1998 TOYOTA 4RUNNER ECU

4RUNNER (1998)
2. Fully extend the shoulder belt to
put it in the lock mode. When the
belt is then retracted slightly, it
cannot be extended.
To hold the convertible seat securely,
make sure the belt is in the lock
mode before letting the belt retract.

4RUNNER (1998)
3. While pressing the convertible seat
firmly against the seat cushion and
seatback, let the shoulder belt re-
tract as far as it will go to hold the
convertible seat securely.

4RUNNER (1998)
CAUTION
Make sure the seat belt is secure-
ly locked. Also make sure the
child restraint system is secure
by pushing and pulling it in dif-
ferent directions. Follow all the
installation instructions provided
by its manufacturer.
4. To remove the convertible seat,
press the buckle- release button
and allow the belt to retract com-
pletely. The belt will move freely
again and be ready to work for an
adult or older child passenger.

4RUNNER (1998)
(e) Malfunction Indicator Lamp
This lamp comes on in the following
cases.
a. The fuel tank is completely empty. (See ºFuel gaugeº in Chapter
1- 5 for instructions.)
b. The fuel tank cap is not tightened
securely. (See ºFuel tank capº in
Chapter 1- 2 for instructions.)
c. There is a problem somewhere in
your engine or automatic transmis-
sion electrical system.
If it comes on while you are driving
in case c, have your vehicle checked/
repaired by your Toyota dealer as
soon as possible.
(f) Low Fuel Level Warning Light
This light comes on when the fuel
level in the tank becomes nearly
empty. Fill up the tank as soon as
possible.
On inclines or curves, due to the
movement of fuel in the tank, the low
fuel level warning light may come on
earlier than usual.
(g) ºABSº Warning Light
This light warns that there is a prob-
lem somewhere in your anti- lock
brake system. If the light comes on while you are
driving, have your vehicle checked by
your Toyota dealer as soon as pos-
sible.
The light will come on when the igni-
tion key is turned to the ºONº posi-
tion. After about 3 seconds, the light
will go off.
When the ºABSº warning light is on
(and the brake system warning light is
off), the brake system operates con-
ventionally but anti- lock brake system
is not assisting brake performance so
that the wheels can lock- up during
sudden braking or braking on slippery
road surfaces.
Vehicles with rear differential lock sys-
temÐ
The anti-lock brake system does not
operate when the rear differential is
locked. It is normal operation for the
ºABSº warning light to be on at this
time.
(h) Open Door Warning Light
This light remains on until all the
doors and back door are completely
closed.
(i) SRS Airbag Warning Light
This light will come on when the
ignition key is turned to the ºACCº
or ºONº position. After about 6 se-
conds, the light will go off. This
means the airbag system is operat-
ing properly.
The warning light system monitors the
airbag sensor assembly, inflators,
warning light, interconnecting wiring
and power sources.
If either of the following conditions
occurs, this indicates a malfunction
somewhere in the parts monitored by
the warning light system. Contact your
Toyota dealer as soon as possible to
service the vehicle.
The light does not come on when
the ignition key is turned to the
ºACCº or ºONº position or remains on.
The light comes on while driving.
(j) Light Reminder Buzzer
This buzzer will sound if the driver 's
door is opened while the ignition
switch is turned to the ºLOCKº posi-
tion with the headlight switch on. Re-
moving the key will not stop the buzz-
er as long as the headlight switch is on.

4RUNNER (1998)
NOTICE
Never shift into reverse while the
vehicle is moving.
(e) Parking
1. Bring the vehicle to a complete stop.
2. Pull the parking brake lever up ful- ly to securely apply the parking
brake.
3. With the brake pedal pressed down, shift the selector lever to the
ºPº position.
CAUTION
While the vehicle is moving, nev-
er attempt to move the selector
lever into ºPº position under any
circumstances. Serious mechani-
cal damage and loss of vehicle
control may result.
(f) Good driving practice
If the transmission is repeatedly
upshifted and downshifted between
third gear and overdrive when
climbing a gentle slope, the over-
drive switch should be turned off.
Be sure to turn the switch on im-
mediately afterward.
When towing a trailer, in order to
maintain engine braking efficiency,
do not use overdrive.
CAUTION
Always keep your foot on the
brake pedal while stopped with
the engine running. This prevents
the vehicle from creeping.
NOTICE
Do not hold the vehicle on an
upgrade with the accelerator ped-al. It can cause the transmissionto overheat. Always use the brake
pedal or parking brake.
(g) Rocking your vehicle if stuck
CAUTION
To rock your vehicle if it becomes
stuck in snow, mud, sand, etc.,
first check that there are no ob-
jects or people around the ve-
hicle. During the rocking opera-
tion the vehicle may suddenly
move forward or backward as it
becomes unstuck, causing injury
or damage to nearby people or
objects.
NOTICE
If you rock your vehicle, observethe following precautions to pre-vent damage to the transmissionand other parts.
Do not depress the acceleratorpedal while shifting the selectorlever or before the transmission
is completely shifted to forwardor reverse gear.
Do not race the engine andavoid spinning the wheels.

4RUNNER (1998)
NOTICE
Be careful not to overrev the
engine. Watch the tachometer tokeep engine rpm from goinginto the red zone. The approxi-
mate maximum allowable speedfor each position is given abovefor your reference:
Front drive control lever inºH2º or ºH4º
3RZ- FE engine º2º.....................111km/h (68
mph)
ºLº...................... 60km/h (37
mph)
5VZ- FE engine º2º.....................1 18km/h (73
mph)
ºLº...................... 64km/h (40
mph)
Front drive control lever in ºL4º
3RZ- FE engine º2º...................... 43km/h (26
mph) ºLº...................... 23km/h (14
mph)
5VZ- FE engine º2º...................... 46km/h (28
mph)
ºLº...................... 25km/h (15
mph)
Do not continue hill climbing or
hard towing for a long time inthe º2º or ºLº position. Thismay cause severe automatic
transmission damage from over-heating. To prevent such dam-age, ºDº position should be
used in hill climbing or hardtowing.
(d) Backing up
1. Bring the vehicle to a complete stop.
2. With the brake pedal held down with your foot, shift the selector
lever to the ºRº position.
NOTICE
Never shift into reverse while the
vehicle is moving.
(e) Parking
1. Bring the vehicle to a complete stop.
2. Pull the parking brake lever fully to securely apply the parking brake.
3. With the brake pedal pressed down, shift the selector lever to
the ºPº position.

4RUNNER (1998)
Rear
The cup holder is designed for
holding cups or drink- cans securely
in its holes.
To use the cup holder, pull it out.CAUTION
Do not place anything else on
the cup holder, as such item
may be thrown about in the
compartment and possibly in-
jure people in the vehicle dur-
ing sudden braking or an acci-
dent.
To reduce the chance of injury
in case of an accident or a sud-
den stop while driving, keep the
cup holder retracted when not
in use.

4RUNNER (1998)
Tie- down hooks
To secure your luggage, use the
tie- down hooks as shown above.
See ºLuggage stowage precautionsº in
Part 2 for what to observe in loading
luggage. Luggage cover