1999 TOYOTA AVALON Owners Manual

’99 AVALON (USA/CANADA)−U
217
Type A fuses can be pulled out by the
pull −out tool. The location of the pull −out
tool is shown in the illustration.
If you are not sure whether the fuse has
blown, try replacing the suspected fuse
with one that you know is good.
If the fuse has blown, push a new fuse
into the clip.
Only install a fuse with the amperage rat-
ing designated on the fuse box lid.
If you do not have a spare fuse, in an
emergency you can pull out the ”TEL”,
”RAD NO.1” or ”A.C” fuse, which may be
dispensable for normal driving, and use it
if its amperage rating is the same.
If you cannot use one of the same amper-
age, use one that is lower, but as close
as possible to the rating. If the amperage
is lower than that specified, the fuse
might blow out again but this does not
indicate anything wrong. Be sure to get
the correct fuse as soon as possible and
return the substitute to its original clip.
It is a good idea to purchase a set of
spare fuses and keep them in your ve-
hicle for emergencies. If the new fuse immediately blows out,
there is a problem with the electrical sys-
tem. Have your Toyota dealer correct it as
soon as possible.
CAUTION
Never use a fuse with a higher am-
perage rating, or any other object, in
place of a fuse. This may cause ex-
tensive damage and possibly a fire.
Adding washer fluid
If any washer does not work, the wash-
er tank may be empty. Add washer
fluid.
You may use plain water as washer fluid.
However, in cold areas where tempera-
tures range below freezing point, use
washer fluid containing antifreeze. This
product is available at your Toyota dealer
and most auto parts stores. Follow the
manufacturer ’s directions for how much to
mix with water.
NOTICE
Do not use engine antifreeze or any
other substitute because it may dam-
age your vehicle’s paint.
ProCarManuals.com

’99 AVALON (USA/CANADA)−U
218
Replacing light bulbs—
The following illustrations show how to
gain access to the bulbs. When replacing
a bulb, make sure the ignition switch and
light switch are off. Use bulbs with the
wattage ratings given in the table.
CAUTION
Halogen bulbs have pressurized gas
inside and require special handling.
They can burst or shatter if scratched
or dropped. Hold a bulb only by its
plastic or metal case. Do not touch
the glass part of a bulb with bare
hands.
NOTICE
Only use a bulb of the listed type.
Light bulbsBulb
No.WTy p e
Headlights
(low beam)900651A
Headlights
(high beam)900560B
Front fog lights—55C
Parking and front
turn signal lights3157 NA27/8E
Rear turn signal
lights744021E
Stop and tail lights744321/5E
Rear side marker
lights1683.8E
Back −up lights92118E
License plate lights1685E
High mounted
stoplight92118E
Interior light—8F
Front personal
lights—8D
Rear personal
lights—8D
Glove box light—1.2E
Door courtesy
lights1945E
Trunk light—3F
A: HB4 halogen bulbs
B: HB3 halogen bulbs
C: H3 halogen bulbs
D: Single end bulbs
E: Wedge base bulbs
F: Double end bulbs
ProCarManuals.com

’99 AVALON (USA/CANADA)−U
219
—Headlights
1. Unplug the connector while depress-
ing the lock release.
If the connector is tight, wiggle it.2. Turn the bulb and remove it.3. Install a new bulb and the connector into the mounting hole.
Aiming is not necessary after replacing
the bulb. When aiming adjustment is nec-
essary, contact your Toyota dealer.
ProCarManuals.com

’99 AVALON (USA/CANADA)−U
220
—Front fog lights
1. Remove the bolts and clips, take out
the engine under cover.
Remove and install the cover clips as shown
in the following illustrations.
Removing cover clips
Installing cover clips
2. Turn the cover counterclockwise andremove it.
ProCarManuals.com

’99 AVALON (USA/CANADA)−U
221
3. Disconnect the cords.4. Release the bulb retaining spring
and remove the bulb. Install a new
bulb and the bulb retaining spring.
To install the bulb, align the cutouts of the
bulb with the protrusions of the mounting
hole.
5. Connect the cords and install thecover by turning it clockwise.
Install the engine under cover securely.
ProCarManuals.com

’99 AVALON (USA/CANADA)−U
222
Use a Phillips −head screwdriver.
—Parking and front turn
signal lights —Rear turn signal, stop and
tail, and rear side maker
lights
ProCarManuals.com

’99 AVALON (USA/CANADA)−U
223
a: Rear turn signal light
b: Stop and tail light
c: Rear side maker lightRemove and install the cover clips as
shown in the following illustrations.Removing cover clips
Installing cover clips
—Stop and tail, and back −up
lights
ProCarManuals.com

’99 AVALON (USA/CANADA)−U
224
a: Stop and tail light
b: Back− up light
—License plate lights
Remove and install the cover clips as
shown in the following illustrations.Removing cover clips
Installing cover clips
ProCarManuals.com