2000 SUBARU FORESTER warning

7-8
Catalytic converter
WARNING
Avoid fire hazards. Do not drive or park the vehicle anywhere
near flammable materials (e.g. grass, paper, rags or leaves), be-
cause the catalytic converter operates at very high temperatures. Keep everyone and flammable materials away from the ex-
haust pipe while the engine is running. The exhaust gas is veryhot.
HB3003BA
The c atalytic c onverter is installed in the exhaust system. It serves as a
c atalyst to red uc e HC, CO and NOx in exhaust g ases, thus p rovid ing
c leaner exhaust.
To avoid d amag e to the c atalytic c onverter: Use only unlead ed fuel. Even a small amount of lead ed fuel will d am-
ag e the c atalytic c onverter. Never start the eng ine b y p ushing or p ulling the ve hic le.
Avoid rac ing the eng ine.
Never turn off the ig nition switc h while the vehic l e is moving .
Keep your eng ine tuned -up . If you feel the eng ine r unning roug h (mis-
firing , b ac kfiring or inc omp lete c omb ustion), have your vehic le c hec ked
and rep aired b y an authorized SUBARU d ealer. Do not ap p ly und erc oating or rust p revention treatm ent to the heat
shield of c atalytic c onverter and the exhaust syste m

Starting and operating7-9
–
CONTINUED –
Fuel economy hints
The following sug g estions will help to save your fu
el.
Selec t the p rop er g ear p osition for the sp eed and r oad c ond itions.
Avoid sud d en ac c eleration or d ec eleration. Always a c c elerate g ently
until you reac h the d esired sp eed . Then try to main tain that sp eed for as
long as p ossib le. Do not p ump the ac c elerator and avoid rac ing the en g ine.
Avoid unnec essary eng ine id ling .
Keep the eng ine p rop erly tuned .
Keep the tires inflated to the c orrec t p ressure sho wn on the tire p lac -
ard , whic h is loc ated und er the d oor latc h on the d river’s sid e. Low p res-
sure will inc rease tire wear and fuel c onsump tion. Use the air c ond itioner only when nec essary.
Keep the front and rear wheels in p rop er alig nment.
Avoid c arrying unnec essary lug g ag e or c arg o.
Preparing to drive
You should p erform the following c hec ks and ad justm ents every d ay b e-
fore you start d riving .
1. Chec k that all wind ows, mirrors, and lig hts are c lean and unob -
struc ted .
2. Chec k the ap p earanc e and c ond ition of the tires. Also c hec k tires for
p rop er inflation.
3. Look und er the vehic le for any sig n of leaks.
4. Chec k that the hood and rear g ate are fully c lose d .
5. Chec k the ad justment of the seat.
6. Chec k the ad justment of the insid e and outsid e mi rrors.
7. Fasten your seat b elt. Chec k that your p asseng ers have fastened
their seat b elts.
8. Chec k the op eration of the warning and ind ic ator lig hts when the ig ni-
tion switc h is turned to the “ON ” p osition.
9. Chec k the g aug es, ind ic ator and warning lig hts af ter starting the en-
g ine.

7-10NOTE Engine oil, engine coolant, brake fluid, washer fluid and other fluid
levels should be checked daily, weekly or at fuel stops.
Driving in foreign countries
When p lanning to use your vehic le in another c ountr
y:
Confirm the availab ility of the c orrec t fuel. (Refe r to Fuel Req uirement
sec tion in this c hap ter.) Comp ly with all reg ulations and req uirements of eac h c ountry.
Periodic inspections
To keep your vehic le in the b est c ond ition at all t imes, always have the
rec ommend ed maintenanc e servic es listed in the main tenanc e sc hed ule
in the “Warranty and Maintenanc e Booklet ” p erformed at the sp ec ified
time or mileag e intervals.
Ignition switch
WARNING
Never turn the ignition switch to “LOCK” while the vehicle is be-
ing driven or towed because that will lock the steering wheel, pre- venting steering control. And when the engine is turned off, it
takes a much greater effort than usual to steer.
The ig nition switc h has four p ositions: LOCK, ACC, ON and START.

7-14tral. Hold the c lutc h p ed al to the floor while star
ting the eng ine. The
starter motor will only op erate when the c lutc h p ed al is p ressed fully
to the floor.
4. Turn the ig nition switc h to the “ON ” p osition and c hec k the op era-
tion of the warning and ind ic ator lig hts. Refer to “Warning and ind ic a-
tor lig hts ” sec tion (Chap ter 3).
5. Turn the ig nition switc h to the “START ” p osition without d ep ressing
the ac c elerator p ed al. Release the key immed iately after the eng ine
has started .
If the eng ine d oes not start within ten sec ond s, wa it a while and then
turn the ig nition switc h to the “START ” p osition ag ain while d ep ressing
the ac c elerator p ed al half way d own.
6. Confirm that all warning and ind ic ator lig hts hav e g one off after the
eng ine has started . The fuel injec tion system autom atic ally lowers the
id le sp eed as the eng ine warms up . Automatic transmission vehicles CAUTION
If you restart the engine while the vehicle is moving, shift the se- lector lever into the “N” position. Do not attempt to place the se-
lector lever of a moving vehicle into the “P” position.
1. Ap p ly the p arking b rake.
2. Turn off unnec essary lig hts and ac c essories.
3. Shift the selec tor lever to the “P ” or “N ” p osition (p referab ly “P ”
p osition).
The starter will only op erate when the selec t lever is at the “P ” or “N ”
p osition.
4. Turn the ig nition switc h to the “ON ” p osition and c hec k the op era-
tion of the warning and ind ic ator lig hts. Refer to “Warning and ind ic a-
tor lig hts ” sec tion (Chap ter 3).
5. Turn the ig nition switc h to the “START ” p osition without depress-
ing the accelerator pedal . Release the key immed iately after the en-
g ine has started .

Starting and operating7-15
–
CONTINUED –
If the eng ine d oes not start within ten sec ond s, wa
it a while and then
turn the ig nition switc h to the “START ” p osition ag ain while d ep ressing
the ac c elerator p ed al half way d own.
6. Confirm that all warning and ind ic ator lig hts hav e g one out after
the eng ine has started . The fuel injec tion system a utomatic ally lowers
the id le sp eed as the eng ine warms up .
While the eng ine is warming up , make sure that the selec tor lever is at
the “P ” or “N ” p osition and that the p arking b rake is ap p lied .
During cold weather below – 4F ( – 20 C)
If the eng ine is d iffic ult to start using the norma l method (without d e-
p ressing the ac c elerator p ed al), turn the ig nition switc h to the
“ START ” p osition while slig htly d ep ressing the ac c elerator p ed al.
Flooded engine
If the eng ine d oes not start, it may b e flood ed (ex c essive fuel in the
eng ine).
In c ase of a flood ed eng ine, turn the starter motor for five sec ond s
with the ac c elerator p ed al fully d ep ressed . Rep eat this two or three
times until the eng ine starts. Release the ig nition switc h and ac c elera-
tor p ed al as soon as the eng ine starts.
Stopping the engine
WARNING
Do not stop the engine when the vehicle is moving. This will
cause loss of power to the power steering and the brake booster,making steering and braking more difficult. It could also result in
accidental activation of the “LOCK” position on the ignition
switch, causing the steering wheel to lock.
The ig nition switc h should b e turned off only when the eng ine is id ling .

7-16Manual transmission
WARNING
Do not drive the vehicle with the clutch disengaged (i.e., when the clutch pedal is depressed) or with the shift lever in the neutralposition. Engine braking has no effect in either of these condi-tions and the risk of an accident is consequently increased.
CAUTION
Shift into reverse ONLY when the vehicle has completelystopped. It may cause damage to the transmission to try shiftinginto reverse when the vehicle is moving.
The manual transmission is a fully sync hromeshed 5- forward and 1-re-
verse sp eed transmission.
HS0128
The shift p attern is shown on the shift lever knob . When shifting from 5th
g ear to reverse g ear, first return the shift lever to the neutral p osition then
shift into reverse g ear.
To c hang e g ears, fully d ep ress the c lutc h p ed al, mo ve the shift lever,
and g rad ually let up on the c lutc h p ed al.
If it is d iffic ult to shift into g ear, p ut the tran smission in neutral, release the
c lutc h p ed al momentarily, and then try ag ain.

Starting and operating7-17
–
CONTINUED –

Shifting speed
n Recommended shifting speeds
The b est c omp romise b etween fuel ec onomy and vehic l e p erfor-
manc e d uring normal d riving is ensured b y shifting up at the sp eed s
listed in the following tab le.
Shift up
mp h (km/h)
1st to 2nd15 (24)
2nd to 3rd25 (40)
3rd to 4th40 (65)
4th to 5th45 (73)
nMaximum allowable speeds
WARNING
When shifting down a gear, ensure that the vehicle is not travel- ling at a speed exceeding the Maximum Allowable Speed for thegear which is about to be selected. Failure to observe this pre-caution can lead to engine over-revving and this in turn canresult in engine damage.In addition, sudden application of engine brakes when the vehicleis travelling on a slippery surface can lead to wheel locking; as a
consequence, control of the vehicle may be lost and the risk ofan accident increased.
The following tab le shows the maximum sp eed s that a re p ossib le with
eac h d ifferent g ear. The tac hometer ’s need le will enter the red area if
these sp eed s are exc eed ed .
With the exc ep tion of c ases where sud d en ac c elerati on is req uired ,
the vehic le should not b e d riven with the tac homete r’s need le insid e
the red area. Failure to ob serve this p rec aution c a n lead to exc essive
eng ine wear and p oor fuel ec onomy.

Starting and operating7-19
–
CONTINUED –
Automatic transmission
WARNING
Do not shift from the “P” or “N” position into the “D”, “3”, “2”,
“1” or “R” position while depressing the accelerator pedal. This
may cause the vehicle to jump forward or backward.
CAUTION
Shift into the “P” or “R” position only after the vehicle is com-
pletely stopped. Shifting while the vehicle is moving may cause
damage to the transmission. Do not race the engine for more than five seconds in any posi-
tion except the “N” or “P” position when the brake is set or the
tires are on blocks. This may cause the automatic transmissionfluid to overheat. Avoid shifting from one of the forward driving positions into
the “R” position or vice versa until the vehicle has completely
stopped. Such shifting may cause damage to the transmission.
The automatic transmission is elec tronic ally c ontro lled with 4-forward
sp eed s and 1-reverse sp eed .
NOTE
Immediately after a disconnected battery is reconnected or ATF (au- tomatic transmission fluid) is replaced, you may feel that the auto-matic transmission operation is somewhat unusual.This results from erasure or invalidation of data which the on-boardcomputer has collected and stored in memory to allow the transmis-sion to shift at the most appropriate times for the current conditionof your vehicle. Optimized shifting will be restored as the vehiclecontinues to be driven for a while.