Page 320 of 495
STARTING AND DRIVING
304
31L016-2
The indicator light shows ºHIGHº mode is selected.
When you turn the ignition key to the ºONº position, the
indicator light will come on for 2 seconds in any mode.
NOTICE
For vehicles equipped with the height controlswitch, be sure to turn the ignition switch offbefore jacking. If this is not done, the vehicleheight adjustment function will operate, whichmay cause body damage.
(b) Malfunction warning
If the ºHIº indicator light blinks, there is a malfunction in
this system. Have the system checked by your Lexus
dealer at the first opportunity.
TRACTION CONTROL SYSTEM
The traction control system automatically helps
control the spinning of the rear wheels which may
occur when accelerating on slippery road surfaces,
thus assisting driver to control the driving power of
the rear wheels.
Page 334 of 495

STARTING AND DRIVING
318This light comes on when the ignition key is turned
to the ºONº position. After about a few seconds, the
light will go off.
If either of the following conditions occurs, this indicates
a malfunction somewhere in the parts monitored by the
warning light system. Contact your Lexus dealer as
soon as possible to service the vehicle.
The light does not come on as described above, or
remains on.
The light comes on while driving.
Even if the anti±lock brake system should fail, the brake
system will still operate conventionally. But when the
ºABSº warning light is on (and the brake system warning
light is off), anti±lock brake system is not assisting brake
performance so that the wheels could lock up during a
sudden brake or braking on slippery road surfaces.
Have your vehicle checked by your Lexus dealer as
soon as possible.
Drum±in±disc type parking brake system
Your vehicle has a drum±in±disc type parking brake
system. This type of brake system needs
bedding±down of the brake shoes periodically or
whenever the parking brake shoes and/or drums are
replaced.
Have your Lexus dealer perform the bedding±down.
Page 356 of 495
SECTION 4
340
IN CASE OF AN EMERGENCY
If your engine stalls while driving341
. . . . . . . . . . . . . . . .
If your vehicle will not start 342
. . . . . . . . . . . . . . . . . . . . .
If your vehicle overheats 347
. . . . . . . . . . . . . . . . . . . . . . .
If you have a flat tire 349
. . . . . . . . . . . . . . . . . . . . . . . . . . .
If your vehicle needs to be towed 366
. . . . . . . . . . . . . . .
If you cannot shift automatic transmission
selector lever 375
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
If you lose your keys or lock yourself out 377
. . . . . . . . .
Page 358 of 495

IN CASE OF AN EMERGENCY
342
IF YOUR VEHICLE WILL NOTSTART
(a) Simple checks
Before making these checks, make sure you have
followed the correct starting procedure instructions in
ºHow to start the engineº on page 280 and that you have
sufficient fuel. Since your vehicle is equipped with the
engine immobiliser system, also check whether the
other keys will start the engine. If they work, your key
may be broken. Have the key checked at your Lexus
dealer. If none of your keys work, the system is possibly
broken. Call your Lexus dealer. See ºKeysº on page 9.
If the engine is not turning over or is turning over too
slowly ±
1. Check that the battery terminals are tight and clean.
2. If the battery terminals are O.K., switch on the interior
light.
3. If the light is out, dim or goes out when the starter is
cranked, the battery is discharged. You may try jump
starting. See º(c) Jump startingº for further instruction.
If the light is O.K., but the engine still will not start, it
needs adjustment or repair. Call a Lexus dealer,
Roadside Assistance or Customer Service Assistance.
(See ºForewordº.)
NOTICE
Do not pull± or push±start the vehicle. It may damage the vehicle or cause a collision when theengine starts. Also the three±way catalyticconverter may overheat and become a fire hazard.
If the engine turns over at its normal speed but will
not start ±
1. The engine may be flooded because of repeated
cranking. See º(b) Starting a flooded engineº for further
instructions.
2. If the engine still will not start, it needs adjustment or
repair. Call a Lexus dealer, Roadside Assistance or
Customer Service Assistance. (See ºForewordº.)
Page 359 of 495
IN CASE OF AN EMERGENCY
343
(b) Starting a flooded engine
If the engine will not start, your engine may be
flooded because of repeated cranking.
If this happens, turn the key to ºSTARTº with the
accelerator pedal held down. Continue this operation for
30 seconds and then stop cranking. Then try starting the
engine with your foot off the accelerator pedal.
If the engine does not start after 30 seconds of cranking,
release the key, wait a few minutes and try again.
If the engine still will not start, it needs adjustment or
repair. Call a Lexus dealer, Roadside Assistance or
Customer Service Assistance. (See ºForewordº.)
NOTICE
Do not crank for more than 30 seconds at a time. This may overheat the starter and wiring systems.
Page 384 of 495
IN CASE OF AN EMERGENCY
368
40L022±1
Place the ignition key in the ºACCº position.
NOTICE
Do not tow with the key removed or in theºLOCKº position, as the steering lockmechanism is not strong enough to hold thefront wheels straight.
When lifting wheels, take care to ensureadequate ground clearance for towing at theopposite end of the raised vehicle. Otherwise,the bumper and/or underbody of the towedvehicle will be damaged during towing.
(b) Using a flat bed truck
Page 390 of 495
IN CASE OF AN EMERGENCY
374
CAUTION
Use extreme caution when towing the vehicle. Avoid
sudden starts or erratic driving maneuvers which would
place excessive stress on the emergency towing eyelet
and towing cable or chain. The eyelet and towing cable
or chain may break and cause serious injury or damage.
NOTICE
Use only a cable or chain specifically intended for use in towing vehicles. Securely fasten the cableor chain to the towing eyelet provided.
Before towing, release the parking brake and put the
transmission in ºNº. The ignition key must be in ºACCº
(engine off) or ºONº (engine running).
CAUTION
If the engine is not running, the power assist for the
brakes and steering will not work so steering and
braking will be much harder than usual.
Page 391 of 495
IN CASE OF AN EMERGENCY
375
IF YOU CANNOT SHIFT
AUTOMATIC TRANSMISSION SELECTOR LEVER
40L025-3
If you cannot shift the selector lever, use the shift
lock override button as follows:
1Turn the ignition key to ºLOCKº or ºACCº. Make
sure the parking brake is applied. Pry up the cover
with a flat±bladed screwdriver or equivalent.