1999 GMC C-SERIES instrument panel

yellowblue
2-67 Daytime Running Lamps (DRL)
Indicator Light
This light is located on the
upper cluster portion of the
instrument panel. It goes on
whenever the Daytime
Running Lamps are on. See
ªDaytime Running Lampsº
in the Index.
When it begins to get dark, the DRL indicator light is a
reminder to turn on your headlamps.
Check Gages Indicator Light (If Equipped)
This light will come on as
you're starting the engine,
just as a check.
If it ever comes on and stays on while you are driving,
however, it means that either your engine coolant
temperature gage or your engine oil pressure gage may
be showing a reading in the warning zone.
When the CHECK GAGES light comes on, you will
also hear a warning tone. The tone and the light will stay
activated until the problem is corrected.
This light may also come on if your vehicle is equipped
with the optional automatic engine shutdown system and
engine shutdown has begun. See ªEngine Automatic
Shutdownº in the Index.
ProCarManuals.com

yellowblue
2-69 Transmission Temperature Gage
(If Equipped)
If you have an automatic
transmission and this gage,
it is to the right of the dash
mounted shift lever, just to
the right of your
floor
-mounted shift lever or
on the lower portion of the
instrument panel to the right
of the steering wheel.
When your ignition is on, the gage shows the
temperature of the transmission oil. A reading in the
warning zone means you must stop driving and check
into the cause. One possible cause is a low oil level in
the transmission.
NOTICE:
If you drive when the transmission temperature
gage is in the warning zone, you can badly
damage the transmission.
Air Pressure Gage (If Equipped)
If your vehicle has air
brakes, this gage at the
center of your instrument
cluster shows the air
pressure for both your front
and rear brake systems.
If the needle on the gage indicates that the air pressure is
below 60 psi (415 kPa), the LOW AIR warning light
will come on. An alarm will also sound if this happens.
The yellow pointer shows the pressure available for the
front system, while the green pointer shows pressure for
the rear. There should be no more than 4 psi (28 kPa)
difference showing between the systems.
Don't drive until both pointers are showing at least
120 psi (830 kPa), so you'll have enough air if you need
to apply your brakes.
ProCarManuals.com

yellowblue
2-70 Filterminder Gage (Diesel Engine)
This optional gage is in the
lower center of the
instrument panel. It
monitors the engine
air filter.
As the filter gets dirty, the yellow indicator will begin to
rise. When it reaches 25 inches of vacuum on the scale,
the filter should be replaced.
After replacing the filter, reset the gage by pressing in
the yellow reset pin at the bottom of the gage.
If you have a diesel engine, also see your Caterpillar


Operation & Maintenance Manual.
Hourmeter Gage (If Equipped)
If your vehicle has this
gage, it will be to the lower
left of the steering column,
mounted on a bracket either
above or below the fuse
block. It shows the total
engine operating time.
ProCarManuals.com

yellowblue
3-2
Comfort Controls
Standard Comfort Controls
If your vehicle does not have air conditioning, this is
what your comfort controls will look like.
Function Lever
The top lever can be moved to three different heating
functions. If you place the lever between positions, it
will send air out both vents.
VENT: The air comes out at the vents on your
instrument panel and at your front side windows.
HEATER: Heated air comes out near the floor.
This is the best setting for cold weather.
DEFOG: This setting operates the defogger.
Heated air comes out near the windshield. Use this when
fog or ice is on the windshield.
Temperature Lever
The bottom lever lets you select the temperature of the
air flowing into your vehicle. Move the lever to the plus
symbol for warmer air. Move the lever to the minus
symbol for cooler air.
If your engine is equipped with an engine coolant heater,
you can use it during initial start
-up in cold weather
(20
F (
-8
C) or lower) to help heat the passenger
compartment faster. See ªEngine Coolant Heaterº in
the Index.
Fan Knob
The fan knob has four positions. To increase airflow,
turn the knob toward the plus symbol. To decrease
airflow, turn it toward the minus symbol.
ProCarManuals.com

yellowblue
3-4
Left Blend Button
The airflow can be blended between the two positions.
To blend between the positions, press the side of the
button showing the area where you would like more
airflow. The system will automatically begin to blend
toward the position chosen. To stop the system between
positions, just press the same side of the button again.
VENT: Press the top of the button and all of the
airflow will come through the instrument panel vents.
HEATER: Press the bottom of this button and all
of the airflow will come through the floor outlet.
Right Blend Button
The airflow can be blended between the two positions.
To blend between positions, press the side of the button
showing the area where you would like more airflow.
The system will automatically begin to blend toward the
position chosen. To stop the system between positions,
just press the same side of the button again.
DEFOG: This setting operates the defogger. Air
comes out near the bottom of the windshield and at your
front side windows.
HEATER: Press the bottom of this button and
heated air comes out near the floor.A/C Button
Press the A/C button to turn your air conditioner on and
off. The A/C symbol will light on your display, and air
will come out of your instrument panel vents. The fan
will automatically be set on LOW.
MAX Button
If you press the MAX button, the air in your vehicle will
be recirculated. With the air conditioner on, MAX will
give you maximum cooling. It can also be used in all
modes to help keep dust out of your vehicle. When
MAX is selected, REC will light on the display.
Fan Control Button
This button is in the upper passenger's side corner of
your system control panel. The fan has four settings:
low, medium low, medium high and high. Press the top
of the button with the plus symbol to increase airflow.
Press the bottom of the button with the minus symbol to
decrease airflow. The setting you select is shown on
your display as LOW, MED, HI or OFF.
ProCarManuals.com

yellowblue
3-6 Defogging
Use DEFOG, along with the HEATER setting, when
there is fog or ice on the windshield. This will direct
airflow toward the windshield and front side windows.
Set the temperature selector toward H and the fan
control at a comfortable level. When the windshield is
clear, use the temperature selector bar and the fan
control button to maintain a comfortable
temperature level.
Ventilation System
Air comes into your vehicle in one of two ways: power air
or ram air. Power air means bringing outside air into the
cab through the air intake, using the blower fan. Fresh air
can be drawn in when the vehicle is stationary or moving
at low speed. Air comes in through four vents in the
instrument panel and is exhausted through the vents and
pressure relief valves in the doors and door pillars. Power
ventilation means an increased supply of fresh air is
brought into the cab interior without having to open the
windows, especially during inclement weather.
Ram air is forced into the cab through the air intake in
the cowl by the vehicle's forward motion. This air is
controlled by two vent air handles under the instrument
panel. Air is directed through the ventilation ducts to the
floor. Ram air provides good airflow into the cab at
normal road speeds.
ProCarManuals.com

yellowblue
3-7
Ventilation Tips

Keep the hood and front air inlet free of ice, snow or
any other obstruction (such as leaves). The heater
and defogger will work far better, reducing the
chance of fogging the inside of your windows.

When you enter a vehicle in cold weather, turn the
blower fan to high for a few moments before driving
off. This helps clear the intake ducts of snow and
moisture and reduces the chance of fogging the
inside of your windows.

Keep the air path under the seats clear of objects.
This helps air to circulate throughout your vehicle.
The air vents are located in the center and on the sides of
your instrument panel. You can move the vents to direct
the flow of air or close the vents altogether. When you
close a vent, it will increase the flow of air coming out
of any vents that are open.
If your vehicle does not have air conditioning, there are
air vent controls located below the instrument panel.Audio Systems
Your Delco Electronics audio system has been designed
to operate easily and give years of listening pleasure.
You will get the most enjoyment out of it if you acquaint
yourself with it first. Find out what your Delco
Electronics system can do and how to operate all its
controls, to be sure you're getting the most out of the
advanced engineering that went into it.
Setting the Clock
While pressing the SET button, press the UP button
until the correct hour appears on the display and the
DOWN button until the correct minute appears on the
display. If you press and hold the UP/DOWN button,
hours or minutes will advance rapidly.
ProCarManuals.com

yellowblue
4-7
Avoid needless heavy braking. Some people drive in
spurts
-- heavy acceleration followed by heavy
braking
-- rather than keeping pace with traffic. This
is a mistake. Your brakes may not have time to cool
between hard stops. Your brakes will wear out much
faster if you do a lot of heavy braking. If you keep pace
with the traffic and allow realistic following distances,
you will eliminate a lot of unnecessary braking. That
means better braking and longer brake life.
If your engine ever stops while you're driving, brake
normally but don't pump your brakes. If you do, the
pedal may get harder to push down. If your engine
stops, you will still have some power brake assist. But
you will use it when you brake. Once the power assist is
used up, it may take longer to stop and the brake pedal
will be harder to push.
Hydraulic Brake Systems
If your engine stops running, or if your primary brake
system stops working, your vehicle has a reserve power
assist system to help you slow down. Just slowly and
steadily apply the brake pedal until you can safely get
off the road. The pedal will seem harder to push down.
Don't pump the pedal; the system won't work well or at
all that way.You may find that the steering wheel seems hard to turn
when you're turning and braking at the same time. Also,
the PRIMARY BRAKE warning light may come on and
the warning tone may sound. This is normal because the
main hydraulic brake system and power steering both
use the power steering pump. If this ever happens, let up
on the brake pedal a little. When you let up on the brake
pedal in that situation, it lets the steering get a little
more help from the pump.
Anti-Lock Brakes (Option)
Your vehicle may have anti-lock brakes (ABS). ABS is
an advanced electronic braking system that will help
prevent a braking skid.
If your vehicle has anti-lock
brakes, this warning light on
the instrument panel will
come on briefly when you
start your vehicle.
When you start your engine and begin to drive away,
your anti
-lock brake system will check itself. You may
hear a momentary motor or clicking noise while this test
is going on. This is normal.
ProCarManuals.com