1998 VOLKSWAGEN JETTA diagram

Downloaded from www.Manualslib.com manuals search engine 01-50


V.A.G 1551
print-out Possible cause
Repair
01130
ABS
operation
Implausible
signal
1)
Electrical interference from
other sources (high
frequency radiation e.g.
non-insulated ignition cable)- Erase DTC memory
- Perform test drive at more than 20 km/h
(13 mph)
- Check DTC memory again


Open circuit, short to
positive or Ground in the
wiring - Check wiring and connections using wiring
diagram
- Perform electrical checks Page 01
-102
If the malfunction occurs again:


ABS Control Module
(w/EDL) -J104- faulty
Repair Manual, Brake System, Repair
Group 45; Hydraulic unit, brake
booster/brake master cylinder - Assembly
overview; Removing and installing control
module and hydraulic unit - Replace ABS control module (w/EDL) -
J104-
1) Type of DTC; this DTC is only recognized above 20 km/h (13 mph) (carry out test drive).
Стр. 30из 81 ABS ITT Mk 20 IE On Board Diagnostic (OBD) program

Downloaded from www.Manualslib.com manuals search engine 01-51


V.A.G 1551
print-out Possible cause
Repair
01276
ABS hydraulic
pump
-V64-
Signal outside
tolerances
1)
ABS hydraulic pump
-V64-connector to
control module faulty- Perform output Diagnostic Test Mode (DTM)
Page 01
-74

Open circuit, short to
positive or Ground in
the wiring - Check wiring and connections using wiring
diagram

- Perform electrical checks from Page 01
-102

ABS hydraulic pump
-V64- faulty - If the ABS hydraulic pump -V64- runs free while
electrical check test step 18 performed Page
01-102 , replace ABS control module (w/EDL) -
J104-

ABS control module
(w/EDL) -J104- faulty
Repair Manual, Brake System, Repair Group 45;
Hydraulic unit, brake booster/brake master cylinder
- Assembly overview; Removing and installing
control module and hydraulic unit - Replace ABS control module (w/EDL) -J104-
1) Type of DTC; this DTC is only recognized above 20 km/h (13 mph) (carry out test drive).
Стр. 31из 81 ABS ITT Mk 20 IE On Board Diagnostic (OBD) program

Downloaded from www.Manualslib.com manuals search engine 01-52


V.A.G 1551
print-out Possible cause
Repair
01312
Drive train data
bus faulty
1)


or:
ABS control module (w/EDL) -
J104- incorrectly coded

Engine control module
incorrectly coded
Repair group 01 for relevant
engine code - Check ABS control module
(w/EDL) -J104- coding Page 01
-
58
- Check engine control module
coding

Open circuit, short to positive or
Ground in the wiring - Check wiring and connections
using wiring diagram

- Perform electrical checks Page
01-102
Drive train data
bus faulty
1)

Sporadic
Ignition/starter switch turned
too slowly - Erase DTC memory Page 01-56
- No further measures required
- Inform customer
1) The DTC "Drive train data bus" will not cause the ABS warning light -K47- or warning light for
brake system -K118- to light up. The ABS function is retained over the complete range.
Стр. 32из 81 ABS ITT Mk 20 IE On Board Diagnostic (OBD) program

Downloaded from www.Manualslib.com manuals search engine 01-53


V.A.G 1551 print-out
Possible cause
Repair
01314
Engine control module
No communication
- Read measured value block
Page 01
-61 display group number
125

Open circuit, short to
positive or Ground in data
bus wiring - Check wiring and connections of
data bus wiring using wiring
diagram
- Perform electrical checks
Page 01
-102
01315
Transmission Control
Module (TCM)
1)
No communication
- Read measured value block
Page 01-61 display group number
125

Open circuit, short to
positive or Ground in data
bus wiring - Check wiring and connections of
data bus wiring using wiring
diagram
- Perform electrical checks
Page 01
-102
1) Vehicles with automatic transmission only.
Стр. 33из 81 ABS ITT Mk 20 IE On Board Diagnostic (OBD) program

Downloaded from www.Manualslib.com manuals search engine 01-54


V.A.G 1551 print-
out Possible cause
Repair
01316
Brake control
module
No
communication
Open circuit, short circuit to
positive or Ground in data bus
wiring - Check data bus wiring and
connection using wiring diagram
- Perform electrical checks
Page 01
-102
Стр. 34из 81 ABS ITT Mk 20 IE On Board Diagnostic (OBD) program

Downloaded from www.Manualslib.com manuals search engine 01-73


Read measured value block
125 Display group number: 125
Engine
1 AWD
1 Gear.
1
Indicated on display (example)

Vacant

Data bus connection for transmission
1)

1 Data bus connection is available.
0 Data bus connection is not available.3)

Data bus for all-wheel drive2)
1 Data bus connection is available.
0 Data bus connection is available.

Data bus for engine

1 Data bus connection is available.
0 Data bus connection is not available.
1) Vehicles with automatic transmission only.

Incorrect transmission control module or incorrect transmission control module coding.

Transmission control module faulty.
Repair Group 01 for relevant transmission code.
2) All-wheel drive vehicles with Haldex coupling only.
3) Data bus connection is interrupted or data bus wires are interchanged.
Electrical Wiring Diagrams, Troubleshooting & Component Locations binder.
Стр. 53из 81 ABS ITT Mk 20 IE On Board Diagnostic (OBD) program

Downloaded from www.Manualslib.com manuals search engine
01-107


Contact
Wiring connection to component ...
1
Left front ABS wheel s peed sensor -G47-
2
Left front ABS wheel s peed sensor -G47-
3
Coding bridge to contact 14
4
Voltage supply to ignition switch
5
Left rear ABS wheel speed sensor -G46-
6
Left rear ABS wheel speed sensor -G46-
7
Connector T16/7, K wire
8
Ground point left in engi ne compartment and Ground connection in engine
compartment wiring harness
9
Voltage supply fr om battery +
10
Data bus wire Wiring diagrams
11 Data bus wire Wiring diagrams
12 Vehicles with navi gation system only
Стр. 6из 31
ABS, ABS/EDL and ABS/EDL/ASR I TT Mark 20 IE, electrical check
Volkswagen Technical Site: http://v olkswagen.msk.ru http://vwts.info http://vwts.ru
огромный архив документации по автомобилям Volkswagen, Skoda, Seat, Audi

Downloaded from www.Manualslib.com manuals search engine 01-111


Test table
Notes on test table

The socket designations of adapter V.A.G 1598/21 are identical to the control module -J104
contact designations in wiring diagram.
Electrical Wiring Diagrams, Troubleshooting & Component Locations binder
If the readings obtained deviate from the specifications, carry out repair measure in the
right-hand part of the table.
Electrical Wiring Diagrams, Troubleshooting & Component Locations binder
Continuity checks with adapter set V.A.G 1594 A (bridging).

If the measured figures only deviate slightly from the specifications, clean sockets and
connectors of the testers and adapter cables (with contact spray G 000 700 04 ) and repeat
check. Before replacing components, check wiring and connections and also, particularly for
specifications of less than 10 , repeat resistance check on the component.
Стр. 10из 31 ABS, ABS/EDL and ABS/EDL/ASR ITT Mark 20 IE, electrical check