2000 BMW MOTORRAD C1 washer fluid

11
20
General information and controlsClearing the windscreenPress and hold down button 1
- wiper/washer system
R
– Washer fluid is sprayed onto
the windscreen and the wiper
is switched on briefly
– If the washer fluid foams, the
reservoir is almost empty
(
b44)
( ) Figure in bracketsbpage number for
description
d Warning:
Use the washer system only
when there is no possibility of
the washer fluid freezing on
the windscreen, as this would
impair your vision - use anti-
freeze
Do not operate the washer
system if the washer fluid res-
ervoir is empty, because this
would damage the pump
Wiper and washer system

1
 

2
44
Safety check
Windscreen washer system
d Warning:
Antifreeze for the washer sys-
tem is flammable. Keep it well
away from all sources of igni-
tion, store it in sealed con-
tainers and keep it out of
reach of children. Always fol-
low the instructions on the
container.
Topping up the
washer fluid
• Place the BMW C1 on its stand
– after making sure that the ground is level and firm
 Remove front fairing panel 2
(
b 21)
 Open quick-release fastener 1 on the headlight
and swing the headlight clear
( ) Figure in bracketsbpage number for
description
1
2
gg ,

2
45
Safety check
Open filler 3 of the washer
fluid reservoir
– Move the cap clear
 Refill with washer fluid
– Fill with water and - if neces-
sary - antifreeze in accord-
ance with the
manufacturer's instructions
– It is best to mix the washer
fluid before pouring it into
the reservoir 
Close the washer-fluid reser-
voir
 Swing the headlight back into
position and close the quick-
release fastener to secure
–Make sure that the head-
light is correctly secured
 Install the front fairing panel
(
b 21)
( ) Figure in bracketsbpage number for
description
Windscreen washer system
3