1998 Mercury Villager fog light

WARNING
Operating with the function selector control in off or in
the recirculated air mode for extended periods of time in
cold weather can result in fog buildup on interior glass
surfaces.
mThe Mix () button directs approximately equal amounts
of air to the windshield and floor outlets with a small
amount to the side windows.
mThe Defrost (
) button directs air to the windshield and
front side windows with a small amount going to the floor
outlets.
mThe Panel (
) button directs air to the instrument panel
outlets.
mThe Panel/Floor (
) button directs approximately equal
amounts of air to the instrument panel outlets and the floor
outlets.
mThe Floor (
) button directs most of the system's air
supply to the floor outlets with a small amount going to the
windshield and side window defrosters.
Air Outlets
Air intake selector button
The typical air intake selection is outside air. However, for
recirculated air, the air intake selector button may be activated.
When the air intake selector button is activated (indicator light is
on), it prevents the intake of outside air. This is the typical
selection when using the air conditioner (if equipped). It
recirculates interior air for faster cooling. The recirculated air
function also helps to prevent the intake of dusty or unpleasant air.
Controls and Features
57

There are several air outlets on the instrument panel. There are
side outlets near the driver's window and passenger's window, two
center outlets, floor outlets, and windshield outlets. The
direction and amount of air flow from the center and side
instrument panel outlets can be adjusted for personal comfort.
NOTE: Selection of the recirculated air mode under cold and
humid conditions may result in window fogging due to
entrapped humidity within the vehicle. To counteract
this circumstance, switch to the Defrost mode and set fan
speed to 3 or 4. Adjust air temperature to a ªwarmº
instead of ªhotº setting and deactivate the air intake
selector.
Heating Only System (Without air conditioning)
You can heat and ventilate the inside of your vehicle, or defrost
the windshield with the function selector buttons, the fan speed
knob and the temperature control knob.
An additional push-on/push-off air intake selector button
provides for the selection of recirculated inside air (button lighted)
or outside air (button not lighted).
58

Press this button to obtain maximum airflow to the windshield.
Adjust the temperature setting as required for defrosting. The
indicator light illuminates and the display window shows
the set temperature. When the outside temperature is about 50É F
(10É C) the air conditioning functions in order to dehumidify
the air to prevent window fogging.
Push this button to select airflow through the instrument panel
registers. The
indicator light illuminates and the display
window shows the set temperature. The ATC heats the air if the
selected temperature is warmer than the outside air coming
into the vehicle. However, the air is not cooled below the
temperature outside of the vehicle regardless of the temperature
setting unless the A/C button is pushed.
Push this button for air from the floor and instrument panel
registers at the same time. The
indicator light illuminates and
the display window shows the set temperature. The ATC heats
the air if the selected temperature is warmer than the outside air
coming into the vehicle. However, the air is not cooled below
the temperature outside of the vehicle regardless of the temperature
setting unless the A/C button is pushed.
Push this button to direct airflow to the floor. Theindicator light
illuminates and the display window shows the set temperature.
The ATC heats the air if the selected temperature is warmer than the
outside air coming into the vehicle. However, the air is not cooled
below the temperature outside of the vehicle regardless of the
temperature setting unless the A/C button is pushed.
72