1998 Mercury Villager warning

NOTE: If a fault occurs in the anti-lock system, and the brake
warning light is not lit, the anti-lock system is disabled
but normal brake function remains operational.
Ford Motor Company has not found any negative effects of
mobile radio transmitting equipment installed on vehicles with
the ABS providing that the radio is installed according to the radio
manufacturer's instructions. However, if you have had a
mobile radio transmitter installed and the check ABS light comes
on (at any time other than immediately after turning the key
to the ON position) have your mobile radio dealer inspect the
installation. Also, if the ABS system is activated other than during
maximum braking, have your mobile radio installation
checked.
If Brakes Do Not Grip Well or Pedal is ``Low''
If the brake pedal seems ªlowº it may indicate the need for a
brake system inspection and/or service. Apply your parking brake
several times. If the condition has not improved, you should
have your brakes checked as soon as possible.
Occasional brake squeal during light to moderate stops does not
affect the function of the brake system and is normal.
However, if the squeal becomes very loud or if it becomes more
frequent, return the vehicle to your dealer for inspection.
WARNING
Modifications to the suspension spring rates and/or
vehicle ride height may adversely affect vehicle stopping
ability.
Driving
217

Stopping Distances
Stopping distances vary with different loads and driving
conditions. Use caution when you drive under new conditions
and acquaint yourself with your vehicle's performance.
Applying the Brakes
Apply the brake pedal evenly. Use the ªsqueezeº technique. Push
on the brake pedal with a steadily increasing force. This allows
the wheels to continue to roll while you are slowing down, which
lets you steer properly. In the event of a sudden stop with ABS
equipped vehicles, do not pump the brakes. Pumping the brakes
during an anti-lock stop will diminish braking effectiveness.
Do not drive with your foot resting on the brake pedal. This will
increase your vehicle's stopping distance and may also cause
brake damage.
WARNING
If you are driving down a long or steep hill, shift to a
lower gear. Do not apply your brakes continuously, as they
may overheat and become less effective.
Using the Parking Brake
The parking brake pedal is suspended just below the bottom of
the instrument panel to the left of the brake pedal. To set the
parking brake, press the brake pedal with your right foot and
hold it while you push the parking brake pedal down firmly with
your left foot.
218

WARNING
When parking, do not use the gearshift in place of the
parking brake. Always set the parking brake fully and make
sure that the gearshift is securely latched in Park (P).
Turn off the ignition whenever you leave your vehicle.
Never leave your vehicle unattended while it is running. If
you do not take these precautions, your vehicle may
move unexpectedly and injure someone.
To release the parking brake, press the brake pedal with your
right foot and hold it while you lift up on the parking brake release
handle.
WARNING
If the parking brake is fully released, but the Brake
System light remains on, have the brakes checked
immediately. They may not be working properly.
The parking brake
Driving
219

Automatic Transaxle Operation
Putting Your Vehicle in Gear
Your vehicle's gearshift lever is on the steering column. The
OVERDRIVE OFF/ON button is located at the end of the gearshift
lever. You can put the gearshift lever in any one of several
positions.
WARNING
Hold the brake pedal down while you move the gearshift
lever from position to position. If you do not hold the
brake pedal down, your vehicle may move unexpectedly
and injure someone.
Once you place the gearshift lever securely into position,
gradually release the brake pedal and use the accelerator as
necessary.
The steering column gearshift lever positions
Driving
221

Shift-lock Safety Feature
Your vehicle has a special shift-lock safety feature which prevents
you from shifting out of P (Park) without the brake pedal
depressed. To shift the transaxle out of the P (Park) position, the
ignition must be in the ON position and your foot must be
pressing on the brake pedal.
If the shift lever cannot be moved from the P (Park) position with
the brake pedal depressed:
1. Shut the engine off and remove the ignition key.
2. Apply the parking brake.
3. Reinsert the ignition key and turn it to the first position (OFF).
4. Depress the brake pedal, move the gearshift lever to N
(Neutral) and start the engine.
If you need to shift out of P (Park) by using the alternate
procedure described above, it is possible that a fuse has blown
and that your brakelamps may also not be functional. Please refer
to the chapter titledRoadside Emergenciesin this Owner Guide
for instructions on checking and replacing fuses.
WARNING
DO NOT DRIVE YOUR VEHICLE UNTIL YOU VERIFY
THAT THE BRAKELAMPS ARE WORKING.
Backing Up
Before shifting into or out of R (Reverse), you should always
come to a complete stop.
222

N (Neutral)
In N (Neutral), the transaxle is not locked. Your vehicle will roll
freely, even on the slightest incline, unless the parking brake
or brakes are on.
Parking
Always come to a complete stop before you shift into P (Park).
This position locks the transaxle and prevents the front wheels from
turning. To securely latch the gearshift in the P (Park) position,
pull it toward you, push it completely counterclockwise against the
stop, and then push it toward the instrument panel.
The gearshift is securely latched in Park (P) if you cannot rotate
it in a clockwise direction without lifting it toward you.
WARNING
Always set the parking brake fully and make sure the
gearshift is latched in P (Park). Turn off the ignition
whenever you leave your vehicle.
WARNING
Never leave your vehicle unattended while it is running.
Forced Downshifts
To gain extra acceleration in Drive (D) (when passing another
vehicle) push the accelerator to the floor. The transaxle will
automatically downshift to the appropriate gear - third,
second or first.
Driving
225

Driving Through Water
Do not drive quickly through standing water, especially if the
depth is unknown. Traction or brake capability may be limited and
if the ignition system gets wet, your engine may stall. Water
may also enter your engine's air intake and cause severe damage
to your engine.
If driving through deep or standing water is unavoidable,
proceed very slowly. Never drive through water that is higher
than the bottom of wheel rims.
Once through the water, always try the brakes. Wet brakes do not
stop the vehicle as effectively as dry brakes. Drying can be
improved by moving your vehicle slowly while applying light
pressure on the brake pedal.
Driving With a Heavy Load
The Safety Compliance Certification Label, located on the driver's
door pillar, provides important information regarding the
weight limits your vehicle can safely carry or tow. The total
weight of your vehicle, including the weight of the passengers
and cargo, should never be more than the Gross Vehicle Weight
Rating (GVWR). Also, the weight that your vehicle carries on
the front axle and rear axle should never be more than the Gross
Axle Weight Rating (GAWR) for the respective axle.
The load capacities of your vehicle's tires affect the GVWR or
GAWR limitations. Using replacement tires with a higher weight
limit than the originals does not increase GVWR or GAWR.
Using lower capacity replacement tires may lower GVWR and
GAWR limitations.
WARNING
Do not exceed the GVWR or the GAWR specified on the
Safety Compliance Certification Label.
226

Trailer towing table
If your vehicle exceeds the GVWR, remove cargo from your vehicle
accordingly. If your vehicle exceeds either GAWR, shift the
load or remove cargo accordingly.
To determine actual GCW, weigh the total vehicle and trailer and
also weigh the trailer separately to verify its weight.
Trailers
Towing a trailer safely means having the proper weight on the
tongue (usually 10-15% of the trailer weight).
WARNING
Do not exceed the GVWR or the GAWR specified on the
Safety Compliance Certification Label.
WARNING
Towing trailers beyond the maximum recommended gross
trailer weight exceeds the limit of the vehicle and could
result in engine damage, transaxle damage, structural
damage, loss of control, and personal injury.
Driving
233