2000 YAMAHA DT125R checking oil

PERIODIC MAINTENANCE AND MINOR
REPAIR................................................................6-1
Tool kit..............................................................6-1
Periodic maintenance and lubrication chart......6-3
Cowling removal and installation......................6-6
Cowling A..........................................................6-6
Cowling B..........................................................6-7
Cowling C.........................................................6-8
Panel removal and installation..........................6-8
Panel D.............................................................6-9
Panel E.............................................................6-9
Spark plug.......................................................6-10
Transmission oil..............................................6-11
Cooling system...............................................6-12
Changing the coolant......................................6-13
Air filter............................................................6-15
Carburetor adjustment....................................6-16
Idle speed adjustment.....................................6-17
Throttle cable free play adjustment.................6-17
Tires................................................................6-18
Wheels............................................................6-20
Clutch lever free play adjustment...................6-21
Front brake lever free play adjustment...........6-21
Rear brake pedal height adjustment...............6-22
Brake light switch adjustment.........................6-23
Checking the front and rear brake pads.........6-23Inspecting the brake fluid level.......................6-24
Brake fluid replacement..................................6-25
Drive chain slack check..................................6-25
Drive chain slack adjustment..........................6-26
Drive chain lubrication....................................6-26
Cable inspection and lubrication.....................6-27
Throttle cable and grip lubrication...................6-27
Autolube pump adjustment.............................6-28
Brake and shift pedal lubrication.....................6-28
Brake and clutch lever lubrication...................6-28
Sidestand lubrication......................................6-29
Front fork inspection.......................................6-29
Steering inspection.........................................6-30
Wheel bearings...............................................6-30
Battery............................................................6-31
Fuse replacement...........................................6-33
Headlight bulb replacement............................6-33
Turn signal light bulb replacement..................6-35
Tail/brake light bulb replacement....................6-35
Supporting the motorcycle..............................6-36
Front wheel removal.......................................6-36
Front wheel installation...................................6-37
Rear wheel removal........................................6-38
Rear wheel installation....................................6-39
Troubleshooting..............................................6-39
Troubleshooting chart.....................................6-40
TABLE OF CONTENTS
1
2
3
4
5
6
7
8
9
6
3MB-9-E7 12/27/00 2:52 PM Page 6

6-11
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
9 Spark plug gap:
0.7 ~ 0.8 mm
Tightening torque:
Spark plug:
20 Nm (2.0 m
0kg)
1
3 2
EAU03109
Transmission oilOil level inspection
1.Place the motorcycle on a level
place and hold it in an upright
position. Warm up the engine for
several minutes.NOTE:
Be sure the motorcycle is positioned
straight up when checking the oil
level. A slight tilt toward the side can
result in false readings.1.Level window
2.Maximum level
3.Minimum level
Installation
1.Measure the electrode gap with
a wire thickness gauge and, if
necessary, adjust the gap to
specification.
2.Clean the gasket surface. Wipe
off any grime from the threads.
3.Install the spark plug and tighten
it to the specified torque.
1
1.Spark plug gap
NOTE:
If a torque wrench is not available
when you are installing a spark plug,
a good estimate of the correct torque
is 1/4 to 1/2 turn past finger tight.
Have the spark plug tightened to the
specified torque as soon as possible.4.Install the spark plug cap.
3MB-9-E7 12/27/00 2:52 PM Page 47

6-12
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
95.Fill the engine with sufficient oil
to reach the specified level.
Install the oil filler cap and tight-
en it.
EC000079
cCDo not put in any chemical addi-
tives. Transmission oil also lubri-
cates the clutch and additives
could cause clutch slippage.6.Start the engine and warm up for
a few minutes. While warming
up, check for oil leakage. If oil
leakage is found, stop the engine
immediately and check for
cause. Recommended oil:
See page 8-1.
Oil quantity:
Total amount: 0.8 L
Periodic oil change: 0.75 L
1
Transmission oil replacement
1.Warm up the engine for several
minutes.
2.Stop the engine. Place an oil pan
under the engine to catch the oil
and remove the oil filler cap.
3.Remove the drain bolt and drain
the oil.
4.Install the drain bolt and tighten it
to the specified torque.1.Drain bolt
Tightening torque:
Drain bolt:
15 Nm (1.5 m
0kg)
1
2.With the engine stopped, check
the oil level through the level
window located at the right side
crankcase cover.NOTE:
Wait a few minutes until the oil level
settles before checking.3.The oil level should be between
the maximum and minimum level
on the level window. If the level
is low, add sufficient oil to raise it
to the specified level.1.Oil filler cap
3MB-9-E7 12/27/00 2:52 PM Page 48

6-24
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
98Use only the designated quality
brake fluid. Otherwise, the rub-
ber seals may deteriorate, caus-
ing leakage and poor brake per-
formance.
NOTE:
If DOT 4 is not available, DOT 3 can
be used.
EAU00732
Inspecting the brake fluid
levelInsufficient brake fluid may let air
enter the brake system, possibly
causing the brakes to become inef-
fective.
Before riding, check that the brake
fluid is above the minimum level and
fill when necessary.
Observe these precautions:
8When checking the fluid level,
make sure the top of the master
cylinder is level by turning the
handlebars.
1
1.Minimum level mark FRONT
1
1.Minimum level markREARRecommended brake fluid:
DOT 4
8Refill with the same type of brake
fluid. Mixing fluids may result in a
harmful chemical reaction and
lead to poor brake performance.
8Be careful that water does not
enter the master cylinder when
refilling. Water will significantly
lower the boiling point of the fluid
and may result in vapor lock.
8Brake fluid may deteriorate paint-
ed surfaces or plastic parts.
Always clean up spilled fluid
immediately.
8Have a Yamaha dealer check
the cause if the brake fluid level
goes down.
3MB-9-E7 12/27/00 2:52 PM Page 60