6-11
1
2
3
4
5
6
7
8
97. Install the new oil filter, new O-
ring and the oil filter cover.
Tighten the oil filter cover
bolts to the specified torque.
NOTE:
Make sure the O-ring is seated
properly.
8. Fill the engine with oil. Install
the oil filler cap and tighten it. Tightening torque:
Oil filter cover bolt:
10 Nm (1.0 m·kg)
PERIODIC MAINTENANCE AND MINOR REPAIR
4. Remove the oil filter cover
bolts and the oil filter cover.
1. Oil filter cover bolt (´3)
5. Remove the oil filter and O-
ring.
6. Reinstall the drain plug and
tighten it to the specified
torque.
1. Oil filter
2. O-ring
1
2
1
Tightening torque:
Drain plug:
32 Nm (3.2 m·kg)
5AJ-9-E3 (XV125S)<3.1E> 4/5/0 5:01 PM Page 42
1
2
3
4
5
6
7
8
9
MOTORCYCLE CARE AND STORAGE
7-4
Storage
Short-term
Always store your motorcycle in a
cool, dry place and, if necessary,
protect it against dust with a
porous cover.
ECA00014
cC
8Storing the motorcycle in a
poorly ventilated room or cov-
ering it with a tarp while it is
still wet will allow water and
humidity to seep in and cause
rust.
8To prevent corrosion, avoid
damp cellars, stables (because
of the presence of ammonia)
and areas where strong chem-
icals are stored.
Long-term
Before storing your motorcycle for
several months:
1. Follow all the instructions in
the “Care” section of this
chapter.
2. Drain the carburetor float
chambers by loosening the
drain bolts; this will prevent
fuel deposits from building up.
Pour the drained fuel into the
fuel tank.
3. Only for motorcycles equipped
with a fuel cock which has an
“OFF” position: Turn the fuel
cock to “OFF”.
4. Fill up the fuel tank and add
fuel stabilizer (if available) to
prevent the fuel tank from rust-
ing and the fuel from deterio-
rating.
5. Perform the following steps to
protect the cylinders, piston
rings, etc. from corrosion.
a. Remove the spark plug caps
and spark plugs.
b. Pour a teaspoonful of engine
oil into each spark plug bore.c. Install the spark plug caps onto
the spark plugs and place the
spark plugs on the cylinder
head so that the electrodes are
grounded. (This will limit
sparking during the next step.)
d. Turn the engine over several
times with the starter. (This
will coat the cylinder walls
with oil.)
e. Remove the spark plug caps
from the spark plugs, install
the spark plugs and then the
spark plug caps.
EWA00003
w
When turning the engine over, be
sure to ground the spark plug elec-
trodes to prevent damage or injury
from sparking.
6. Lubricate all control cables and
the pivoting points of all levers
and pedals as well as of the
sidestand/centerstand.
5AJ-9-E3 (XV125S)<3.1E> 4/5/0 5:01 PM Page 76
