2000 CHRYSLER CARAVAN fuel filter

TEST TC-45ACONTINUED - REPAIRING - FUEL QUANTITY ACTUATOR POS. GOVERNOR
DEVIATION COLD
*Perform Verification TEST VER-2A. **Check connectors - Clean / repair as necessary.
CHECK FOR RECENT
TEST TC-45A REPLACEMENT OR
CONTINUED FROM MOVEMENT OF THE
PREVIOUS PAGE. FUEL INJECTION
PUMP ASSEMBLY.
NOTE: AN
IMPROPERLY TIMED WAS THE FUEL YES RESET FUEL
FUEL INJECTION INJECTION PUMP INJECTION PUMP TO
PUMP WILL CAUSE MOVED OR REPLACED? ENGINE TIMING.
THIS CODE TO SET.
NO
INSPECT THE FUEL
SYSTEM FOR AT THE FUEL TANK WAS A RESTRICTION YES REPAIR AS
RESTRICTIONS AT THE MODULE. FOUND? NECESSARY.*
DELIVERY LINES,
FILTER AND....
NO
REPLACE THE FUEL START AND OPERATE
INJECTION PUMP THE ENGINE BETWEEN DOES THE DRB YES REPLACE THE ENGINE
ASSEMBLY. IDLE AND 3500 RPM DISPLAY THIS CODE? CONTROL MODULE.*
USING THE DRB, WHILE MONITORING
ERASE CODES. THE DRB DISPLAY.
NO
TEST COMPLETE.*
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
171
ProCarManuals.com

TEST TC-46ACONTINUED - REPAIRING - FUEL QUANTITY ACTUATOR POS. GOVERNOR
DEVIATION WARM
*Perform Verification TEST VER-2A. **Check connectors - Clean / repair as necessary.
CHECK FOR RECENT
TEST TC-46A REPLACEMENT OR
CONTINUED FROM MOVEMENT OF THE
PREVIOUS PAGE. FUEL INJECTION
PUMP ASSEMBLY.
NOTE: AN
IMPROPERLY TIMED WAS THE FUEL YES RESET FUEL
FUEL INJECTION INJECTION PUMP INJECTION PUMP TO
PUMP WILL CAUSE MOVED OR REPLACED? ENGINE TIMING.
THIS CODE TO SET.
NO
INSPECT THE FUEL
SYSTEM FOR AT THE FUEL TANK WAS A RESTRICTION YES REPAIR AS
RESTRICTIONS AT THE MODULE. FOUND? NECESSARY.*
DELIVERY LINES,
FILTER AND....
NO
REPLACE THE FUEL START AND OPERATE
INJECTION PUMP THE ENGINE BETWEEN DOES THE DRB YES REPLACE THE ENGINE
ASSEMBLY. IDLE AND 3500 RPM DISPLAY THIS CODE? CONTROL MODULE.*
USING THE DRB, WHILE MONITORING
ERASE CODES. THE DRB DISPLAY.
NO
TEST COMPLETE.*
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
175
ProCarManuals.com

TEST NS-4AREPAIRING A START AND STALL CONDITION
Perform TEST NS-SEL Before Proceeding
At this point in the diagnostic test procedure it is assumed that all of the engine electrical systems
are operating as designed and are not the cause of a start and stall, or a no start problem. The
following additional items should be checked as possible mechanical problems. Any one of these
items can produce a start and stall, or no start condition; none can be overlooked as a possible
cause.
1. ENGINE VALVE TIMINGÐ must be within specifications
2. ENGINE COMPRESSIONÐ must be within specifications
3. ENGINE EXHAUST SYSTEMÐ must be free of any restrictions
4. FUELÐ must be free of contamination
5. FUEL FILTERÐ must be free of any restrictions
6. INTAKE AIR DUCTÐ passages must be free of any debris
Always look for any Technical Service Bulletins that may relate to this problem.
N
O
S
T
A
R
T
T
E
S
T
S
418
ProCarManuals.com