1-28Engine hood
WARNING
Always check that the hood is properly locked before you start
driving. If it is not, it might fly open while the vehicle is moving
and block your view, which may cause an accident and serious
bodily injury.
HS0025
HS0026 HS0024
To op en the hood :
1. Pull the hood release knob und er the instrument p
anel.
2. Release the sec ond ary hood release loc ated und er the front of the
eng ine hood b y moving the lever toward the left. Li ft up the hood , release
the hood p rop from its retainer and p ut the end of the hood p rop into the
slot in the hood .
Doors and locks1-29
–
CONTINUED –
To c lose the hood :
1. Lift the hood slig htly and remove the hood p rop f
rom the slot in the
hood and return the p rop to its retainer.
2. Lower the hood until it ap p roac hes ab out 6 in. (1 5 c m) from the
c losed p osition and let it d rop .
3. After c losing the hood , b e sure the hood is sec ur ely loc ked .
If this d oes not c lose the hood , release it from a slig htly hig her p osition.
Do not p ush the hood forc ib ly to c lose it. It c ould d eform the metal.
Roof rail and crossbar (if equipped)
CAUTION
For cargo carrying purposes, the roof rail must be used to-
gether with a roof cross bar kit. The roof rail must never be used
alone to carry cargo. Otherwise, damage to the roof or paint or adangerous road hazard due to loss of cargo could result. When using the roof cross bar kit, make sure that the total
weight of the crossbars, carrying attachment and cargo does not
exceed the maximum load limit. Overloading may cause damageto the vehicle and create a safety hazard.
HS1005BB
The roof rail is not d esig ned to c arry c arg o b y its elf.
Carg o c an b e c arried on the roof after sec uring the roof c ross b ar kit to
