1998 YAMAHA TW200 brake

6-18
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
5
6
7
8
9
a
b 3
12
EAU00694
Clutch lever free play
adjustment
The clutch lever free play should
be adjusted to 2 ~ 3 mm.
1. Loosen the locknut at the
clutch lever.
2. Turn the adjusting bolt at the
clutch lever in direction ato
increase free play or in direc-
tion bto decrease free play.
3. Tighten the locknut at the
clutch lever.
1. Locknut
2. Adjusting bolt
3. Free play
If the specified free play cannot be
obtained, proceed with the follow-
ing steps.
4. Loosen the locknut at the
clutch lever.
5. Turn the adjusting bolt at the
clutch lever in direction ato
loosen the cable.
6. Loosen the locknut at the
crankcase side.
7. Turn the adjusting nut at the
crankcase in direction ato
increase free play or in direc-
tion bto decrease free play.
8. Tighten the locknut at the
crankcase and the clutch lever.
b
a213
EAU00699
Front brake lever free play
adjustment
The front brake lever free play
should be adjusted to 2 ~ 4 mm.
1. Loosen the locknut at the
brake lever.
2. Turn the adjusting bolt at the
brake lever in direction ato
increase free play or in direc-
tion bto decrease free play.
3. Tighten the locknut at the
brake lever .
1. Locknut
2. Adjusting bolt
3. Free play
a
b
1
2
1. Adjusting nut
2. Locknut
5FY-28199-EX (TW200) 4/16/02 5:38 PM Page 47

6-19
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
5
6
7
8
9b. Turn the adjusting bolt in
direction ato raise pedal
height or in direction bto
lower pedal height.
c. Tighten the locknut.
EW000105
w
After adjusting the pedal height
adjust brake pedal free play.
4
5 12
3
a b
EAU00707
Rear brake pedal height and
free play adjustment
EW000104
w
It is advisable to have a Yamaha
dealer make this adjustment.
1. Pedal height
The brake pedal should be
positioned so that its top end
is approximately 10 mm below
the top of the footrest.
a. Loosen the locknut.
1. Locknut
2. Adjusting bolt
3. Footrest
4. Pedal height: 10 mm
5. Free play
a b 1
2
If the specified free play cannot be
obtained, proceed with the follow-
ing steps.
4. Loosen the locknut at the
brake lever.
5. Turn the adjusting bolt at the
brake lever in direction ato
loosen the cable.
6. Loosen the locknut at the
brake hub.
7. Turn the adjusting nut at the
brake hub in direction ato
increase free play or in direc-
tion bto decrease free play.
8. Tighten the locknut at the
brake hub and the brake lever.
1. Adjusting nut
2. Locknut
5FY-28199-EX (TW200) 4/16/02 5:38 PM Page 48

6-20
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
5
6
7
8
9
b1
2a
EAU00713
Brake light switch
adjustment
The rear brake light switch is acti-
vated by the brake pedal and is
properly adjusted when the brake
light comes on just before braking
takes effect. To adjust the rear
brake light switch, hold the switch
body so it does not rotate while
turning the adjusting nut.
Turn the adjusting nut in direction
ato make the brake light come on
earlier.
Turn the adjusting nut in direction
bto make the brake light come on
later.
1. Brake light switch
2. Adjusting nut
EW000106
w
8Brake pedal free play should
be checked whenever the
chain is adjusted or the rear
wheel is removed and then
reinstalled.
8Check the operation of the
brake light after adjusting the
rear brake.
8If it is impossible to make
proper adjustment, consult a
Yamaha dealer.
2. Free play
The rear brake pedal free play
should be adjusted to 20 ~ 30
mm at the brake pedal end.
Turn the adjusting nut on the
brake rod in direction ato
increase free play or in direc-
tion bto decrease free play.
a
b1
1. Adjusting nut
5FY-28199-EX (TW200) 4/16/02 5:38 PM Page 49

6-21
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
5
6
7
8
9
EAU00744Drive chain slack check
NOTE:
Spin the wheel several times and
find the tightest position of the
chain. Check and/or adjust the
chain slack while it’s in this tightest
position.
EAU00719
Checking the brake shoes
A wear indicator is provided on
each brake. This indicator allows
inspection of shoe wear without
disassembling the brake. Apply the
brake and inspect the position of
the indicator. If the indicator reach-
es to the wear limit line, ask a
Yamaha dealer to replace the
shoes.
1
2
1. Wear indicator
2. Wear limit
FRONT
21
1. Wear indicator
2. Wear limit
REAR
a
a. 30 ~ 40 mm
5FY-28199-EX (TW200) 4/16/02 5:38 PM Page 50

6-22
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
5
6
7
8
9 To check the chain slack the motor-
cycle must be held straight up with
both wheels on the ground and
without rider. Check the slack at
the position shown in the illustra-
tion. Normal slack is approximately
30 ~ 40 mm. If the slack exceeds 40
mm, adjust.
EAU01302
Drive chain slack adjustment
1. Loosen the rear brake adjust-
ing nut.
2. Remove the cotter pin from
the axle nut.
3. Loosen the axle nut.
4. Turn both left and right chain
adjusting plates the same
amount. Make sure that they
are in the same position for
proper wheel alignment.
1
2
3 4
1. Adjusting nut
2. Axle nut
3. Cotter pin
4. Chain adjusting plate
EC000096
cC
Too little chain slack will overload
the engine and other vital parts.
Keep the slack within the specified
limits.
5. After adjusting, be sure to
tighten the axle nut to the
specified torque.
Tightening torque:
Axle nut:
90 Nm (9.0 m0kg)
5FY-28199-EX (TW200) 4/16/02 5:38 PM Page 51

6-23
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
5
6
7
8
9
1
6. Insert a new cotter pin into the
axle nut and bend the end of
the cotter pin as shown in the
illustration. If the notch in the
nut and cotter pin hole do not
match, tighten the nut slightly
to align them.
EW000110
w
Always use a new cotter pin on
the axle nut.
1. Cotter pin
7. Adjust the free play in the
brake pedal.
EW000103
w
Check the operation of the brake
light after adjusting the rear brake.
EAU01106Drive chain lubrication
The chain consists of many parts
which work with each other. If the
chain is not maintained properly, it
will wear out quickly. Therefore,
the chain must be serviced regular-
ly. This service is especially neces-
sary when riding in dusty areas.
1. The drive chain should be
lubricated every 500 km. First,
remove all dirt and mud from
the chain with a brush or cloth.
Then, spray any of the many
brands of spray-type chain
lubricant between both rows
of side plates and on all center
rollers.
2. To clean the chain thoroughly,
remove it from the motorcycle,
dip it in solvent, and clean out
as much dirt as possible. Then,
take the chain out of the sol-
vent to dry it, and immediately
lubricate it to prevent it from
rusting.
5FY-28199-EX (TW200) 4/16/02 5:38 PM Page 52

6-24
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
5
6
7
8
9
EAU00772
Cable inspection and
lubrication
EW000112
w
Damage to the outer housing of
cables may lead to internal rusting
and interfere with the cable move-
ment. Replace damaged cables as
soon as possible to prevent unsafe
conditions.
Lubricate the cables and cable
ends. If a cable does not operate
smoothly, ask a Yamaha dealer to
replace it.
Recommended lubricant:
Same as engine oil
EAU00773
Throttle cable and grip
lubrication
The throttle twist grip assembly
should be greased at the time that
the cable is lubricated, since the
grip must be removed to get at the
end of the throttle cable. After
removing the screws, hold the end
of the cable up in the air and put in
several drops of lubricant. With the
throttle grip disassembled, coat the
metal surface of the grip assembly
with a suitable all-purpose grease.
EAU00776
Brake and shift pedal
lubrication
Lubricate the pivoting parts.
Recommended lubricant:
Same as engine oil
5FY-28199-EX (TW200) 4/16/02 5:38 PM Page 53

6-25
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
5
6
7
8
9
EAU00778
Brake and clutch lever
lubrication
Lubricate the pivoting parts.
EAU00785
Sidestand lubrication
Lubricate the sidestand pivoting
point and metal-to-metal contact
surfaces. Check that the sidestand
moves up and down smoothly.
EW000113
w
If the sidestand does not move
smoothly, consult a Yamaha deal-
er.
Recommended lubricant:
Same as engine oil
Recommended lubricant:
Same as engine oil
EAU00791
Rear suspension lubrication
Lubricate the pivoting parts.
Recommended lubricant:
Lithium soap base grease
5FY-28199-EX (TW200) 4/16/02 5:38 PM Page 54