Page 358 of 472
IN CASE OF AN EMERGENCY
338
(a) Towing with a wheel lift type truck
From front
40E018±2
Release the parking brake.
NOTICE
When lifting wheels, take care to ensure adequate
ground clearance for towing at the opposite end of the raised vehicle. Otherwise, the bumperand/or underbody of the towed vehicle will bedamaged during towing.
From rear
Page 359 of 472
IN CASE OF AN EMERGENCY
339
40E019±1
Use a towing dolly under the front wheels.
NOTICE
Never tow a vehicle with an automatictransmission from the rear with front wheels onthe ground, as this may cause serious damage tothe transmission.
(b) Using a flat bed truck
Page 362 of 472
IN CASE OF AN EMERGENCY
342
40E016
Rear emergency towing eyelets
NOTICE
Do not use the rear emergency towing eyelets.
Tie down angle
40E017
Page 363 of 472
IN CASE OF AN EMERGENCY
343
If you use chains or wires to tie down your vehicle,
the angles shaded black must be at 45
.
(c) Towing with a sling type truck
40E020±1
NOTICE
Do not tow with a sling type truck, either from the
front or rear. This may cause body damage.
(d) Emergency towing
40E021
Page 364 of 472
IN CASE OF AN EMERGENCY
344If towing is necessary, we recommend you to have
it done by your Lexus dealer or a commercial tow
truck service.
If towing service is not available in an emergency,
your
vehicle may be temporarily towed by a cable or
chain secured to the emergency towing eyelet. Use
extreme caution when towing the vehicle.
A driver must be in the vehicle to steer it and operate the
brakes.
Towing in this manner may be done only on
hard±surfaced roads for a short distance and at low
speeds. Also, the wheels, axles, drive train, steering
and brakes must all be in good condition.
Page 365 of 472
IN CASE OF AN EMERGENCY
345
CAUTION
Use extreme caution when towing the vehicle. Avoid
sudden starts or erratic driving maneuvers which would
place excessive stress on the emergency towing eyelet
and towing cable or chain. The eyelet and towing cable
or chain may break and cause serious injury or damage.
NOTICE
Use only a cable or chain specifically intended for use in towing vehicles. Securely fasten the cableor chain to the towing eyelet provided.
Before towing, release the parking brake and put the
transmission in ºNº. The ignition key must be in ºACCº
(engine off) or ºONº (engine running).
CAUTION
If the engine is not running, the power assist for the
brakes and steering will not work so steering and
braking will be much harder than usual.
Page 385 of 472

INTRODUCTION
365
NOTICE
Remember that battery and ignition cablescarry high currents or voltages. Be careful ofaccidentally causing a short circuit.
Before closing the engine hood, check to seethat you have not forgotten any tools, rags, etc.
Do not drive with the air cleaner removed, or
excessive engine wear could result. Alsobackfiring could cause a fire in the enginecompartment.
Do not overfill automatic transmission fluid, orthe transmission could be damaged.
Be careful not to scratch the glass surface withthe wiper frame.
PARTS AND TOOLS
Here is a list of parts and tools you will need to perform
do±it±yourself maintenance. Remember all Lexus parts
are designed in metric sizes, so your tools must be
metric.
Checking the engine oil level
Parts (if level is low):
Use API grade SJ, ºEnergy±Conservingº multigrade
engine oil or ILSAC multigrade engine oil. For
recommended oil viscosity, see page 382.
Tools:
Rag or paper towel
Funnel (only for adding oil)
Checking the engine coolant level
Parts (if level is low):
ªToyota Long Life Coolantº or equivalent
See ºChecking the engine coolant levelº on page 383
for instructions.
Demineralized or distilled water
Tools:
Funnel (only for adding coolant)
Page 386 of 472
INTRODUCTION
366
Checking brake fluid
Parts (if level is low):
FMVSS No. 116 DOT 3 or SAE J1703 brake fluid
Tools:
Funnel (only for adding fluid)
Checking power steering fluid
Parts (if level is low):
Automatic transmission fluid DEXRON
II or III
Tools:
Rag or paper towel
Funnel (only for adding fluid)
Checking battery condition
Non±maintenance batteries
Tools:
Warm water
Baking soda
Grease
Conventional wrench (for terminal clamp bolts)
Maintenance type batteries
Parts (if level is low):
Distilled water
Tools:
Warm water
Baking soda
Grease
Conventional wrench (for terminal clamp bolts)
Coin (for vent plugs)
Funnel (only for adding distilled water)