FULLY AUTOMATIC AIR CONDITIONER
Trouble Diagnosis by Self-diagnosis Function
There are 5 steps in the self-diagnosis: to check for any sensor failure, and to check that a given control sig-
nal is transmitted to each output device.
Diagnosis
content
- - -
Diagnostic
item
i Step I I Step 2 - - - - - - - --
Each sensor check
Indicator lamp check
Display segments Ambient sensor
0 Indicator lamp In-vehicle sensor
lntake air tempera-
ture sensor
Sunload sensor Step
3
Each
actuator check
and reset check display for each
sen-
lntake door actuator
Air mix door actua-
tor Mode door actuator
lntake door actuator
Air mix door actua-
tor
Mode door actuator
Blower fan motor
Compressor
Air purifier (only
when connected)
Ambient sensor
In-vehicle sensor
lntake air tempera-
ture sensor
SELF-DIAGNOSIS OPERATION PROCEDURE R8
Switching to self-diagnosis mode
Turn the temperature adjustment dial all the way to the left.
Start the engine with the ignition switch from OFF position. Within 10 seconds, press and hold the OFF
switch for more than approx. 5 seconds, to start the self-diagnosis step 1.
Self-diagnosis completion EL
a Turn the ignition switch OFF.
Turn the AUTO switch ON.
Switching between self-diagnosis steps
Use the temperature adjustment dial to switch between self-diagnosis steps 1 to 5.
Temperature adjustment dial (turn clockwise): Step
1-5
Temperature adjustment dial (turn counterclockwise): Step
5- 1
a Refer to "SELF-DIAGNOSIS DISPLAY ITEM" for the diagnosis contents of each step.
