2000 Lexus ES300 ignition

iiiThis vehicle should not be modified with non±genuine
Lexus products. Modification with non±genuine Lexus
products could affect its performance, safety or
durability, and may even violate governmental
regulations. In addition, damage or performance
problems resulting from the modification may not be
covered under warranty.
Spark ignition system of your Lexus
The spark ignition system in your Lexus meets all
requirements of the Canadian Interference±Causing
Equipment Standard.
Installation of a mobile two±way radio
system
As the installation of a mobile two±way radio system in
your
vehicle could affect electronic systems such as the
multiport fuel injection system/sequential multiport fuel
injection system, cruise control system, anti±lock brake
system and Supplemental Restraint System (SRS), be
sure to check with your Lexus dealer for precautionary
measures or special instructions regarding installation.
Scrapping of your Lexus
The Supplemental Restraint System (SRS) in your
Lexus consists of driver and front passenger airbags,
side airbags and seat belt pretensioners. The SRS
device contains explosive chemicals. If the vehicle is
scrapped with the airbags and seat belt pretensioners
left as they are, this may cause an accident such as fire.
Be sure to have the SRS removed and disposed of by
a qualified service shop or by your Lexus dealer before
you scrap your vehicle.

BE028
Note: When the cruise control is being used, even if you downshift the transmi\
ssion by turning off the overdrive switch, engine
braking will not be applied because the cruise control is not cancelled. For th\
e operation to decrease the vehicle speed, see page
298.
Parking, engine starting and key
removal position
Reverse position
Neutral position
Normal driving position
Position for engine braking
Position for stronger engine braking
than that in ª2º position
With the brake pedal depressed,
shift while holding the lock release
button in. (The ignition switch must
be in ªONº position.)
Shift while holding the lock release
button in.
Shift normally.
Overdrive switch
For selecting either a three±speed or
four±speed transmission
Lock release button (To prevent misshifting)
ªO/D OFFº indicator
light on the instrument
cluster
BASIC OPERATION ± QUICK REFERENCE
3
3. AUTOMATIC TRANSMISSION

BE004
BE004
Parking, tail, license plate,
side marker and instrument
panel lights turn on.
Headlights turn of at full
intensity.
Automatic light control
Parking, tail, license plate,
side marker and instrument
panel lights turn on.
Headlights also turn on.
Automatic light control
BE005
BE006
High beam
Headlight flasher
Right or left turn
Lane change
(Right or left)
BASIC OPERATION ± QUICK REFERENCE
4
4. HEADLIGHT AND TURN
SIGNAL SWITCH

HEADLIGHT SWITCH
With the ignition OFF
With the engine started and parking
brake released

TURN SIGNAL SWITCH

KEYS AND DOORS
13
11E042
The engine immobiliser system is a theft prevention
system. When you insert the key in the ignition
switch, the transponder chip in the key's head
transmits an electronic code to the vehicle. The
engine will start, only when the electronic code in
the chip corresponds to the registered ID code for
the vehicle.
The system is automatically set when the key is
removed from the ignition switch. At this time, the
security indicator light flashes. When you insert the key
in the ignition switch, the security indicator light goes out
and the system is canceled automatically, which
enables the engine to start.
For your Lexus dealer to make you a new key with
built±in transponder chip, your dealer will need your key
number and master key. However, there is a limit to the
number of additional keys your Lexus dealer can make
for you. If you make your own duplicate key, you will not be
able to cancel the system or start the engine.
For vehicles sold in U.S.A.
FCC ID: MOZ RI±4ETY MADE IN JAPAN
This device complies with Part 15 of the FCC
Rules.
Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired
operation.

KEYS AND DOORS
16dropping it.
 Avoid putting it in water.
Locking/Unlocking the doors
When you push the ªLOCKº button on the key
briefly, all the doors can be locked from outside the
vehicle.
At this time, one beep sounds and the parking lights and
tail lights flash once. However, when you push the
ªLOCKº button with any door not closed securely, the
buzzer sounds for 10 seconds. To stop the buzzer, close
all the doors securely or push the ªUNLOCKº button. If
the key is in the ignition switch, locking cannot be done.
Make sure all the doors are locked when you leave the
vehicle. Push the ªLOCKº button once again.
NOTICE
Do not push the ªLOCKº button any longer than 2 to 3 seconds. Pushing the button longeractivates an alarm. For details, see page 19.
When you push the ªUNLOCKº button, the driver's
door is unlocked. Pushing that button once again
within 3 seconds from the first push, all other doors
are also unlocked.

KEYS AND DOORS
17
At this time, two beeps sounds and the parking lights and
tail lights flash twice. Together with the activation of
unlocking, the interior light comes on for 15 seconds if
the interior light switch is in ªDOORº position. However,
this f
unction does not work when the ignition key is in the
ªONº position. For further information, see ªInterior lightº
on page 75.
You have 30 seconds to open a door after using the
wireless remote unlock feature. If a door is not opened
by then, all the doors will be automatically locked again.
Even if the ªLOCKº or ªUNLOCKº switch is kept pressed
in, the locking or unlocking operation is not repeated.
Release the button and then push again.

KEYS AND DOORS
19
Unlocking the trunk lid
11E030
When you keep the button pushed for about 1
second, you can unlock the trunk lid. One beep
sounds.
This function does not work when the ignition key is in
the ªONº position.Sounding an alarm
11E024

KEYS AND DOORS
20When you push the ªPANICº button for about 2 to 3
seconds, an alarm sounds to deter any person
trying to break into or damage your vehicle.
If you want to stop the alarm, push any button.
This function does not work when the ignition key is in
the ªONº position.
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment
generates, uses and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the following
measures:
± Reorient or relocate the receiving antenna.
± Increase the separation between the
equipment and receiver.
± Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
± Consult the dealer or an experienced radio /
TV technician for help.