Page 185 of 200
Maintenance and care
185 Cleaning and maintaining the
safety belts
Clean the safety belts with a mild
soap solution recommended for
cleaning upholstery or carpets and
warm water. Do not bleach or dye
the belts, because these actions
may weaken the belt webbing.
Check the safety belt system
periodically to make sure there are
no nicks, wear or cuts.
Cleaning and caring for your
vehicle
Refer to the “Customer Assistance
Guide” for a list of Ford-approved
cleaners, polishes and waxes.
Ford recommends that all
safety belt assemblies and
attaching hardware should be
inspected by a qualified technician
after any collision. Safety belt
assemblies not in use during a
collision should also be inspected
and replaced if either damage or
improper operation is noted.
CDW VA1-19Maint en C 5/15/97 8:56 PM Page 185
Page 186 of 200
Capacities and specifications
186
*Refer to Vehicle Emission Control Information (VECI) decal for spark plug and gap specifications.
**If a spark plug is removed for examination, it must be reinstalled in the same cylinder.
If a spark plug needs to be replaced, use only spark plugs with the service part number suffix
letter “FE” as shown on the engine decal.
Motorcraft parts
Component
Spark plug*
Air filter
Passenger compartment
air filter
Fuel filter
Oil filter
Battery
PCVvalve
Crankcase ventilation
filter2.0 litre engine
AZFS-22F # 1+2**
AZFS-22FE# 3+4
FA-1612
FP4
FG-800A
FL-2005
BXT-40R
EV-224
FA-1621
2.5 litre engine
AWSF-32F
FA-1613
FP4
FG-800A
FL-820
BXT-40R
EV-152
—
Part number
CDW_VB1-5_Caps_en_C 5/15/97 8:58 PM Page 186
Page 187 of 200
Capacities and specifications
187
* Total capacity
** with automatic transaxle
Engine oil
- with filter
- without
Manual transaxle2.6 l (2.7 qts)
Automatic transaxle
with oil cooler
Power steering
Cooling system with heating
Windshield washer fluid
Fuel tank
Braking system4.25 l (4.5 qts)
3.75 l (4.0 qts)
8.5 l (9.0 qts.)
6.6 l (7.0 qts)*
7.1 l (7.5 qts)**
Fill to MAX mark
Fill to top of reservoir
61.5 l (16.2 gallons)
Fill to MAX mark5.5 l (5.8 qts)
5.0 l (5.3 qts)
9.6 l (10.2 qts)
9.5 l (10.0 qts)*
9.7 l (10.2 qts)**
Capacities2.0 litre
engine2.5 litre
engine
CDW_VB1-5_Caps_en_C 5/15/97 8:58 PM Page 187
Page 188 of 200
Capacities and specifications
188
ItemFord part name
or equivalent
High performance
DOT 3 brake fluid
Premium engine
coolant
Motorcraft motor
oil 5W-30 super
premium
MERCON
®
power steering
fluid
Motorcraft
MERCON
®ATF
Ultra-clear
windshield washer
concentrate
Ford
part number
C6AZ-19542-AB
E2FZ-19549-AA
CXC-8-B*
XO-5W30-QSP
E6AZ-19582-AA
XT-2-QDX
C9AZ-19550-AA
or
C9AZ-19550-BA
Ford
specification
ESA-M6C25-A
WSE-97B44-A
American Petroleum
Institute Certification
Mark and
WSS-M2C153-G
MERCON®
MERCON®
ESR-M17P5-A Brake fluid
Engine coolant
Engine oil
Power steering
fluid
Transaxle fluid
automatic/
5-speed manual
Windshield
washer
fluid
Lubricant Specifications
CDW_VB1-5_Caps_en_C 5/15/97 8:58 PM Page 188
Page 189 of 200
Capacities and specifications
189 Engine data
* Mechanical valve adjuster
2.0 litre
Engine2.5 litre
Engine
19882544
96 (125)
5500125 (170)
6250
176 (130)
4000220 (162)
4250
61506700
63756925
800±50
(880±50)725±50
(725±50)
1-3-4-21-4-2-5-3-6
1.3
Electronically controlled Idle speed
(manual transaxle)Engine
cm
3Capacity
kW(HP)
at rpm Power output
Nm (lb-ft)
at rpm Max. torque
Fuel required87 Octane
rpm Continuous engine
speed
rpm Max. intermittent
engine speed
rpm
Mixture preparation
Injection system
Firing order
mm
Spark plug gap
Ignition system
0.14 mm
0.30 mm Valve Inlet
clearancesExhaustHydraulic valve
adjusters 0.11-0.18*
0.27-0.34*
CDW_VB1-5_Caps_en_C 5/15/97 8:58 PM Page 189
Page 190 of 200
190
D
A
E
B C
Capacities and specifications
Dimensionsmm (inches)
4556 (179.4)
1751 (68.9)
1380 - 1427 (54.3 - 56.2)
2704 (106.5)
1499 - 1518* (59.0 - 59.8)
1483 - 1502*(58.4 - 59.1) A = Maximum length
B=Overall width (without mirrors)
C=Overall height (curb weight)
D=Wheelbase
E=Track
Front
Rear
* Dependent on tire size
CDW_VB1-5_Caps_en_C 5/15/97 8:58 PM Page 190
Page 191 of 200
191
Capacities and specifications
VEHICLE IDENTIFICATION
NUMBER
The vehicle identification number
(VIN) is attached to a metal tag
and is located on the front driver’s
side of the instrument panel. The
VIN tag may be seen by looking
through the windshield from the
outside of the vehicle.
CDW_VB1-5_Caps_en_C 5/15/97 8:58 PM Page 191
Page 192 of 200
192
Reporting safety defects
REPORTING SAFETYDEFECTS
(U.S. ONLY)
If you believe that your vehicle has
a defect that could cause a crash,
or could cause injury or death, you
should immediately inform the
National Highway Traffic Safety
Administration (NHTSA) in
addition to Ford Motor Company.
If NHTSA receives similar
complaints, it may open an
investigation, and if it finds that a
safety defect exists in a group of
vehicles, it may order a recall and
remedy campaign. However,
NHTSA cannot become involved in
individual problems between you,
your dealer or Ford Motor
Company.
To contact NHTSA, you may either
call the Auto Safety Hotline
toll–free at 1-800-424-9393
(202-366-0123 in the Washington
D.C. area) or write to
NHTSA
U.S.Department of Transportation
400 Seventh Street
Washington D.C. 20590
You can also obtain other
information about motor vehicle
safety from the hotline.
CDW_Index_en_C 5/15/97 8:59 PM Page 192