1998 TOYOTA 4RUNNER odometer

4RUNNER (1998)
Instrument cluster overview
1. Service reminder indicators or indi- cator lights
2. Engine coolant temperature gauge
3. Tachometer 4. Speedometer
5. Odometer
6. Trip meter
7. Fuel gauge
8. Trip meter reset knob

4RUNNER (1998)
Part 1
OPERATION OF
INSTRUMENTS
AND CONTROLSÐ
Chapter 1- 5
Gauges, Meters
and Service reminder indicators
Fuel gauge
Engine coolant temperature gauge
Tachometer
Odometer and trip meter
Service reminder indicators and
warning buzzers
Fuel gauge

4RUNNER (1998)
The tachometer indicates engine
speed in thousands of rpm (revolu-
tions per minute). Use it while driv-
ing to select correct shift points
and to prevent engine lugging and
overrevving.
Driving with the engine running too
fast causes excessive engine wear
and poor fuel economy. Remember, in
most cases the slower the engine
speed, the greater the fuel economy.
NOTICE
Do not let the indicator needle get
into the red zone. This may causesevere engine damage.
Odometer and trip meter

4RUNNER (1998)
These meters show the running dis-
tance.
1. OdometerÐIt shows the total dis- tance the vehicle has been driven.
2. Trip meterÐIt shows the distance driven since the last time it was
set to zero. The black digits on
white indicate tenths of kilometers
or miles.
3. Trip meter reset knobÐIt resets the trip meter to zero.
To reset the trip meter, push the
knob. Service reminder indicators
an d warn in g bu zzers

4RUNNER (1998)
Tread wear indicator
CHECKING YOUR TIRES
Check the tire tread for the tread
wear indicators. If the indicators
show, replace the tires.
The tires on your Toyota have built- in
tread wear indicators to help you
know when the tires need replace-
ment. When the tread depth wears to
1.6 mm (0.06 in.) or less, the indica-
tors will appear. If you can see the
indicators in two or more adjacent
grooves, the tire should be replaced.
The lower the tread, the higher the
risk of skidding.
The effectiveness of snow tires is
lost if the tread wears down below
4 mm (0.16 in.). Check the tires regularly for dam-
age such as cuts, splits and cracks.
If any damage is found, consult
with a technician and have the tire
repaired or replaced.
Even if the damage does not appear
serious, a qualified technician should
examine the damage. Objects which
have penetrated the tire may have
caused internal damage.
Any tires which are over six years
old must be checked by a qualified
technician even if damage is not
obvious.
Tires deteriorate with age even if they
have never or seldom been used.
This also applies to the spare tire and
tires stored for future use.REPLACING YOUR TIRES
When replacing a tire, use only the
same size and construction as origi-
nally installed and with the same or
greater load capacity.
Using any other size or type of tire
may seriously affect handling, ride,
speedometer/odometer calibration,
ground clearance, and clearance be-
tween the body and tires or snow
chains.

4RUNNER (1998)
CAUTION
Do not drive with the snow
tires incorrectly inflated.
Never drive over 120 km/h (75
mph) with any type of snow
tires.
TIRE CHAIN SELECTION
Use the tire chains of correct size.
Regulations regarding the use of
tire chains vary according to loca-
tion or type of road, so always
check them before installing chains.
CHAIN INSTALLATION
Install the chains on the rear tires
as tightly as possible. Do not use
tire chains on the front tires. Re-
tighten chains after driving 0.5Ð1.0
km (1/4Ð1/2 mile).
When installing chains on your tires,
carefully follow the instructions of the
chain manufacturer.
If wheel covers are used, they will be
scratched by the chain band, so re-
move the covers before putting on the
chains.
CAUTION
Do not exceed 50 km/h (30
mph) or the chain manufactur-
er 's recommended speed limit,
whichever is lower.
Drive carefully avoiding bumps,
holes, and sharp turns, which
may cause the vehicle to bounce.
Avoid sharp turns or locked-
wheel braking, as use of chains
may adversely affect vehicle
handling.
Replacing wheels
WHEN TO REPLACE YOUR WHEELS
If you have wheel damage such as
bending, cracks or heavy corrosion,
the wheel should be replaced.
If you fail to replace damaged wheels,
the tire may slip off the wheel or they
may cause loss of handling control.
WHEEL SELECTION
When replacing wheels, care should
be taken to ensure that the wheels
are replaced by ones with the same
load capacity, diameter, rim width,
and offset.
Correct replacement wheels are avail-
able at your Toyota dealer.
A wheel of a different size or type
may adversely affect handling, wheel
and bearing life, brake cooling,
speedometer/odometer calibration,
stopping ab ility, headlight aim, bumper
height, vehicle ground clearance, and
tire or snow chain clearance to the
body and chassis.