1998 SSANGYONG MUSSO torque

7B/C-22 MANUAL & SEMIAUTO-HVAC
Removal & Installation Procedure
1. Disconnect the negative(-) terminal from the battery.
2. Discharge refrigerant from the system.
Notice
By connecting a manifold gauge connection hose to High/
Low pressure line, discharge the refrigerant.
3. Disconnect the high / low pressure pipe and wire connectors.
Installation Notice
Notice
Before tightening, apply the compressor oil to O-ring.
Tightening Torque
20 - 30 Nm
4. Remove the mounting bolt from the compressor bracket
and remove compressor assembly.
Notice
Place the removed compressor in vertical position.
Installation Notice
5. Installation should follow the removal procedure in the
reverse order.
Tightening Torque
21 - 26 Nm

8B-18 SUPPLEMENTAL RESTRAINT SYSTEM(SRS)
MAINTENANCE AND REPAIR
ON-VEHICLE SERVICE
AIR BAG MODULE
Removal & Installation Procedure
1. Remove the steering wheel rid (LH,RH) with a screwdriver.
Installation Notice
Each position mark (LH,RH) is stamped on the inner surface
of the rids.
Tightening Torque 7 - 11 Nm
3. Disconnect the connectors and remove the air bag module.
4. Installation should follow the removal procedure in the
reverse order. 2. Unscrew the bolts from both sides.
Installation Notice

9L-8 GLASS AND MIRRORS
Tightening Torque 7.7 Nm 4. Before installation, ensure that the stay bolt washer is
inserted.
5. Using suction holders, install the side glass within 5minutes
after application of sealant.

FRAME AND UNDERBODY 9N-5
1 Mounting Bolt.......................................28-47 Nm
SKID PLATE
.
2 Skid Plate
Removal & Installation Procedure
1. Remove 6 mounting bolts and carefully remove the skid
plate.
Installation Notice
2. Installation should follow the removal procedure in the
reverse order.
Tightening Torque 28 - 47 Nm

9R-6 BODY FRONT END
5. Remove the fender mounting bolts.
Notice
Be careful not to damage the paintwork.
Installation Procedure
1. Installation should follow the removal procedure in the
reverse order.
Notice
Apply a tape sealer to the fender and body panel to prevent
rust in fender mounting bolts area.
Tightening Torque 7 - 9 Nm