TEST VER-1ANO START VERIFICATION
Important Note:
If the Engine Control Module, Sentry Key Immobilizer Module or Body Control Module have been
changed the Vehicle Identification Number (VIN) and Secret Key data must be updated to enable the
vehicle to start and run. Refer to GENERAL INFORMATION SECITON 8.0 for programming
procedures.
Inspect the vehicle to ensure that all engine components are connected. Reassemble and reconnect
components as necessary.
Inspect the engine oil for contamination. If it is contaminated, change the oil and filter.
Using the DRB, clear all diagnostic trouble codes (DTC's).
Turn the ignition off for 10 seconds.
Attempt to start the vehicle.
If the engine isunableto start, look for any Technical Service Bulletins that may relate to this
condition. Return toDTC TESTif necessary.
The repair is now complete.
V
E
R
I
F
I
C
A
T
I
O
N
T
E
S
T
422
ProCarManuals.com
