1999 LAND ROVER DEFENDER washer

84WIPERS AND WASHERS
2
REPAIR
4.Remove 4 trim studs securing upper rear finisher
to body.
5.Release and remove upper rear finisher.
6.Position drain tin to collect any fluid spillage.
7.Disconnect washer tube from jet.
8.Remove nut securing washer jet to body.
9.Remove washer jet.
Refit
10.Fit washer jet to body and secure with nut.
11.Connect washer tube to jet.
12.Remove drain tin.
13.Fit upper rear finisher and secure with trim studs.
14.Fit both rear grab handles and secure with
screws.
15.Fit both rear side window finishers.ARM - WIPER - FROM 02MY
Service repair no - 84.15.02
Remove
1.Raise nut cover on wiper arm and remove nut.
2.Remove wiper arm from spindle.
NOTE: Do not carry out further
dismantling if component is removed for
access only.
3.Remove wiper blade.
Refit
4.Fit wiper blade.
5.Fit wiper arm to spindle and align blade to
windscreen.
6.Tighten nut securing wiper arm to17 Nm (13
lbf.ft),and fit cover.
ProCarManuals.com

WIPERS AND WASHERS
3
REPAIR WIPER MOTOR AND DRIVE RACK - FROM 02MY
Service repair no - 84.15.09
Remove
1.Disconnect battery negative lead.See
ELECTRICAL, Repair.
2.Remove wiper arms.See this Section.
3.Remove fascia console.See CHASSIS AND
BODY, Repair.
4.Remove air vent control knobs.
5.Remove 6 screws, remove fascia closing panel
and collect nut plate.
6.Move cover aside and loosen wiper motor drive
tube nut.
7.Remove 2 screws securing wiper motor, remove
retaining strap and mounting pad.
8.Disconnect multiplug from wiper motor.
9.Remove tube nut and remove wiper motor with
rack.
Refit
10.Lubricate wiper motor drive rack with grease.
11.Feed wiper motor rack into tube, connect
multiplug and fit but do not tighten tube nut.
12.Fit mounting pad and retaining strap, align wiper
motor and tighten screws.
13.Tighten wiper motor tube nut to8 Nm (6 lbf.ft)
and reposition nut cover.
14.Fit fascia closing panel.
ProCarManuals.com

84WIPERS AND WASHERS
4
REPAIR 15.Fit nut plate and fit screws to secure nut plate
and closing panel.
16.Fit knobs to air vent control levers.
17.Fit fascia console.See CHASSIS AND BODY,
Repair.
18.Fit wiper arms.See this Section.
19.Connect battery negative lead.See
ELECTRICAL, Repair.WHEELBOX/DRIVE PIVOT - FROM 02MY
Service repair no - 84.15.25
Remove
1.Disconnect battery negative lead.See
ELECTRICAL, Repair.
2.Remove steering column nacelle.See
STEERING, Repair.
3.Remove wiper motor and drive rack.See this
Section.
4.Remove 2 screws and move heater fan switch
aside.
5.Remove 2 screws securing drivers side demister
duct.
6.Disconnect demister tube and remove duct.
7.Remove bolt and nut and bolt securing steering
column support bracket and remove bracket.
8.Remove 11 screws securing fascia support rail.
ProCarManuals.com

WIPERS AND WASHERS
5
REPAIR
9.Remove cable ties securing washer tube to
windscreen wiper rack tube.
10.Loosen fully 4 nuts securing backplates to wheel
boxes and remove windscreen wiper rack tubes.
11.Remove seals from wheel box spindles.
12.Remove 2 nuts securing wheel boxes and
remove sealing washers.
13.Carefully pull fascia support rail from bulkhead
sufficiently to remove wheel boxes.
Refit
14.Loosen fully but do not remove nuts securing
wheel box back plates.
15.Grease wheel boxes.
16.Fit wheel boxes, fit sealing washers and tighten
nuts to5 Nm (3.7 lbf.ft).
17.Fit spindle seals.
18.Fit wiper rack tubes and tighten wheel box back
plate nuts sufficiently to hold tubes. Tighten
wheel box back plate nuts to6 Nm (4 lbf.ft)
after fitting windscreen wiper motor.
19.Align washer tube to rack tube and secure with
cable ties.
20.Align fascia support rail and secure with screws.
21.Fit steering column support bracket and tighten
bolt and nut and bolt to45 Nm (33 lbf.ft).
22.Fit demister duct to tube, align relay bracket and
secure duct with screws.
23.Position heater fan switch and secure with
screws.
24.Fit wiper motor and drive rack.See this
Section.
25.Fit steering column nacelle.See STEERING,
Repair.
26.Connect battery negative lead.See
ELECTRICAL, Repair.RELAY - WIPER DELAY - FROM 02MY
Service repair no - 84.15.37
Remove
1.Disconnect battery negative lead.See
ELECTRICAL, Repair.
2.Remove 4 screws securing instrument pack and
release pack from fascia.
3.Disconnect 2 multiplugs from warning lamp
panel.
4.Disconnect instrument pack multiplug from main
harness.
5.Remove instrument pack.
ProCarManuals.com

84WIPERS AND WASHERS
6
REPAIR
6.Identify and remove relay.
Refit
7.Fit relay.
8.Position instrument pack and connect multiplugs.
9.Fit instrument pack to fascia and secure with
screws.
10.Connect battery negative lead.See
ELECTRICAL, Repair.MOTOR - WIPER - TAIL DOOR - FROM 02MY
Service repair no - 84.35.12
Remove
1.Remove spare wheel from tail door.
2.Raise nut cover, remove nut and release wiper
arm.
3.Remove nut and collect washer securing wiper
motor to tail door.
4.Open tail door.
5.Remove tail door trim casing.See CHASSIS
AND BODY, Repair.
6.Remove bolt securing door locking solenoid to
tail door.
7.Pivot both assemblies and withdraw wiper motor
from tail door.
8.Disconnect multiplugs from wiper motor.
9.Remove wiper motor assembly.
ProCarManuals.com

WIPERS AND WASHERS
7
REPAIR
NOTE: Do not carry out further
dismantling if component is removed for
access only.
10.Remove 2 bolts securing wiper motor to
mounting bracket, remove bracket.
Refit
11.Fit mounting bracket to motor and tighten bolts
to10 Nm (7 lbf.ft).
12.Fit motor spindle to rear door, connect multiplugs
and push motor fully home. Align motor
mounting bracket with solenoid mounting
bracket, fit bolt and tighten to10 Nm ( 7 lbf.ft ).
13.Fit rear door trim casing.See CHASSIS AND
BODY, Repair.
14.Fit washer and nut to rear wiper assembly,
tighten nut to3 Nm (2.2 lbf.ft).
15.Fit wiper arm to spindle, align blade to glass and
tighten nut to17 Nm (13 lbf.ft).
16.Close nut cover.
17.Fit spare wheel and tighten nuts to45 Nm (33
lbf.ft).RELAY - TAIL DOOR WIPER - FROM 02MY
Service repair no - 84.35.38
Remove
1.Remove tail door trim casing.See CHASSIS
AND BODY, Repair.
2.Remove rear wiper motor relay.
Refit
3.Fit relay.
4.Fit tail door trim casing.See CHASSIS AND
BODY, Repair.
ProCarManuals.com

84WIPERS AND WASHERS
8
REPAIR
ProCarManuals.com

86ELECTRICAL
18
DESCRIPTION AND OPERATION FASCIA CONSOLE
1.Rear fog lamp switch
2.Rear wiper switch
3.Heated front screen switch (if fitted)
4.Hazard warning lamp switch
5.Heated rear window switch
6.Rear washer switch
7.Front fog lamps switch (if fitted)8.RH front window switch
9.RH heated front seat switch (if fitted)
10.Headlamp levelling control switch
11.Cigar lighter (if fitted)
12.LH heated front seat switch (if fitted)
13.LH front window switch
ProCarManuals.com