Page 198 of 333

Driving in Bad Weather
Visibility — Being able to see clearly in all directions and being
visible to other drivers are important in all weather conditions. This is
more difficult in bad weather. To be seen more clearly during daylight
hours, turn on your headlights.
Inspect your windshield wipers and
washers frequently. Keep the wind- shield washer reservoir full of the
proper fluid. Have the windshield
wiper blades replaced if they start to streak the windshield or leave parts
unwiped. Use the defroster and air conditioning to keep the windows
from fogging up on the inside (see
pages 128 and 133). Traction — Check your tires
frequently for wear and properpressure. Both are important in
preventing "hydroplaning" (loss of
traction on a wet surface). In the
winter, mount snow tires on all four
wheels for the best handling.
Watch road conditions carefully, they can change from moment tomoment. Wet leaves can be as slip-
pery as ice. "Clear" roads can have
patches of ice. Driving conditionscan be very hazardous when the
outside temperature is near freezing.
The road surface can become covered with areas of water puddles
mixed with areas of ice, so your
traction can change without warning.
Be careful when downshifting. If
traction is low, you can lock up the drive wheels for a moment and cause
a skid. Be very cautious when passing, or
being passed by other vehicles. The spray from large vehicles reduces
your visibility, and the wind buffeting can cause you to lose control.
Driving
Page 202 of 333
Towing a Trailer
Trailer Lights
Your vehicle has a trailer lighting connector located in the trunk by the
left taillight. To use the connector,
undo the fastener on the left side of
the trunk lining. Refer to the drawing in this page for the wiring
color code and purpose of each pin.
If you use a converter, you can get
the connector and pins that mate
with the connector in your vehicle
from your Acura dealer.
Since lighting and wiring vary in
trailer type and brand, you should also have a qualified mechanic installa suitable connector between the
vehicle and the trailer.
RIGHT TURN SIGNAL
(GREEN/YELLOW)BRAKE LIGHT
(GREEN/WHITE)
TAILLIGHT
(RED/BLACK)
CONTINUED
Driving
GROUND
(BLACK)
BACK-UP LIGHT
(GREEN/BLACK)
LEFT TURN SIGNAL
(PINK/BLUE)
Page 203 of 333

Towing a Trailer
Additional Trailer Equipment
Many states and Canadian provinces
require special outside mirrors when
towing a trailer. Even if they don't,
you should install special mirrors if
you cannot clearly see behind you, or if the trailer creates a blind spot.
Ask your trailer sales or rental agency if any other items are
recommended or required for your
towing situation.
Pre-Tow Checklist
When preparing to tow, and before driving away, be sure to check the
following:
The vehicle has been properlyserviced, and the tires, brakes,
suspension, and cooling system
are in good operating condition.
All weights and loads are within limits (see pages 196 and 197 ). The hitch, safety chains, and any
other attachments are secure. All items on and in the trailer are
properly secured and cannot shift
while you drive. The lights and brakes on your
vehicle and the trailer are workingproperly. Your vehicle tires and spare are
properly inflated (see page 244 ),and the trailer tires and spare are
inflated as recommended by thetrailer maker.
Driving
Page 206 of 333

Maintenance
This section explains why it is important to keep your car well
maintained and to follow basic
maintenance safety precautions.
This section also includes Maintenance Schedules for normal
driving and severe driving conditions,
a Maintenance Record, and instruc-
tions for simple maintenance tasks
you may want to take care of
yourself.
If you have the skills and tools to per-
form more complex maintenance
tasks on your Acura, you may want
to purchase the Service Manual. See
page 319 for information on how to obtain a copy, or see your Acura
dealer.
Maintenance Safety....................... 204
Important Safety Precautions.. 205
Maintenance Schedule.................. 206
Required Maintenance Record.... 213 Owner Maintenance Checks........ 215
Fluid Locations............................... 216
Engine Oil...................................... 217
Adding Oil................................... 217
Recommended Oil.................... 217
Synthetic Oil.............................. 218
Additives.................................... 218
Changing the Oil and Filter...... 219
Cooling System.............................. 221 Adding Engine Coolant............. 221Replacing Engine Coolant........ 223
Windshield Washers..................... 227
Automatic Transmission Fluid..... 228 Differential Oil.............................. 229
Brake Fluid.................................... 230
Brake System............................. 230
Power Steering............................... 230
Hood Latch.................................... 231
Air Cleaner Element...................... 231 Spark Plugs..................................... 233
Replacement.............................. 233
Specifications............................ 236
Battery............................................ 236
Wiper Blades.................................. 239
Air Conditioning System............... 241
Air Conditioning Filter.................. 242
Drive Belts...................................... 242
Timing Belt..................................... 243
Tires................................................ 243
Inflation..................................... 243
Inspection................................... 245
Maintenance............................... 246
Tire Rotation.............................. 246
Replacing Tires and Wheels .... 247
Wheels and Tires....................... 248
Winter Driving........................... 248
Snow Tires............................ 249
Tire Chains.............................
249
Lights.............................................. 250 Replacing Bulbs......................... 252
Storing Your Car............................
261
Maintenance
Page 218 of 333
Owner Maintenance Checks
You should check the following items at the specified intervals. If
you are unsure of how to perform any check, turn to the page given. Engine oil level — Check every
time you fill the fuel tank. See page 171.
Engine coolant level — Check the
radiator reserve tank every time
you fill the fuel tank. See page 172 .
Windshield washer fluid — Check the level in the reservoir monthly.
If weather conditions cause you to
use the washers frequently, check
the reservoir each time you stop
for fuel. See page 227 . Automatic transmission — Check
the fluid level monthly. See page
228.
Brakes — Check the fluid level
monthly. See page 230 . Tires — Check the tire pressure
monthly. Examine the tread for
wear and foreign objects. See page
245.
Lights — Check the operation of
the headlights, parking lights,
taillights, high-mount brake light,
turn signals, brake lights, and
license plate lights monthly. See
page 250.
Maintenance
Page 253 of 333
Lights
Check the operation of your car's
exterior lights at least once a month.
A burned out bulb can create an unsafe condition by reducing yourcar's visibility and the ability to
signal your intentions to other
drivers.
Maintenance
HIGH BEAM HEADLIGHT
LOW BEAM HEADLIGHT
FRONT FOG LIGHT
TURN SIGNAL/
PARKING LIGHT
SIDE MARKER LIGHT
Page 254 of 333
Lights
Check the following: Headlights (low and high beam)
Fog lights
Parking lights
Taillights
Brake lights
Turn signals Back-up lights
Hazard light function License plate light
Side marker lights
High-mount brake light
Daytime running lights (Canadian
models)
If you find any bulbs are burned out,
replace them as soon as possible.
Refer to the chart on page 303 to
determine what type of replacement
bulb is needed.
Maintenance
HIGH-MOUNT BRAKE LIGHT
TURN SIGNAL LIGHT
LICENSE PLATE
LIGHTS
STOP/TAIL LIGHTS
BACK-UP LIGHT
Page 255 of 333
Lights
Replacing a High Beam Headlight
Bulb
The low beam headlight bulbs are a type of high voltage discharge tube.
High voltage can remain in the
circuit even with the light switch off
and the key removed. Because of
this, you should not attempt to examine or change a low beam
headlight bulb yourself. If a low
beam headlight bulb fails, take the
car to your dealer to have it replaced. Halogen bulbs are used for the high
beam headlight bulbs. When replacing a high beam headlight bulb,
handle it by its base and protect the
glass from contact with your skin or
hard objects. If you touch the glass, clean it with denatured alcohol and a
clean cloth.
Halogen bulbs get very hot when lit. Oil,
perspiration, or a scratch on the glass
can cause the bulb to overheat and
shatter.
1. Open the hood.
2. Remove the electrical connector
from the bulb by pulling the connector straight back.
3. Remove the rubber weather seal
by pulling on the tab.
Maintenance
NOTICE