1999 Mercury Sable oil dipstick

IDENTIFYING COMPONENTS IN THE ENGINE
COMPARTMENT
3.0L V6 Vulcan engine
1. Automatic transmission fluid dipstick
2. Brake fluid reservoir
3. Air filter assembly
4. Battery
5. Engine oil filler cap
6. Engine oil dipstick
7. Power steering fluid reservoir
8. Engine coolant reservoir
9. Windshield washer fluid reservoir
12
3
4567
8
9
Maintenance and care
137

3.0L V6 Duratec engine
1. Automatic transmission fluid dipstick
2. Brake fluid reservoir
3. Air filter assembly
4. Battery
5. Engine oil filler cap
6. Engine oil dipstick
7. Engine coolant reservoir
8. Windshield washer fluid reservoir
9. Power steering fluid reservoir
ENGINE OIL
Checking the engine oil
Refer to the Scheduled Maintenance Guide for the
appropriate intervals for checking the engine oil.
1. Make sure the vehicle is on level ground.
2. Turn the engine off and wait a few minutes for
the oil to drain into the oil pan.
8912
3
4
56
7
Maintenance and care
138

3. Set the parking brake and ensure the gearshift is
securely latched in P.
4. Open the hood. Protect yourself from engine heat.
5. Locate and carefully
remove the engine oil
indicator (dipstick).
6. Wipe the indicator clean. Insert the indicator fully,
then remove it again.
²If the oil level isbetween the ADD and FULL
marks or between the MIN and MAX marks
(depending on application),the oil level is
acceptable.DO NOT ADD OIL.
²If the oil level is
below the ADD or
MIN mark, add
enough oil to raise
the level within the
ADD-FULL or within
the MIN-MAX range.
²Oil levels above the F in FULL or above the MAX
mark, may cause engine damage. Some oil must
be removed from the engine by a service
technician.
7. Put the indicator back in and ensure it is fully
seated.
ADD 1 QTFULL
MAX MIN
Maintenance and care
139

Adding engine oil
1. Check the engine oil. For instructions, refer to
Checking the engine oilin this chapter.
2. If the engine oil level is not within the normal
range, add only certified engine oil of the
recommended viscosity. Remove the engine oil filler
cap and use a funnel to pour the engine oil into the
opening.
3. Recheck the engine oil level. Make sure the oil
level is not above the F in FULL mark on the
dipstick.
Engine oil and filter recommendations
Look for this
certification mark.
Ford oil specification is WSS-M2C153-G.
Use SAE 5W-30 motor oil certified for gasoline
engines by the American Petroleum Institute.
Do not use supplemental engine oil additives, oil
treatments or engine treatments. They are
unnecessary and could, under certain conditions,
lead to engine damage which is not covered by your
warranty.
Change your engine oil and filter according to the
appropriate schedule listed in the Scheduled
Maintenance Guide.
Ford production and aftermarket (Motorcraft) oil
filters are designed for added engine protection and
long life. If a replacement oil filter is used that does
not meet Ford material and design specifications,
startup engine noises or knock may be experienced.
Maintenance and care
140

REFILL CAPACITIES
Fluid Ford Part
NameAppli-
cationCapacity
Brake fluid High Per-
formance
DOT 3
Motor
Vehicle
Brake
FluidAll Fill to line on
reservoir
Engine
coolant
1Premium
Engine
Coolant3.0L V6
Vulcan
engine11.0L
(11.6 quarts)
3.0L V6
Duratec
engine10.0L
(10.6 quarts)
Engine oil
(includes
filter
change)Motorcraft
5W-30
Super
Premium
Motor Oil3.0 V6
Vulcan
engine4.25L
(4.5 quarts)
3.0L V6
Duratec
engine5.2L
(5.5 quarts)
Fuel tank
capacityN/A All
vehicles60.6L
(16.0 gallons)
Power
steering
fluidMotorcraft
MERCONt
AT F3.0L V6
Vulcan
engineKeep in FULL
range on
dipstick
3.0L V6
Duratec
engineFill to line on
reservoir
Capacities and specifications
181

Emission
control system ......... 166
Engine
coolant ................... 143
idle speed control . 149
service points . 137,138
starting after a
collision ................. 118
Engine block heater . 99
Engine oil
checking
and adding ............ 140
dipstick .................. 138
specifications . 138,140
Exhaust fumes .......... 99
Floor mats ................. 52
Fuel
choosing
the right fuel ......... 160
comparisons with
EPA fuel economy
estimates ............... 166
detergent in fuel ... 161
filling your vehicle
with fuel ......... 157,159
quality .................... 161
running out of fuel 162
safety information
relating to
automotive fuels ... 157
Fuses ................. 119,120
Gas mileage (see Fuel
economy) ................. 162
163,164,165
Gauges ....................... 12
engine coolant
temperature gauge . 14
fuel gauge ................ 15
odometer ................. 14
speedometer ........... 12
tachometer .............. 13
trip odometer .......... 14Hazard flashers ....... 118
Head restraints ......... 70
Headlamps
aiming ............. 173,174
bulb specifications. 172
high beam ............ 6,16
Heating ...................... 18
heating and air
conditioning
system ........... 18,19,21
Hood ........................ 136
Ignition ..................... 184
Inspection/maintenance
(I/M) testing ............ 168
Instrument panel ........ 6
cleaning ................. 178
Keyless entry system
autolock ................... 65
keypad ..................... 62
locking and
unlocking doors ...... 64
programming entry
code .................... 63,64
Keys
positions of the
ignition .................... 40
Lamps
autolamp system ..... 17
daytime
running light ........... 16
headlamps ............... 16
headlamps, flash to
pass .......................... 17
instrument panel,
dimming ................... 17
interior lamps .. 47,172
replacing
bulbs ........ 169,171,172
Lane change indicator
(see Turn signal) ...... 45
Liftgate ...................... 57
remote release ........ 53
Index
206

Item Information
Recommended fuel Unleaded fuel only ±
87 octane
Fuel tank capacity 60.6L (16 gallons)
Engine oil capacity
(including filter
change)-3.0L V6 Vulcan
engine4.25L (4.5 quarts) Use
Motorcraft 5W30 Super
Premium Motor Oil,
Ford specification
WSS-M2C153-G.
Engine oil capacity
(including filter
change)-3.0L V6
Duratec engine5.2L (5.5 quarts) Use
Motorcraft 5W30 Super
Premium Motor Oil,
Ford specification
WSS-M2C153-G.
Tire size and pressure Refer to Certification
Label. Inflate temporary
spare to 414 kPa
(60 psi).
Hood release Pull handle under the
left side of the
instrument panel.
Coolant capacity (3.0L
V6 Vulcan engine)
111.0L (11.6 quarts)
Coolant capacity (3.0L
V6 Duratec engine)
110.0L (10.6 quarts)
Power steering fluid
capacity-3.0L V6 Vulcan
engineKeep in FULL range on
dipstick.
Power steering fluid
capacity-3.0L V6
Duratec engineFill to line on reservoir.
Filling station information
215