ENGINE/TRANSMISSION
²Horsepower Ð 200 hp @ 6 600 rpm
²Torque Ð 167 lb/ft at 5 500 rpm
²Redline Ð 6 750 rpm (fuel shut-off 7 000 rpm)
²Compression ratio Ð 10.0:1
²Throttle body Ð 60 mm
²Mass air sensor Ð 70 mm
²Air filter assembly Ð large capacity, conical
²Upper intake manifold and cylinder heads Ð Extrude Honeypolished
²Lower intake manifold Ð 32 mm
²Pistons Ð Unique design, aluminum-alloy
²Camshafts Ð special design intake and exhaust cams
²Flywheel weight Ð 18 lbs
²Fuel injectors Ð 19 lbs/hour
²Oil cooler Ð block mounted, water-to-oil cooler
²Engine cooling Ð heavy duty radiator core
²Exhaust Ð Quasi-dual exhaust
²Transaxle Ð MTX-75 5±speed with high performance clutch
Engine/Transmission
7
FLUID RECOMMENDATIONS
Fluid capacities:
Please refer to your Contour Owner's Guide.
Fuel recommendation:
91 Octane or higher
Regular fuel can be used in the SVT Contour without damaging
engine components. The knock sensor will adjust the engine
calibration to accomodate regular unleaded fuel. This may result in
a degradation of engine performance.
SYNTHETIC FLUIDS
There are no synthetic fluids or break-in fluids in your SVT Contour
when it leaves the factory. Note that SVT does not make
recommendations about the use of synthetic oils in your vehicle. Should
you decide to use synthetic engine oil, we recommend you allow 4 000 to
6 000 miles (6 500 km to 9 600 km) in order to assure complete break-in
before switching to synthetic oil.
MAINTENANCE AND BREAK-IN
For complete maintenance and break-in procedure information, please
refer to your Contour Owner's Guide.
91(R+M)/2 METHOD
Maintenance
13
