2000 HONDA S2000 display

Operating the Radio
The ignition switch must be in
ACCESSORY (I) or ON (II) to
operate the audio system.
Turn the
system on by pushing the
PWR/
VOL
knob. Adjust the volume by
turning the same knob.
The band and frequency that the
radio was last tuned to is displayed.
To change bands, press the
AM/FM
button. On the FM band, ST will be
displayed
if the station is broadcast­
ing
in stereo. Stereo reproduction on
AM is not available.
You can use any of four methods to
find radio stations on the selected
band:
TUNE, SEEK, SCAN or the
Preset buttons.
TUNE -Use the TUNE bar to tune
the radio to a desired frequency.
Press the ~ side of the bar to tune
to a higher frequency, and the
~ side to tune to a lower
frequency.
The frequency numbers
will start to change rapidly. Release
the bar when the display reaches the
desired frequency. To change
the
frequency in small increments, press
and release the
TUNE bar quickly.
Audio System
SEEK -The SEEK function
searches the band for a station with
a strong signal. To activate
it, press
the
SEEK bar on either the 1<111<111 or
~ side, then release it.
Depending on which side you press,
the system scans upward or
down­
ward from the current frequency. It
stops when it finds a station with a
strong signal.
CONTINUED
Comfort and Convenience Features 95

Audio System
SCAN -The SCAN function
samples
all the stations with strong
signals on the selected band.
To
activate it, press the SCAN button,
then release it. When the system is
in the SCAN mode, SCAN shows in
the display.
The system will scan up
the band for a station with a strong
signal. When it finds one, it will stop
and play that station for
approximately five seconds.
If you do
nothing, the system will then scan
for the next strong station and play
that for five seconds. When it plays a
station that you want to continue
listening to, press the
SCAN button
again.
Preset -You can store the fre­
quencies of your favorite radio
stations in the six preset buttons.
Each button will store one frequency
on the
AM band, and two on the FM
band.
96 Comfort and Convenience Features

Audio System
AUTO SELECf -If you are
traveling far from home and can no
longer receive the stations you
preset, you can use the Auto Select
feature to find stations
in the local
area.
To activate Auto Select, press the
A. SEL button. A. SEL will flash in
the display, and the system will go
into scan mode for several seconds.
It automatically scans both bands,
looking for stations with strong
signals;
It stores the frequencies of
six AM stations and twelve FM
stations
in the preset buttons. You
can then use the preset buttons to
select those stations.
If you are in a remote area, Auto
Select may not find six strong AM
stations or twelve strong FM stations.
If this happens, you will see a "0"
displayed when you press any preset
button that does not have a station
stored.
98 Comfort and Convenience Features
If you do not like the stations Auto
Select has stored, you can store
other frequencies
in the preset
buttons.
Use the TUNE, SEEK, or
SCAN function to find the desired
frequencies,
then store them in the
selected preset buttons as described
previously.
SCAN BUTTON
A.SELBUTTON
Auto Select does not erase the
frequencies
that you preset pre­
viously. When you return home, turn
off Auto Select by pressing the
A. SEL button. The preset buttons
will then select the frequencies you
originally set.

Audio System
Audio System Lighting
The audio system illuminates when
the parking lights are on, even
if the
radio is turned off.
1 00 Comfort and Convenience Features
Radio Frequencies
Your Honda's radio can receive the
complete AM and FM bands.
Those bands cover these frequen­
cies:
AM band:
530 to 1,710 kilohertz
FMband:
87.7 to 107.9 megahertz
Radio stations on
the AM band are
assigned frequencies at least ten
kilohertz apart
(530, 540, 550).
Stations on the FM band are
assigned frequencies
at least 0.2
megahertz apart (87.9, 88.1, 88.3). Stations
must use these exact
frequencies.
It is fairly common for
stations to round-off the frequency
in
their advertising, so your radio could
display a frequency of
100.9 even
though the announcer may identify
the station as
"FM101."

Audio System
Operating the CD Player
You operate the CD player with the
same controls used for the radio.
With the ignition switch in
ACCESSORY (I) or ON (lD, insert
the disc into the
CD slot. Push the
disc
in halfway, the drive will pull it
in the rest of the way and begin to
play.
The number of the track that is
playing is shown
in the display.
You can also play 3-inch (8-cm) discs
without using an adapter ring. In
all
cases, play only standard round discs.
Odd-shaped CDs may jam in the
drive or cause other problems.
When the system reaches the end of
the disc, it will return to the begin­
ning and play that disc again.
1 04 Comfort and Convenience Features