1998 HONDA PRELUDE Owners Manual

Keys and Locks

Power Door Locks

Each door has a master door lock
switch. Either switch locks and
unlocks both doors. Push the switch down to lock both doors and up to

unlock them.
Each door has a lock tab next to the

inside door handle. When you push

in the lock tab on the driver's door,

both doors lock. Pulling out the lock

tab on the driver's door only unlocks

that door. The lock tab on the

passenger's door only locks and

unlocks that door.
To lock the passenger's door when
getting out of the vehicle, push the
lock tab in and close the door. To
lock the driver's door, remove the
key from the ignition switch and
push the lock tab in or push the
master switch down, then close the
door.

Both doors can be locked from the
outside by using the key in either

door.

To unlock only the driver's door from the outside, insert the key in
the driver's door lock, turn the key
and release it. If you turn the key
and hold it, both doors will unlock.
Both doors will unlock when you
unlock the passenger's door with the
key.
Instruments and ControlsProCarManuals.comMain Menu Table of Contents s t

Keys and Locks

Lockout Prevention

If you forget and leave the key in the
ignition switch, Lockout Prevention
will not allow you to lock the driver's door. With the driver's door open
and the key in the ignition, both
master door lock switches are
disabled.

However, if the driver's door is not open, the master door lock switches
are not disabled. Pushing the switch
down on the open passenger's door
will lock both doors. If you try to lock an open driver'sdoor by pushing in the lock tab, the
tabs on both doors pop out. Pushing
in the lock tab on the passenger's door only locks that door.
Trunk

You can open the trunk in two ways:
Pull the trunk release handle to
the left of the driver's seat. Use the master key to open the
trunk lock. The valet key does not
work in this lock.
To close the trunk, press down on

the trunk lid.

See page 129 for cargo loading and

weight limit information. Keep the

trunk lid closed at all times while
driving to avoid damaging the lid,
and to prevent exhaust gas from

getting into the interior. See Carbon
Monoxide Hazard on page 47.

Instruments and Controls
CONTINUED

TRUNK RELEASE
HANDLE MASTER KEYProCarManuals.comMain Menu Table of Contents s t

Keys and Locks
To protect items in the trunk when you need to give the key to someoneelse, lock the trunk release handle
with the master key and give the other person the valet key. Glove Box
Open the glove box by pulling the
bottom of the handle. Close it with a
firm push. Lock or unlock the glove box with the master key.

Instruments and Controls
An open glove box can cause
serious injury to your passenger
in a crash, even if the
passenger is wearing the seat

belt.

Always keep the glove box closed while driving.
MASTER KEYProCarManuals.comMain Menu Table of Contents s t

Seat Adjustments

Front Seat Adjustments
See pages 11 — 12 for important safety
information and warnings about how to
properly position seats and seat-backs.
Make all seat adjustments before
you start driving.
To adjust the seat forward and backward, pull up on the lever under
the seat cushion's front edge. Move
the seat to the desired position andrelease the lever. Try to move the
seat to make sure it is locked in

position.
To change the angle of the seat-back,
pull up on the lever on the outside of
the seat bottom. Move the seat-back
to the desired position and release the lever. Let the seat-back latch in

the new position.

Instruments and ControlsProCarManuals.comMain Menu Table of Contents s t

Seat Adjustments

Driver's Seat Height Adjustment

See pages 11 — 12 for important safety

information and warnings about how to

properly position seats and seat-backs.

To adjust the height of the driver's seat, turn the dial on the outside of
the seat bottom.
Rear Seat Access

To get into the back seat on the driver's side, pull up on the seat-back
adjustment lever.
To get into the back seat on thepassenger's side, push forward on
the release lever at the base of the seat-back. The seat-back will tilt
forward and the entire seat will move
forward to allow easier entry to the back seat. After you return the seat-
back to the upright position, push
the whole seat backwards until it
latches. Make sure the seat is fully
latched before sitting in it.

Instruments and Controls
RELEASE

LEVERProCarManuals.comMain Menu Table of Contents s t

Seat Adjustments

Head Restraints

See page 13 for important safety
information and a warning about how to
properly position the head restraints.

The front head restraints helpprotect you and your passenger from
whiplash and other injuries. They are most effective when you adjust them so the back of the occupant's head
rests against the center of the
restraint. A taller person should adjust the restraint as high as

possible.
The front head restraints adjust for
height. You need both hands toadjust the restraint. Do not attempt
to adjust it while driving. To raise it,
pull upward. To lower the restraint, push the release button sidewaysand push the restraint down.
To remove a head restraint for cleaning or repair, pull it up as far as
it will go. Push the release button and pull the restraint out of the seat-

back.

Instruments and Controls

RELEASE

BUTTONProCarManuals.comMain Menu Table of Contents s t

Seat Heaters
On Canadian models

Both front seats are equipped with
seat heaters. The ignition switch
must be ON (II) to use them. Push
the front of the switch, HI, to rapidly
heat up the seat. After the seat

reaches a comfortable temperature,
select LO by pushing the back of the
switch. This will keep the seat warm. The HI or LO indicator lights and
remains lit until you turn it off. To
turn the heater off, push theopposite side of the switch lightly.
The indicator will turn off.
In HI, the heater turns off when theseat gets warm, and turns back on
after the seat's temperature drops. It
continues to cycle as long as you
leave it set on HI. The HI indicator
remains lit as a reminder that you
have the heater on.
In LO, the heater runs continuously.
It does not cycle with temperature

changes.
Follow these precautions whenever
you use the seat heaters:
Use the HI setting only to heat theseats quickly. Select the LO
setting when the seats feel warm.
The HI setting draws large amounts of current from the
battery. Do not use the seat heaters, even
on the LO setting, if the engine is
left idling for an extended period.
They can weaken the battery, causing hard starting.

Instruments and Controls
SEAT HEATERProCarManuals.comMain Menu Table of Contents s t

Folding Rear Seat

The back of the rear seat folds down, giving you direct access to the trunk.
The seat-back can be released from inside the vehicle or inside the trunk.
To fold down the seat-back frominside the vehicle, insert the master
key in the lock on the rear shelf.
Turn the key clockwise, pull down the top of the seat-back, then release
the key. To release the seat-back from inside
the trunk, pull the release under therear shelf.
To lock the seat-back upright, push it firmly against the rear shelf. Makesure it is latched in place by pulling
on the top of the seat.

CONTINUED

Instruments and Controls

MASTER KEY

RELEASE

PullProCarManuals.comMain Menu Table of Contents s t