1998 Mercury Villager change wheel

Tilt Steering
WARNING
Never adjust the steering wheel when the vehicle is
moving.
To change the position of the steering column, pull the release lever
on the column down. Move the steering wheel to the desired
position and raise the lever to lock the steering wheel in place.
Tilt release lever location
Controls and Features
91

The parking brake is not designed to stop a moving vehicle, but
you can use the parking brake to stop your vehicle in an
emergency if the service brakes fail. However, since the parking
brake does not stop your vehicle as quickly as the normal
brakes, the stopping distance will increase greatly.
Steering Your Vehicle
Your vehicle has power steering. Power steering uses energy
from the engine to help steer your vehicle.
If the amount of effort needed to steer your vehicle changes at a
constant vehicle speed, have the power steering system
checked. If the power steering system breaks down (or if the
engine is turned off), you can steer the vehicle manually but it takes
more effort.
Never hold the steering wheel in the extreme right or left
position for more than five seconds if the engine is running. This
can damage the power steering pump.
NOTE: After any severe impact such as striking large potholes,
sliding into curbs on icy roads, or a collision involving
the front end, have the front suspension and
steering checked for possible damage.
220

Stowing the spare tire
1. To raise the tire to the stowed position, lay the tire on the
ground with the inboard side facing up. Install the retainer
through the wheel center and slide the tire under the
vehicle. Fit the hex-shaped end of the lug wrench over the hex
nut in the floor of the cargo area. Turn the lug wrench
clockwise until the tire is raised to its original position
underneath the vehicle.
NOTE: The lug wrench ratchets when the tire is raised to the
stowed position. It will not allow you to over-tighten.
2. Check for proper seating against the underbody supports and
retighten if necessary.
WARNING
Make sure the spare tire and jacking equipment are
stowed and secured in the proper storage location.
Preparing to Change the Tire
You should only raise your vehicle with a jack properly placed at
the front or rear jacking points.
1. Make sure that your vehicle will not move or roll and that the
tires and jack are on a level, solid surface. Put the gearshift
lever in P (Park). Set the parking brake and block the wheel Ð
in both directions Ð that is diagonally opposite the tire that
you are changing.
WARNING
When one of the front wheels is off the ground, the
transaxle alone will not prevent the vehicle from moving
or slipping off the jack, even if the vehicle is in P
(Park).
258

WARNING
To prevent the vehicle from moving when you change a
tire, be sure the parking brake is set, then block (in both
directions) the wheel that is diagonally opposite (other
side and end of the vehicle) to the tire being changed.
WARNING
If the vehicle slips off the jack, you or someone else could
be seriously injured.
2. Remove the spare tire and jack. See previous section for
instructions on spare tire removal. The jack is located in the rear
storage compartment in the right door panel of the cargo
area. You will have to unfasten the jack before removing it as
shown in the illustration. The jack handle is in the tool kit
located behind the jack.
NOTE: All occupants should be out of the vehicle while it is
on the jack.
Roadside Emergencies
259

3. Insert the tapered end of the jack handle behind the wheel
cover of the tire to be changed and gently pry it off. When
you want to replace the wheel cover, simply align the valve stem
to the slot in the cover and press it back on.
Removing the wheel cover
260

16. Make sure the lug wrench is secured back into the tool kit and
store it next to the jack.
17. Unblock the wheels.
Retighten the lug nuts to the specified torque at 500 miles (800
km) of operation, after any wheel change, or any time the lug nuts
are loosened.
Storing the jack
Roadside Emergencies
267