1998 JAGUAR X308 ECU

9. Remove upper steering column upper fixings.
1. Remove bolts.
Allow column to rest on the floor

10. Cut cable tie which secures console harness to LH blower
duct.

11. Remove LH fan motor duct.
Remove screws.
Remove duct.
12. Remove passenger si de footwell vent.
Remove nut.
Remove vent.

13. Cut cable tie which secures console harness to RH blower
duct.

14. Remove RH fan motor duct.
Remove screws.
Remove duct.

15. Disconnect heater / cooler assembly electrical connector.
16. Disconnect condensate drain tubes from heater / cooler
assembly.

17. Disconnect A/CCM connectors.

18. Remove evaporator pipe support bracket fixing.

19. Remove heater / cooler assembly fixings.
1. Remove lower nut.
2. Remove upper nuts.
20. Remove tape securing RH rear footwell intermediate duct to
rear duct joint.
Displace duct to clear heater / cooler assembly.

Installation


21. Remove tape securing LH rear footwell intermediate duct to
rear duct joint.
Displace duct to clear heater / cooler assembly.

22. Remove heater / cooler assembly from vehicle.
Guide matrix heater pipe stubs through firewall grommet
and remove assembly.

1. Install heater / cooler assembly into vehicle.
Guide matrix heater pipe stubs through firewall grommet.
Position heater / cooler as sembly against firewall.
2. Install heater / cooler assembly fixings.
Install upper fixing nuts.
Install lower fixing nut.

3. Install evaporator pipe support bracket fixing.

4. Position RH rear footwell inte rmediate duct to rear duct.
Secure with suitable cloth tape.

5. Connect condensate drain tubes from heater / cooler assembly.
6. Connect A/CCM connectors.

7. Position LH rear footwell inte rmediate duct to rear duct.
Secure with suitable cloth tape.

8. Connect heater / cooler assembly electrical connector.

9. Install LH fan motor duct.
Install duct.
Install screws.
10. Install cable tie to secure console harness to LH blower duct.

11. Install RH fan motor duct.
Install duct.
Install screws.

12. Install cable tie to secure console harness to RH blower
duct.

13. Install passenger side footwell vent.
Install vent.
Install nut.
14. Install driver footwell duct.
Install duct.
Install screw.

15. Position upper steering column and install upper fixings.
1. Install bolts, do not tighten.

16. Install upper steering column lower fixings.
Tighten fixings.

17. Tighten upper fi xing bolts.
18. Under hood: reconnect heater ho ses to heater matrix pipes.
Remove blanking plugs.
Reconnect heater hoses and secure with spring band clips.