Page 154 of 495
COMFORT ADJUSTMENT
138Adjust the m
irror so that you can just see the rear of
your vehicle in the mirror.
Pushing the switch changes the mode between
ºAUTOº and ºDAYº.
The indicator comes on when the ºAUTOº mode is
selected.
ºDAYº mode: The mirror surface is normal.
ºAUTOº mode: If the mirror detects light from the
headlights of the vehicle behind you, the mirror
surface darkens slightly to reduce the reflected
light.
When the inside rear view mirror surface changes, the
outside rear view mirror surfaces will also become
darker.
When the ignition key is inserted and turned on, the
inside rear view mirror always turns on in the ºAUTOº
mode. When the outside air temperature is low, it may take a
little longer for the mirror to darken in response to the
detection of headlights.
CAUTION
Do not adjust the mirror while the vehicle is moving. It
may cause the driver to mishandle the vehicle and an
accident may occur resulting in personal injuries.
Page 172 of 495
COMFORT ADJUSTMENT
156The indicator comes on when the ignition key is
turned to the ºACCº or ºONº position. It goes off
after about 6 seconds. This means the SRS is
operating properly.
The SRS warning light system monitors the airbag
sensor assemblies, inflators, seat belt pretensioners,
warning
light, interconnecting wiring and power sources.
(For details, see ºService reminder indicators and
warning buzzersº on page 62 for instructions.)
16L029
Page 219 of 495

COMFORT ADJUSTMENT
203
16L040±1
1Bolt 2Anchor bracket 3Spacer
4. Insert a 15 mm (0.6 in.) spacer, and tighten down the
anchor bracket for your child restraint system with a bolt.
Torque the bolt to 16.5 ± 24.7 N´m (1.68 ±2.52 kgf´m,
12.2 ± 18.2 ft´lbf.).
To comply with Canadian Motor Vehicle Safety
Standards, this model sold in Canada is provided with a
bracket set in the glove box, designed for use with any
of the 3 anchor locations shown in the illustration.
DRIVING POSITION MEMORY SYSTEM
The micro computer can memorize the position of the
driver's seat, the height of the shoulder belt anchor of the
driver's seat belt, and the positions of the tilt and
telescopic steering, and outside rear view mirrors. Two
different driving position profiles can be entered into the
computer's memory.
Recording a driving position in the computer's memory
can only be done when the ignition key is in the ºONº
position and the selector lever is in the ºPº position.
Setting a driving position
16L055
Page 222 of 495
COMFORT ADJUSTMENT
206Conditions for memorized position activation
Ignition key ºONº and selector lever in ºPº position.
All parts of the memorized positions can be activated.
However, if the brake pedal is being depressed, the
seat position will not change.
Key not in ignition switch and within 30 seconds of
opening driver's door.
The memorized position can be activated, except for
the tilt and telescopic steering.
If any driving position memory switch is pushed while
one of the memorized driving position profiles is being
activated, the operation will stop.
To activate the system, push the desired button (º1º or
º2º) again.
The driving position memory control system cannot be
operated while the vehicle is moving.
If the vehicle's battery is disconnected, the computer's
memory will be erased and the memorized positions will
have to be set again.
Page 225 of 495
THEFT DETERRENT
209
17L001
Setting the system
1. Turn the ignition key to the ºLOCKº position and
remove it.
2. Close and lock all the doors, trunk and hood
using an ignition key or wireless remote control.
Page 226 of 495

THEFT DETERRENT
210If you lock them with wireless remote control, the turn
signals flash once.* If you do not want to make them
flash, consult with your Lexus dealer.
NOTE: *The turn signals can be set not to flash. Ask
your Lexus dealer for details.
The indicator light will come on when all the doors, trunk
and hood are closed and locked.
3. After 30 seconds, the indicator flashes and the
system is set.
Cancelling the system
When you unlock any door or trunk using an ignition
key or wireless remote control, the system is
cancelled.
If you unlock any door or trunk with wireless remote
control, the turn signals flash twice.* If you do not want
to make them flash, consult with your Lexus dealer.
NOTE: *The turn signals can be set not to flash. Ask your Lexus dealer for details.
Activating the system
The alarm sounds for 60 seconds if any of the following
are operated:
Unlocking any door or trunk without using an ignition
key or wireless remote control.
Opening the hood forcibly.
Reconnecting the battery.
Page 227 of 495

THEFT DETERRENT
211
If any door is unlocked and the ignition key is not in the
ignition switch during the alarm sounding, its door is
automatically locked.
To stop the alarm:
Use either of the following methods.
Unlock the door or trunk using an ignition key or
wireless remote control.
Turn the ignition switch on.
Testing the system
1. Open all the windows.
2. Set the system as described above.
The front doors should be locked with the ignition key or
wireless remote control. Be sure to wait until the
indicator light starts flashing.
3. Unlock one of the doors from the inside.
The system should activate the alarm.
4. Unlock any of the doors with a key or the wireless
remote control to cancel the system.
5. Repeat this operation for the other doors and
hood.
When testing the hood, also check that the system is
activated when the battery terminal is disconnected and
then reconnected.
If the system does not work properly, have it checked by your Lexus dealer.
NOTICE
Disconnecting the battery may result in the
erasure of information you have set in thecomputer memory. After reconnecting thebattery, check that the memorized data has beenretained. If it has been erased, input it into thecomputer once more.
Page 231 of 495
AIR CONDITIONING AND AUDIO
215
AUTOMATIC AIR CONDITIONING CONTROLS
21L001a
The automatic air conditioning automatically
maintains the set temperature.
This air conditioning features automatic fan speed
and air flow control which automatically selects the
most suitable fan speed and air flow to control the
temperature. The ignition key must be in the ºONº
position.NOTICE
To prevent the battery from being discharged, do not leave the air conditioning on longer thannecessary when the engine is not running.