1999 MITSUBISHI LANCER EVOLUTION VI fuel pump

FUEL SUPPLY – General / Fuel Tank13-69
FUEL SUPPLY
GENERAL
OUTLINE OF CHANGE
The service procedures have been revised as shown below because of change in the fuel pump & gauge
assembly and the fuel gauge unit.
FUEL TANK
REMOVAL AND INSTALLATION
4
32 1
65
7
11
Removal steps
1. Fuel hose
2. Fuel pump & gauge assembly
3. Packing
A4. High-pressure fuel hose5. Fuel pipe assembly
6. Fuel gauge unit
7. Packing
NOTE
The service procedures other than those mentioned above
remain unchanged.
INSTALLATION SERVICE POINT
AHIGH-PRESSURE FUEL HOSE INSTALLATION
Caution
After connecting the quick-release joint of the
high-pressure fuel hose, pull it gently in the direction
of removal to check that the hose is firmly connected
with a play of about 3 mm.

– Engine Compartment WIRING HARNESS
CONFIGURATION DIAGRAMSC-7
A-94 (4-GR) Radiator fan motor
A-96 (2-GR) Knock sensor
A-97 (3-B) Camshaft position sensor
A-99 (2-B) Condenser fan motor
A-101 (1) Power steering oil pressure switch
A-102 (1) Spare connector for fog lamp
A-103 (2-B) Fog lamp (RH)
A-104 (2) Position lamp (RH)
A-105 (3-B) Headlamp (RH)
A-106 (1-B) A/C compressor assembly
A-107 (2-BR) Front turn signal lamp (RH)
A-110 (3-GR) Ignition coil 1
A-111 (3-GR) Ignition coil 2A-112X (4) Radiator fan relay (HI)
A-113X (4) Condenser fan relay (LO)
A-114X (4) Condenser fan relay (HI)
A-116X (4) A/C compressor relay
A-117 (2-GR) Side turn signal lamp (RH)
A-123 (5-B) Fuel pump relay No.2
A-124 (2-B) Fuel pump resistor
A-125 (6-B) Resistor (for injector)
A-126 (5-B) AYC relay
A-127 (2-B) Secondary air control solenoid valve
A-128 (2-GR) Condenser fan motor
A-129 (2-B) Water spray motor
A-131 (1-B) Noise condenser

– Dash Panel WIRING HARNESS
CONFIGURATION DIAGRAMS
Interior relay box
C-9
B-21 (2) Stop lamp switch
B-22 (16-B) Diagnosis connector
B-24 (26-Y) ABS-ECU
B-25 (22-Y) ABS-ECU
B-26 (2-B) Diode (for ABS circuit)
B-27 (4) Engine control relay
B-28 (4) Fuel pump relay
B-30 (14) Radio or spare connector for radio
B-31 (1) Glass antenna amplifier
B-32 (19-B) J/C (5)
B-33 (2) Blower motor matic air conditioner>B-34 (4) Blower high speed relay fully automatic air conditioner>
B-35 (22) Body harness and front door harness
(passenger’s side) combination
B-36 (2) Inside and outside air change-over
damper motor automatic air conditioner>
B-37 (4) Power transistor automatic air conditioner> or resistor
conditioner>

SINGLE PART INSTALLATION POSITION – Relay
B
Fuel pump relay No.2
AYC relay
C
Radiator fan
motor relay (LO)
C-16
SINGLE PART INSTALLATION POSITION
RELAY
NameSymbolNameSymbol
AYC relayBFuel pump relay No.2B
Condenser fan motor relay (HI)ARadiator fan motor relay (HI)A
Condenser fan motor relay (LO)ARadiator fan motor relay (LO)C
A
Condenser fan motor
relay (LO)Condenser fan motor
relay (HI)
Radiator fan motor
relay (HI)

Inspection Connector / Fusible Link and
Fuse SINGLE PART
INSTALLATION POSITION –C-20
INSPECTION CONNECTOR
Engine speed
check connector
Fuel pump
check connector
FUSIBLE LINK AND FUSE
(vehicles without ABS)>
Fusible link
(vehicles with ABS)>
Fusible link