4-1
4
EAU01114
4-PRE-OPERATION CHECKSThe condition of a vehicle is the owner’s responsibility. Vital components can start to deteriorate quickly and unexpectedly,
even if the vehicle remains unused (for example, as a result of exposure to the elements). Any damage, fluid leakage or loss
of tire air pressure could have serious consequences. Therefore, it is very important, in addition to a thorough visual inspec-
tion, to check the following points before each ride.
EAU00340
PRE-OPERATION CHECK LIST
ITEM CHECKS PAGE
Front brake• Check operation, free play, fluid level and vehicle for fluid leakage.
• Add DOT 4 brake fluid if necessary.6-17
–6-22
Rear brake• Check operation, position, fluid level and vehicle for fluid leakage.
• Add DOT 4 brake fluid if necessary.6-19–6-22
Clutch• Check operation, condition and free play.
• Adjust if necessary.6-17
Throttle grip and housing• Check smooth operation.
• Lubricate if necessary.6-13, 6-22
Engine oil• Check oil level.
• Add oil if necessary.6-7–6-9
Final gear oil• Check vehicle for oil leakage. 6-9–6-10
Wheels and tires• Check tire air pressure, wear, damage and spoke tightness.
• Tighten spokes if necessary.6-13–6-16
Control cables• Check smooth operation.
• Lubricate if necessary.6-22
Brake pedal shaft• Check smooth operation.
• Lubricate if necessary.6-23
Brake and clutch lever pivots• Check smooth operation.
• Lubricate if necessary.6-23
Sidestand pivot• Check smooth operation.
• Lubricate if necessary.6-24
E_5KS.book Page 1 Monday, August 21, 2000 10:48 AM
MOTORCYCLE CARE AND STORAGE
7-5
7c. Install the spark plug caps onto the
spark plugs, and then place the
spark plugs on the cylinder head
so that the electrodes are ground-
ed. (This will limit sparking during
the next step.)
d. Turn the engine over several times
with the starter. (This will coat the
cylinder walls with oil.)
e. Remove the spark plug caps from
the spark plugs, and then install
the spark plugs and the spark plug
caps.
EWA00003
WARNING
@ To prevent damage or injury from
sparking, make sure to ground the
spark plug electrodes while turning
the engine over. @6. Lubricate all control cables and
the pivoting points of all levers and
pedals as well as of the sidestand/
centerstand.7. Check and, if necessary, correct
the tire air pressure, and then lift
the motorcycle so that both of its
wheels are off the ground. Alterna-
tively, turn the wheels a little every
month in order to prevent the tires
from becoming degraded in one
spot.
8. Cover the muffler outlets with plas-
tic bags to prevent moisture from
entering them.
9. Remove the battery and fully
charge it. Store it in a cool, dry
place and charge it once a month.
Do not store the battery in an ex-
cessively cold or warm place (less
than 0 °C or more than 30 °C). For
more information on storing the
battery, see page 6-27.
NOTE:@ Make any necessary repairs before
storing the motorcycle. @
E_5KS.book Page 5 Monday, August 21, 2000 10:48 AM
