1998 Lexus ES300 Owner's Manuals (in English)

STARTING AND DRIVING145
Setting at a desired speed
31L014
The transmission must be in ºDº before you set the cruise control spe\
ed.
Bring the vehicle to the desired speed, press the control lever downward in th\
e
ºSET/COASTº direction and release it. This sets the vehicle at that speed.
Now you may take your foot off the accelerator pedal. If you need
acceleration ± for example, when passing ± depress the accelerator pedal
enough for the vehicle to exceed the set speed. When you release the
accelerator pedal, the vehicle will return to the speed set prior to the
acceleration.
Cancelling the preset speed
You can cancel the preset speed by either of the following:
a. Pulling the control lever in the ºCANCELº direction.
b. Depressing the brake pedal.
If the vehicle speed falls below about 40 km/h (25 mph), the preset spee\
d will
be automatically cancelled.
If the vehicle speed drops 16 km/h (10 mph) below the preset speed, the \
preset
speed will also automatically be cancelled.
If the preset speed automatically cancels out for other than these reasons\
, have
your vehicle checked by your Lexus dealer at the earliest opportunity.
Resetting to a faster speed
Press the control lever upward in the ºRES/ACCº direction and hold it.
Release the lever when the desired speed is attained. While the lever is held
upward, the vehicle will gradually gain speed.
When the difference between the actual vehicle speed and the set speed is less
than 5 km/h (3 mph), the set speed can be increased 1.6 km/h (1 mph) eac\
h
time by pressing the control lever upward in the ºRES/ACCº direction
quickly.
However, a quicker way to reset is to accelerate the vehicle and then press the
control lever downward in the ºSET/COASTº direction.

STARTING AND DRIVING
146
Resetting to a slower speed
Press the control lever downward in the ºSET/COASTº direction and hold \
it.
Release the lever when the desired speed is attained. While the lever is held
downward, the vehicle speed will gradually decrease.
When the difference between the actual vehicle speed and the set speed is less
than 5 km/h (3 mph), the set speed can be lowered 1.6 km/h (1 mph) e\
ach time
by pressing the control lever downward in the ºSET/COASTº direction
quickly.
However, a quicker way to reset is to depress the brake pedal and then press
the control lever downward in the ºSET/COASTº direction.
Even if you turn off the overdrive switch with the cruise control on, engine
braking will not be applied because the cruise control is not cancelled. To
decrease the vehicle speed, reset to a slower speed with the cruise control lever\
or depress the brake pedal. If you use the brake pedal, cruise control \
is
cancelled.
Resuming the preset speed
If the preset speed is cancelled by pulling the control lever or by depr\
essing
the brake pedal, pushing the lever up in the ºRES/ACCº direction will\
restore
the speed set prior to cancellation. However, once the vehicle speed falls
below about 40 km/h (25 mph), the preset speed will not be resumed.
Cruise control failure warning
If the ºCRUISEº indicator light in the instrument cluster flashes fi\
ve times and
then goes out when using the cruise control, it means that there is trouble in
the cruise control system. Contact your Lexus dealer.
ELECTRONIC MODULATED SUSPENSION
This electronic modulated suspension adjusts the damping effect on the
shock absorbers with the control switch. Select one of the 4 modes which
is suited to the driving conditions with the control switch to provide good
riding comfort and stability.
31E012±2
1 For sporty type driving such as on winding mountain roads and high
speed driving
2For moderate high speed driving
3For ordinary driving such as in the city traffic
4For driving on a bumpy road

STARTING AND DRIVING147
TRACTION CONTROL SYSTEM
The traction control system automatically helps control the spinning of
the front wheels which may occur when accelerating on slippery road
surfaces, thus assisting driver to control the driving power of the front
wheels.
31E013
When you turn the ignition switch on, this system always turns on. Leave
the system on during ordinary driving so that it can operate when needed.
When traction control is applied, the slip indicator light blinks.
31E014±1
You can turn off the traction control system by pushing the ºTRAC OFFº
switch. The ºTRAC OFFº indicator/warning light will then come on. Pushing
the ºTRAC OFFº switch a second time turns the system back on
and extinguishes the ºTRAC OFFº indicator/warning light.
When the traction control system is operating, you may feel vibration or nois\
e
of your vehicle, caused by operation of the brakes. This indicates the sy\
stem
is functioning properly.
When getting the vehicle out of mud or new snow, etc. the traction control
system will help operate to prevent the wheels from spinning.
Traction control failure warning
If the ºTRAC OFFº indicator/warning light flashes, contact your Lexus dealer
as soon as possible. There may be trouble in the traction control syste\
m.
CAUTION
Under certain slippery road conditions, full traction of the
vehicle and power to the front wheels cannot be maintained,
even though the traction control system is in operation. Do not
drive the vehicle under any speed or maneuvering conditions
which will cause the vehicle to lose traction. In situations
where the road surface is covered with ice or snow, your
vehicle should be fitted with snow tires or tire chains. Always
drive at an appropriate and cautious pace.

STARTING AND DRIVING
148
BRAKE SYSTEM
The tandem master cylinder brake system is a hydraulic system with two
separate sub±systems. If either sub±system should fail, the other will still
work. However, the pedal will be harder to press, and your stopping distance
will be longer. Also, the brake system warning light may come on.
CAUTION
Do not drive your vehicle with only a single brake system.
Have your brakes fixed immediately.
Brake booster
The brake booster uses engine vacuum to power±assist the brakes. If the
engine should quit while you are driving, you can bring the vehicle to a stop
with normal pedal pressure. There is enough reserve vacuum for one or t\
wo
stops but no more!
CAUTION
Do not pump the brake pedal if the engine stalls. Each push
on the pedal uses up your vacuum reserve.
 Even if the power assist is completely lost, the brakes will
still work. But you will have to push the pedal hard ± much
harder than normal. And your braking distance will be
longer.
Anti±lock brake system
The anti±lock brake system is designed to automatically help prevent
lock±up of the wheels during a sudden brake or braking on slippery road
surfaces. This assists in providing directional stability and steering
performance of the vehicle under these circumstances.
The anti±lock brake system becomes operative after the vehicle has
accelerated to a speed in excess of approximately 10 km/h (6 mph). It stops
operating when the vehicle decelerates to a speed below approximately 5
km/h (3 mph).
You may hear a sound in the engine compartment for a few seconds when the
engine is started or just after the vehicle is started. This means that the
anti±lock brake system is in the self±check mode, and does not indicate a
malfunction.
Effective way to press the ABS brake pedal: When the anti±lock brake
system function is in action, you may feel the brake pedal pulsating and hear
a noise. In this situation, to let the anti±lock brake system work f\
or you, just
hold the brake pedal down more firmly. Do not pump the brake. This will
result in reduced braking performance.
The brake pedal pulsation caused by the anti±lock brake system may indic\
ate
hazardous road surface conditions. Although the anti±lock brake system
assists in providing vehicle control, it is still important to drive with all due
care, because the anti±lock brake system cannot overcome the laws of physic\
s
that act on your vehicle:
 Braking capability is dependent on tire friction with the road surface.

STARTING AND DRIVING149

Even though the anti±lock brake system is operating, a driver cannot
maintain full control on certain slippery road surfaces, when cornering at
high speeds, or in violent maneuvers.
 Avoid high speeds on wet roads. The anti±lock brake system cannot
eliminate the risk of hydroplaning and loss of tire friction.
Always maintain a safe distance from the vehicle in front of you. Compared
with vehicles not fitted with an anti±lock brake system, your vehicle\
may
require a longer stopping distance in the following cases:
 Driving on rough, gravel or snow±covered roads.
 Driving with tire chains installed.
 Driving on roads where the road surface is pitted or has other differences
in surface height. ºABSº warning light
31E015
This light comes on when the ignition key is turned to the ºONº po\
sition.
After about a few seconds, the light will go off.
If either of the following conditions occurs, this indicates a malfunction
somewhere in the parts monitored by the warning light system. Contact your
Lexus dealer as soon as possible to service the vehicle.

The light does not come on as described above, or remains on.
 The light comes on while driving.
Even if the anti±lock brake system should fail, the brake system will still
operate conventionally. But when the ºABSº warning light is on (and the
brake system warning light is off), anti±lock brake system is not assisting
brake performance so that the wheels could lock up during a sudden brake or
braking on slippery road surfaces. Have your vehicle checked by your Lexus
dealer as soon as possible.
Drum±in±disc type parking brake system
Your vehicle has a drum±in±disc type parking brake system. This type of
brake system needs bedding±down of the brake shoes periodically or
whenever the parking brake shoes and/or drums are replaced.
Have your Lexus dealer perform the bedding±down.

STARTING AND DRIVING
150
BRAKE PAD WEAR LIMIT INDICATORS
31E016
The brake pad wear limit indicators on your disc brakes give a warning
noise when the brake pads are worn to the extent that replacement is
required.
If you hear a squealing or scraping noise while driving, have the brake \
pads
checked and replaced by your Lexus dealer as soon as possible. Expensive
rotor damage can result if the pads are not replaced when needed.
TYPES OF TIRES
Determine what kind of tires your vehicle is originally equipped with.
1. Summer tires
Summer tires are high±speed capability tires best suited to highway driving\
under dry conditions.
Since summer tires do not have the same traction performance as snow tires,
summer tires are inadequate for driving on snow±covered or icy roads. For
driving on snow±covered or icy roads, we recommend using snow tires. If
installing snow tires, be sure to replace all four tires.
2. All season tires
All season tires are designed to provide better traction in snow and to \
be
adequate for driving in most winter conditions, as well as for use all year
round.
All season tires, however, do not have adequate traction performance
compared with snow tires in heavy or loose snow. Also, all season tires fall
short in acceleration and handling performance compared with summer tires
in highway driving.
CAUTION
Do not mix summer and all season tires on your vehicle as
this can cause dangerous handling characteristics,
resulting in loss of control.
 Do not use tires other than the manufacturer's designated
tires, and never mix tires or wheels of the sizes different
from the originals.

SECTION 3 ± 2
151
STARTING AND DRIVING
Driving tips
Break±in period152
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
. . . . . . . . . . . . . . . . . . . . . .
Operation in foreign countries 152
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
. . . . . . . . . .
Tips for driving in various conditions s 152. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
. . . .
Winter driving tips 153
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
. . . . . . . . . . . . . . . . . . .
Trailer towing 154
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
. . . . . . . . . . . . . . . . . . . . . . .
How to save fuel and make your vehicle last longer 159
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .

DRIVING TIPS
152
BREAK±IN PERIOD
Drive gently and avoid high speeds.
You need not follow a break±in schedule with your new Lexus. But follow\
ing
a few simple tips for the first 1600 km (1000 miles) can add to the fu\
ture
economy and long life of your vehicle:
Do not drive over 88 km/h (55 mph).
 Avoid overrevving. Maintain engine speed between 2000 and 4000 rpm.
 Avoid full±throttle starts.
 Try to avoid hard stops during the first 300 km (200 miles).
 Do not drive for a long time at any single speed, either fast or slow.
 Do not tow a trailer during the first 800 km (500 miles).
OPERATION IN FOREIGN COUNTRIES
If you plan to drive your Lexus in another country ...
First, comply with the vehicle registration laws.
Second, confirm the availability of the correct fuel (unleaded and minimum
octane rating).
TIPS FOR DRIVING IN VARIOUS CONDITIONS
Always slow down in gusty crosswinds. This will allow you much better
control.
 Drive slowly onto curbs and, if possible, at a right angle. Avoid driving
onto high, sharp±edged objects and other road hazards. Failure to do so can
lead to severe tire damage resulting in tire bursts.
 When parking on a hill, turn the front wheels until they touch the curb so
that the vehicle will not roll. Apply the parking brake, and place the
transmission in ºPº. If necessary, block the wheels.
 Washing your vehicle or driving through deep water may get the brakes
wet. To see whether they are wet, check that there is no traffic near you and
then press the pedal lightly. If you do not feel a normal braking force, the
brakes are probably wet. To dry them, drive the vehicle cautiously while
lightly pressing the brake pedal with the parking brake applied. If they still
do not work safely, pull to the side of the road and call a Lexus dealer for
assistance.