RS-2
- SUPPLEMENTAL RESTRAINT SYSTEMSRS AIRBAG
2277 Author: Date:
2004 LAND CRUISER (RM1071U)
When the negative (-) terminal cable is disconnected from the battery, the memory of the clock
and audio system will be canceled. So before starting work, make a record of the contents mem-
orized in the audio memory system. When work is finished, reset the audio systems as they
were before and adjust the clock. To avoid erasing the memory in each memory system, never
use a back- up power supply from outside the vehicle.
If the vehicle is equipped with a mobile communication system, refer to the precaution in the
IN section.
F17248
Mark
- STEERINGTILT STEERING COLUMN
SR-25
2234 Author: Date:
2004 LAND CRUISER (RM1071U)
12. INSTALL COWL TRIM
Install the cowl trim with the clip.
13. INSTALL SCUFF PLATE
14. INSTALL SPIRAL CABLE (See page BE-31)
15. INSTALL COMBINATION SWITCH WITH SPIRAL
CABLE
(a) Install the combination switch with the 3 screws.
(b) Connect the airbag connector.
(c) Tilt steering column:
Connect the 3 connectors.
(d) w/ Power tilt and power telescopic steering column:
Connect the 5 connectors.
16. INSTALL UPPER AND LOWER COLUMN COVERS
Install the upper and lower column covers with the 3 screws.
17. CENTER SPIRAL CABLE
(a) Check that the front wheels are facing straight ahead.
(b) Turn the cable counterclockwise by hand until it becomes
harder to turn the cable.
(c) Then rotate the cable clockwise about 2.5 turns to align
the mark.
HINT:
The cable will rotate about 2.5 turns to either left or right of the
center.
18. INSTALL STEERING WHEEL
(a) Align the matchmarks on the steering wheel and main
shaft.
(b) Install the steering wheel set nut.
Torque: 50 N´m (510 kgf´cm, 37 ft´lbf)
(c) Connect the connector.
19. INSTALL STEERING WHEEL PAD
NOTICE:
Never use airbag parts from another vehicle. When
replacing parts, replace with new ones.
Make sure the wheel pad is installed to the specified
torque.
If the wheel pad has been dropped, or there are
cracks, dents or other defects in the case or connec-
tor, replace the wheel pad with a new one.
When installing the wheel pad, take care that the wir-
ings do not interfere with other parts and are not
pinched between other parts.
