3 - 52
CHK
ADJ
CHECKING THE TIRES
2. Check:
• tire surfaces
Damage/wear ® Replace the tire.
1Tire tread depth
2Side wall
3Wear indicator
WARNINGWARNING
• Do not use a tubeless tire on a wheel
designed only for tube tires to avoid
tire failure and personal injury from
sudden deflation.
• When using a tube tire, be sure to
install the correct tube.
• Always replace a new tube tire and a
new tube as a set.
• To avoid pinching the tube, make sure
that the wheel rim band and tube are
centered in the wheel groove.
• Patching a punctured tube is not rec-
ommended. If it is absolutely neces-
sary to do so, use great care and
replace the tube as soon as possible
with a good quality replacement.
Tire õWheel
• After extensive tests, the tires listed
below have been approved by
Yamaha Motor Co., Ltd. for this
model. The front and rear tires should
always be by the same manufacturer
and of the same design. No guarantee
concerning handling characteristics
can be given if a tire combination
other than one approved by Yamaha is
used on this motorcycle.
Minimum tire tread depth
1.6 mm (0.06 in)
Tube wheel Tube tire only
Tubeless wheelTube or tubeless
tire
Front tire
Manufacturer Size Model
PIRELLI120/70 ZR17
(58W)MTR01A
Rear tire
Manufacturer Size Model
PIRELLI180/55 ZR17
(73W)MTR08
õ
7 - 3
CHAS
FRONT WHEEL AND BRAKE DISCS
EB700102
REMOVING THE FRONT WHEEL
1. Stand the motorcycle on a level surface.
WARNINGWARNING
Securely support the motorcycle so that
there is no danger of it falling over.
NOTE:
Place the motorcycle on a suitable stand
so that the front wheel is elevated.
2. Remove:
• left brake caliper
• right brake caliper
NOTE:
Do not squeeze the brake lever when
removing the brake calipers.
3. Elevate:
• front wheel
NOTE:
Place the motorcycle on a suitable stand
so that the front wheel is elevated.
EB700400
CHECKING THE FRONT WHEEL
1. Check:
• wheel axle
Roll the wheel axle on a flat surface.
Bends
®
Replace.
WARNINGWARNING
Do not attempt to straighten a bent
wheel axle.
2. Check:
• tire
• front wheel
Damage/wear
®
Replace.
Refer to “CHECKING THE TIRES” and
“CHECKING THE WHEELS” in chapter 3.
