2000 YAMAHA TW125 lock

6-23
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
5
6
7
8
9 8Use only the designated quali-
ty brake fluid. Otherwise, the
rubber seals may deteriorate,
causing leakage and poor
brake performance.
NOTE:
If DOT 4 is not available, DOT 3 can
be used.
8Refill with the same type of
brake fluid. Mixing fluids may
result in a harmful chemical
reaction and lead to poor
brake performance.
8Be careful that water does not
enter the master cylinder when
refilling. Water will significant-
ly lower the boiling point of
the fluid and may result in
vapor lock.8Brake fluid may deteriorate
painted surfaces or plastic
parts. Always clean up spilled
fluid immediately.
8Have a Yamaha dealer check
the cause if the brake fluid
level goes down.
EAU00742Brake fluid replacement
The brake fluid should be replaced
only by trained Yamaha service
personnel. Have the Yamaha deal-
er replace the following compo-
nents during periodic maintenance
or when they are damaged or leak-
ing:
8oil seals (every two years)
8brake hoses (every four years) Recommended brake fluid:
DOT 4
5EK-9-E1 (TW125)<3.1> 4/6/0 11:50 PM Page 53

6-33
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
5
6
7
8
9 4. Turn the bulb holder counter-
clockwise to remove it and
then remove the defective
bulb.EW000119
w
Keep flammable products and your
hands away from a bulb while it is
on, as it is hot. Do not touch a bulb
until it cools down.
5. Put a new bulb into position
and secure it in place with the
bulb holder.
1. Bulb holder
6. Install the bulb holder cover,
connector and headlight unit.
7. Install the cowling.
8. If the headlight beam adjust-
ment is necessary, ask a
Yamaha dealer to make that
adjustment.EAU00855Turn signal and taillight bulb
replacement
1. Remove the screws and the
lens.
1. Screw
11
5EK-9-E1 (TW125)<3.1> 4/6/0 11:50 PM Page 63

6-34
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
5
6
7
8
92. Push the bulb inward and turn
it counterclockwise.
1. Screw (´2)
3. Place a new bulb in the socket.
Push the bulb inward and turn
it clockwise until it engages
into the socket.
4. Install the lens and the screws.
EC000108
cC
Do not over-tighten the screws as
the lens may break.
1. Bulb
EAU01579Supporting the motorcycle
Since the Yamaha TW125 has no
centerstand, follow these precau-
tions when removing the front and
rear wheel or performing other
maintenance requiring the motor-
cycle to stand upright. Check that
the motorcycle is in a stable and
level position before starting any
maintenance. A strong wooden
box can be placed under the
engine for added stability.
Front wheel service
To stabilize the rear of the motor-
cycle, either use a motorcycle
stand or place a motorcycle jack
under the frame in front of the rear
wheel to prevent it from moving
from side to side. Then use a
motorcycle stand to elevate the
front wheel off of the ground.11
5EK-9-E1 (TW125)<3.1> 4/6/0 11:50 PM Page 64