2000 SUBARU FORESTER oil temperature

[x] Cancel search: oil temperature

Page 11 of 322

SUBARU FORESTER 2000 SF / 1.G Owners Manual 13-2A 
ABS (Anti-Loc k Brake System) (if eq uip p ed ) 7-34
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 
ABS warning  lig ht (for vehic les with ABS) 3-8 . . . . . . . . . . . . . . . .

Page 93 of 322

SUBARU FORESTER 2000 SF / 1.G Owners Manual 3
Instruments and controls Gauges3-2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  . . . . . . . 
Speedometer 3-2
. .

Page 101 of 322

SUBARU FORESTER 2000 SF / 1.G Owners Manual  Instruments and controls3-9
–
 CONTINUED  –
�
The warning  lig ht c omes on when the ig nition switc h  is turned  to the
“ ON ” p osition, b ut it d oes not g o out even when the veh ic le s

Page 162 of 322

SUBARU FORESTER 2000 SF / 1.G Owners Manual 6-18If the temperature is beyond the range, the maximum number is shown.
Accessory power socket �Electrical power socket located on the left-lower part of theinstrument panel CAUTION
The electrical po

Page 267 of 322

SUBARU FORESTER 2000 SF / 1.G Owners Manual  Maintenance and service10-11
–
 CONTINUED  –
 OM-H2756
SAE viscosity number and applicable temperature
� Recommended grade and viscosity under severe driving conditions
If the vehic le is used  i

Page 268 of 322

SUBARU FORESTER 2000 SF / 1.G Owners Manual 10-12Cooling system
WARNING
Never attempt to remove the radiator cap until the engine has 
been shut off and has cooled down completely. Since the coolantis under pressure, you may suffer serious burn

Page 279 of 322

SUBARU FORESTER 2000 SF / 1.G Owners Manual  Maintenance and service10-23
–
 CONTINUED  –
SAE viscosity No. and Applicable Temperature
 OM-H0212
Rear differential gear oil
�Checking the oil level CAUTION
If the vehicle requires frequent ref

Page 280 of 322

SUBARU FORESTER 2000 SF / 1.G Owners Manual 10-24
HB0078
HB0077
Filler hole
Drain hole Filler hole
Drain hole
Oil level
Remove the p lug  from the filler hole and  c hec k the  oil level. The oil
level should  b e kep t even with the b ottom of