3) Conduct appearance inspection on parts
selected.
NOTE:
Also check connector terminals, wiring harness,
case, etc. for damage.
:Is there anything unusual about the
appearance of airbag component
parts?
: Replace faulty airbag component parts.
: Go to step5X2.
5X2 : AIRBAG COMPONENT PARTS
VIBRATION INSPECTION
1) Gently shake check parts (to determine faults.).
2) To check airbag module or roll connector, turn
and tilt steering wheel.
CAUTION:
Do not shake or vibrate airbag control module.
:Does the component malfunction
again when shaking?
: Replace faulty airbag component parts.
: Go to step5X3.
5X3 : SHOWERING INSPECTION TO BODY
Spray water on vehicle body.
CAUTION:
Do not directly spray water on airbag compo-
nents.
NOTE:
Also check wiring harnesses as water may leak
along them and get airbag component parts wet.
G5M0461
:Does water leak into the passenger
compartment when showering
vehicle?
: Replace faulty airbag component parts.
: Perform clear memory.
[T4C0].>
Y: WARNING LIGHT INDICATES
TROUBLE CODE, THEN NORMAL
CODE. (FLASHING NORMAL CODE.)
DIAGNOSIS:
IAirbag connector is faulty.
IFuse No. 11 (in joint box) is blown.
IAirbag main harness is faulty.
IAirbag control module is faulty.
IBody harness is faulty.
CAUTION:
Before performing diagnostics on airbag
system, turn ignition switch ªOFFº, disconnect
battery ground cable, and then wait at least 20
seconds.
5Y1 : AIRBAG CONNECTOR APPEARANCE
INSPECTION
Conduct appearance inspection on airbag connec-
tors (AB1) through (AB28).
NOTE:
Check terminals, case and wiring harnesses for
damage.
:Is there anything unusual about the
appearance of connectors (AB1)
through (AB28)?
: Replace faulty airbag component parts.
: Go to step5Y2.
5Y2 : AIRBAG CONNECTOR VIBRATION
INSPECTION
Conduct vibration inspection on airbag connectors
(AB1) through (AB28).
NOTE:
Gently shake each airbag connector.
:Do the connectors (AB1) through
(AB28) malfunction again when shak-
ing?
: Replace faulty airbag component parts.
: Go to step5Y3.
61
[T5Y2]5-5DIAGNOSTICS
5. Diagnostics Chart with Trouble Code
5Y3 : SHOWERING INSPECTION TO BODY
Spray water on vehicle body.
CAUTION:
Do not directly spray water on airbag compo-
nents.
NOTE:
If leaks are noted, also check wiring harnesses as
water may leak along them and wet airbag connec-
tors.
G5M0461
:Does water leak into the passenger
compartment when showering
vehicle?
: Replace faulty airbag component parts.
: Go to step5Y4.
5Y4 : FUSE NO. 11 (IN JOINT BOX), AIR-
BAG MAIN HARNESS, AIRBAG CON-
TROL MODULE, BODY HARNESS
APPEARANCE INSPECTION
Conduct appearance inspection on fuse No. 11
, airbag main harness
5-5 [W4A0].>, airbag control module
[W6A0].> and body harness.
NOTE:
Also check connectors, terminals, wiring harness
and case for damage.
:Is there anything unusual about the
appearance of fuse No. 11, airbag
main harness, airbag control module
or body harness?
: Replace faulty airbag component parts.
: Go to step5Y5.5Y5 : FUSE NO. 11 (IN JOINT BOX), AIR-
BAG MAIN HARNESS, BODY HAR-
NESS VIBRATION INSPECTION
Conduct vibration inspection on fuse No. 11, airbag
main harness and body harness.
CAUTION:
Do not shake or vibrate airbag control module.
NOTE:
Gently shake each part.
:Do fuse No. 11, airbag main harness
or body harness malfunction again
when shaking?
: Replace faulty airbag component parts.
: Go to step5Y6.
5Y6 : SHOWERING INSPECTION TO BODY
Spray water on vehicle body.
CAUTION:
Do not directly spray water on each part.
NOTE:
If leaks are noted, check wiring harnesses as water
may leak along them and get parts wet.
G5M0461
:Does water leak into the passenger
compartment when showering
vehicle?
: Replace faulty airbag component parts.
: Go to step5Y7.
62
5-5[T5Y3]DIAGNOSTICS
5. Diagnostics Chart with Trouble Code
