2000 YAMAHA DT125R weight

6-18
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
9
EAU00652
TiresTo ensure maximum performance,
long service and safe operation, note
the following:
Tire air pressure
Always check and adjust the tire
pressure before operating the motor-
cycle.
EW000082
wTire inflation pressure should be
checked and adjusted when the
temperature of the tire equals the
ambient air temperature. Tire infla-
tion pressure must be adjusted
according to total weight of cargo,
rider, passenger, and accessories
(fairing, saddlebags, etc. if
approved for this model), and vehi-
cle speed.
*Load is the total weight of cargo, rider, passenger
and accessories. Maximum load*180 kg
178 kg (CH, A only)
Cold tire pressureFrontRear
125 kPa150 kPa
Up to 90 kg(1.25 kg/cm
2,(1.50 kg/cm
2,
1.25 bar)1.50 bar)
90 kg load ~150 kPa175 kPa
Maximum load*(1.50 kg/cm
2,(1.75 kg/cm
2,
1.50 bar) 1.75 bar)
125 kPa150 kPa
Off-road riding(1.25 kg/cm
2,(1.50 kg/cm
2,
1.25 bar)1.50 bar)
1.Loosen the locknut.
2.Turn the adjusting nut in direc-
tion ato increase free play and
in direction bto decrease free
play.
3.Tighten the locknut.
2
1
b
a
1.Locknut
2.Adjusting nut
3MB-9-E7 12/27/00 2:52 PM Page 54

6-19
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
9
EW000083
wProper loading of your motorcycle
is important for several character-
istics of your motorcycle, such as
handling, braking, performance
and safety. Do not carry loosely
packed items that can shift.
Securely pack your heaviest items
close to the center of the motorcy-
cle, and distribute the weight even-
ly from side to side. Properly
adjust the suspension for your
load, and check the condition and
pressure of your tires. NEVER
OVERLOAD YOUR MOTORCYCLE.
Make sure the total weight of the
cargo, rider, passenger, and
accessories (fairing, saddlebags,
etc. if approved for this model)
does not exceed the maximum
load of the motorcycle. Operation
of an overloaded motorcycle could
cause tire damage, an accident, or
even injury.
Tire inspection
Always check the tires before operat-
ing the motorcycle. If center tread
depth reaches the limit as shown, if
the tire has a nail or glass fragments
in it, or if the side wall is cracked,
contact a Yamaha dealer immediate-
ly and have the tire replaced.
EW000078
wAfter extensive tests, the tires
mentioned below have been
approved by Yamaha Motor Co.,
Ltd. for this model. No guarantee
for handling characteristics can be
given if tire combinations other
than what is approved are used on
this motorcycle. The front and rear
tires should be of the same manu-
facture and design.
1
2
1.Tread depth
2.Side wall
ManufacturerSizeType
BRIDGESTONE2.75-21 45PTW25FRONTManufacturerSizeType
BRIDGESTONE4.10-18 59PTW44REAR
Minimum tire tread
1.6 mm
depth (front and rear)
3MB-9-E7 12/27/00 2:52 PM Page 55

8-1
1
2
3
4
5
6
78
9
EAU01038
SPECIFICATIONS
Specifications
ModelDT125R
Dimensions
Overall length2,170 mm
2,235 mm (N, S, SF, CH, A only)
Overall width830 mm
Overall height1,255 mm
Seat height885 mm
Wheel base1,415 mm
Ground clearance315 mm
Minimum turning radius2,100 mm
Basic weight (with oil and
full fuel tank)127 kg
129 kg (CH, A only)
Engine
Engine typeLiquid-cooled 2-stroke
Cylinder arrangementForward-inclined single
cylinder
Displacement124 cm
3
Bore ´Stroke56.0 ´50.7 mm Compression ratio6.7:1
Starting systemKick starter
Lubrication systemSeparate lubrication
(Yamaha autolube)
Engine oil (2-cycle)
Type2 stroke engine oil
Capacity
Total amount1.2 L
Transmission oil
TypeSAE 10W30 type SE motor oil
Capacity
Periodic oil change0.75 L
Total amount0.8 L
Radiator capacity
(Including all routes)0.92 L
Air filterWet type element
Fuel
TypeRegular unleaded gasoline
Fuel tank capacity10 L
Reserve amount1.8 L
3MB-9-E7 12/27/00 2:52 PM Page 83

8-3
1
2
3
4
5
6
78
9
SPECIFICATIONS
90 kg load ~ maximum
load*
Front150 kPa (1.50 kg/cm
2, 1.50 bar)
Rear175 kPa (1.75 kg/cm2, 1.75 bar)
Off-road riding
Front125 kPa (1.25 kg/cm2, 1.25 bar)
Rear150 kPa (1.50 kg/cm2, 1.50 bar)
* Load is total weight of cargo, rider, passenger and accessories.
Wheels
Front
TypeSpoke wheel
Size1.60 ´21
Rear
TypeSpoke wheel
Size1.85 ´18
Brakes
Front
TypeSingle disc brake
OperationRight hand operation
FluidDOT 3 or DOT 4Rear
TypeSingle disc brake
OperationRight foot operation
FluidDOT 3 or DOT 4
Suspension
FrontTelescopic fork
RearSwingarm (link suspension)
Shock absorber
FrontCoil spring/oil damper
RearCoil-gas spring/oil damper
Wheel travel
Front270 mm
Rear260 mm
Electrical
Ignition systemC.D.I.
Charging system
TypeC.D.I. magneto
3MB-9-E7 12/27/00 2:52 PM Page 85

8-5
1
2
3
4
5
6
78
9
SPECIFICATIONS
EAU01064
HOW TO USE THE CONVERSION TABLEAll specification data in this manual are listed in SI and
METRIC UNITS.
Use this table to convert METRIC unit data to
IMPERIAL unit data.
Ex.
METRICMULTIPLIERIMPERIAL
** mm´0.03937=** in
2 mm´0.03937=0.08 in
METRIC TO IMPERIAL
Metric unitMultiplierImperial unit
m¥kg7.233ft¥lb
Torquem¥kg86.794in¥lb
cm¥kg0.0723ft¥lb
cm¥kg0.8679in¥lb
Weightkg2.205lbg0.03527oz
Speedkm/hr0.6214mph
km0.6214mi
m3.281ft
Distancem1.094yd
cm0.3937in
mm0.03937in
cc (cm3)0.03527oz (IMP liq.)
Volume/cc (cm3)0.06102cu¥in
Capacitylt (liter)0.8799qt (IMP liq.)lt (liter)0.2199gal (IMP liq.)
kg/mm55.997lb/in
Misc.kg/cm214.2234psi (lb/in2)Centigrade(¡C)
9/5 + 32
Fahrenheit(¡F)
CONVERSION TABLE
3MB-9-E7 12/27/00 2:52 PM Page 87