2000 Acura RL ECU

HomeLin
k Universa l Transmitte r

The HomeLink Universal Transmit- ter built into your car can be
programmed to operate remotely-controlled devices around your home,
such as garage doors, lighting, or
home security systems. It can replace up to three remote
transmitters.

Custome r Assistanc e

If you have problems with training
the HomeLink Universal
Transmitter, or would like information on home products thatcan be operated by the transmitter,
call (800) 355-3515. Importan
t Safet y Precaution s
Always refer to the operating instruc- tions and safety information that
came with your garage door opener
or other equipment you intend tooperate with the HomeLink
Universal Transmitter. If you do not
have this information, you should contact the manufacturer of the
equipment.
While training or using the transmitter, make sure you have aclear view of the garage door or gate,
and that no one will be injured by its
movement. If your garage door opener was
manufactured before April 1982, you
may not be able to program the
HomeLink Universal Transmitter to
operate it. Garage door openers
manufactured before that date do
not have a safety feature that causes
them to stop and reverse if an obstacle is detected during closing,
increasing the risk of injury. If you
have questions, call (800) 355-3515.
Instrument s an d Control s

HomeLin
k Universa l Transmitte r

Trainin g th e Transmitte r
Before you can use the HomeLink
Universal Transmitter to operate
devices around your home, it must

"learn" the proper codes. For
example, to train the transmitter to
open and close the garage door:

1. This step erases all previously learned
codes. Perform this step before
training the transmitter for the very

first time. Press and hold the two
outside buttons until the red light
in the transmitter flashes (approximately 20 seconds).
Release the buttons.
2. Hold the end of the garage door opener remote control 1 to 3
inches from the HomeLink
transmitter. Make sure you are
not blocking your view of the red
light in the transmitter. 3. Select the transmitter button you
want to train.
4. Press the button on the remote control and the button on the
transmitter at the same time. Hold down both buttons. 5. The red light in the transmitter
should begin flashing. It will flash
slowly at first, then rapidly.
6. When the red light flashes rapidly, release both buttons. The
transmitter should have learned
the code from the remote control.
7. Test the transmitter button by pushing it. It should operate the
garage door.
8. Repeat these steps to train the other two transmitter buttons to
operate any other remotely-
controlled devices around your
home (lighting, automatic gate, security system, etc.).

CONTINUED

Instrument s an d Control s

HomeLin
k Universa l Transmitte r

Trainin g Wit h a Rollin g Cod e
Syste m

For security purposes, newer garage

door opening systems use a "rolling"

or variable code. If you know that
your garage door opener has a
rolling code, or you have been

unable to train the transmitter after
several attempts, use the following

procedure. You will need someone to

help you.

1. Make sure you have properlycompleted the "Training the
Transmitter" procedure.
2. Find the "Training" button on your garage door opener motor/control
unit. The location will vary,depending on the manufacturer.
The manufacturer's documentation may help. 3. Press the Training button on the
motor/control unit until the
Training light comes on, then release it.
4. Press and release the desired button on the HomeLink
transmitter.
5. Press and release the HomeLink transmitter button again. Thisshould turn off the training light
on the motor/control unit. (Some
systems may require you to press
and release the button three times.)
6. Press the transmitter button again. It should operate the garage door.
Instrument s an d Control s

TRAININ
G BUTTO N

GARAG E DOO R

OPENE R MOTOR /

CONTRO L UNI T

Sea
t Adjustments , Armres t

The head restraints adjust for height and tilt. You need both hands toadjust the restraint. Do not attempt
to adjust it while driving. To raise it,
pull upward. To lower the restraint,
push the release button sideways and push the restraint down. To
adjust the tilt, pivot the head
restraint to the desired position. To remove a head restraint for
cleaning or repair, pull it up as far as
it will go. Push the release button and pull the restraint out of the seat-
back.
The lid of the console compartmentcan be used as an armrest at the
high or low position. To raise the armrest, push the button on the lid.
Make sure the armrest is securely
latched. To lower it, press the button and push the armrest down until it
latches.
Make sure the passengers' hands or
fingers are away from the armrest
before pushing it down.
Instrument s an d Control s
RELEAS
E BUTTO N
Armres
t

Pus h

Armres
t

The rear seat armrest is located at the center of the rear seat. Pivot itdown to use it.
Trunk Pass-through Cover

The pass-through cover can be opened from either side; it folds
forward onto the center armrest. Open the cover by sliding the knob
downward and pushing or pulling on
the cover. To close the cover, swing it up and push firmly on the top.
Make sure it latches properly. Make sure all items in the trunk and
those extending through the pass-
through are secured.
For security, this cover can be
locked and unlocked only with themaster key. To lock the cover, insert
the key and turn it clockwise.
Never drive with this cover open and
the trunk lid open. See Carbo n Monoxid e Hazar d on
page 49.
Instrument s an d Control s

LI
D
KNO
B

Drivin
g Positio n Memor y Syste m

Your Acura has a memory feature for the steering wheel, driver's seatand outside mirror positions.
Two seat, steering wheel, and outside mirror positions, for
different drivers or driving
conditions, can be stored in separate
memories. You select a memorized
position by pushing the appropriate

button.
Storing a Driving Position in Memory
Store a driving position as explained
in this section only when the car is

parked.

1. Turn the ignition switch ON (II). You cannot add a new drivingposition in the memory unless the
ignition switch is ON (II). You can
recall a memorized position with
the ignition switch in any position.
2. Adjust the seat to a comfortable position (see page 93). Adjust
the steering wheel to acomfortable position (see page 71).

Adjust the outside mirrors for best

visibility (see page 98).
MEM
O BUTTO N
3. Press and release the MEMO button on the control panel. You
will hear a beep. Immediatelypress and hold one of the memory
buttons (1 or 2) until you hear two
beeps. The indicator light in the
memory button will come on. Thecurrent positions of the driver's

seat, steering wheel, and outside

mirrors are now stored.
Instrument s an d Control s

Sk
i Sleev e

2. Open the trunk. Remove the ski sleeve from its storage bag.
3. Attach the ski sleeve to the trunk
pass-through.

4. Load the skis into the ski sleeve from the trunk. Make sure the tipof the ski sleeve is resting on the
center console. 5. Use the strap on the ski sleeve to
secure it tightly to the rear seatarmrest. Follow these precautions when you
use the ski sleeve: Do not transport skis that are
longer or heavier than these limits: Maximum length: 84 in (215 cm)
Maximum weight: 55 Ibs (25 kg) After use, make sure the ski
sleeve is dry both inside and out
before folding it up for storage.
This will help to prevent mildew.
Instrument s an d Control s

Comfor
t an d Convenienc e Feature s

The climate control system in your

Acura provides a comfortable driving
environment in all weather condi-

tions.

The standard audio system has
many features. This section de-
scribes those features and how to

use them.

Your Acura has an anti-theft audio
system that requires a code number

to enable it.
The security system helps to dis-
courage vandalism and theft of your

Acura. Climate Control System................ 120

3.5 RL without Navigation System
Fully-automatic Operation........ 122
Semi-automatic Operation........ 123

3.5 RL with Navigation System
Fully-automatic Operation ........ 127
Semi-automatic Operation ........ 128
Rear Ventilation ......................... 132

Sunlight Sensor/ Temperature Sensor.............
133

Audio System ................................. 134

AM/FM/Cassette Stereo
Audio System......................... 134

3.5 RL without Navigation System
Operating the Radio.................. 135
Adjusting the Sound.................. 138
Audio System Lighting............. 139 Operating the Cassette Player...................................... 139
Tape Search Functions............. 140 Operating the CD Changer...... 142
3.5 RL with Navigation System

Operating the Radio.................. 145
Adjusting the Sound.................. 148
Audio System Lighting............. 149 Radio Frequencies..................... 149
Radio Reception......................... 149Operating the Cassette
Player...................................... 151
Tape Search Functions............. 151 Caring for the Cassette Player...................................... 154
Operating the CD Changer...... 155
Loading the CD Changer ......... 157
Protecting Compact Discs........ 159 CD Changer Error Indications.............................. 160
Remote Audio Controls ............ 161
Theft Protection........................ 162
Security System............................. 163

Comfor t an d Convenienc e Feature s