TEST SC-1ACHECKING SPEED CONTROL OPERATION
*Perform Verification TEST VER-3A. **Check connectors - Clean / repair as necessary.
START TEST KEY ON. WITH THE
SC-1A. DRB, SELECT
"SENSOR DISPLAY".
PRESS EACH OF THE PRESSING EACH SWITCH DID EACH SWITCH
CRUISE SWITCH SHOULD RESULT IN A PROVIDE THE NO PERFORM TEST
BUTTONS WHILE VOLTAGE INPUT SHOWN CORRECT VOLTAGE SC-2A.
OBSERVING CRUISE IN FIG.1. INPUT.
SWITCH VOLTS.
YES
WITH THE DRB, DID THE DRB INDICATE
MONITOR THE WHILE PRESSING AND THE CORRECT CHANGE NO PERFORM TEST
PRIMARY AND RELEASING THE OF STATE FROM SC-3A.
SECONDARY BRAKE BRAKE PEDAL. "RELEASED" TO
SWITCH INPUT... "PRESSED".
YES
DID THE DRB INDICATE
WITH THE DRB, WHILE PRESSING AND THE CORRECT CHANGE NO PERFORM TEST
MONITOR THE CLUTCH RELEASING THE OF STATE FROM SC-4A.
SWITCH INPUT. CLUTCH PEDAL. "RELEASED" TO
"PRESSED".
YES
WITH THE DRB,
MONITOR VEHICLE DOES THE DRB NO PERFORM TEST
SPEED WHILE DISPLAY ACCURATE SC-6A.
DRIVING THE VEHICLE SPEED?
VEHICLE.
YES
DRIVE VEHICLE AND ATTEMPT TO SET DID THE SPEED YES
GENERATE A SPEED SPEED CONTROL. CONTROL MAINTAIN TEST COMPLETED.*
ABOVE 35KM/H. SET VEHICLE SPEED?
NO
CONTINUE TEST
SC-1A ON THE
NEXT PAGE.
S
P
E
E
D
C
O
N
T
R
O
L
T
E
S
T
S
373
ProCarManuals.com
