLLTTWWAASSHHEERR

The air cleaner element should be
cleaned or replaced according to the
time and distance recommendations
in the maintenance schedule.
Clean the air cleaner element by
blowing compressed air through it in
the opposite direction to normal air
f low. If you do not have access to
compressed air (such as a service
station), ask your Honda dealer to do
this service.
Follow the replacement procedure
for removal and reinstallation.To replace it:Remove the two pins holding the
air intake cover by pulling the
head on each pin. Remove the air
intake cover.
The air cleaner element is inside the
air cleaner housing on the driver’s
side of the engine compartment.
Loosen the f our bolts by using a
Phillips-head screwdriver.
1. 2.
A ir Cleaner Element
Maint enance
Cleaning (Severe Conditions)
Replacement
262
AAIIRRIINNTTAAKKEECCOOVVEERR
BBOOLLTTSS