1998 BUICK REGAL headlamp

Security Feedback
Security Feedback provides audible and/or visible
feedback that a remote keyless entry lock or unlock
command has been received and executed. Your
vehicle’s ignition must be off for this feature to work.
You may select one of four operating modes for
reception of a lock command. You may also select one
of four operating modes for reception of an unlock
command. The selection and programming of the lock
and unlock operating modes are independent of each
other. The following modes are available for either lock
or unlock verification:
Mode 1: No Verification
Mode 2: Horn Chirp only
Mode 3: Headlamp Flash only
Mode &Horn Chirp and Headlamp Flash The operating
mode of the Security Feedback lock
feature will be changed when you perform the following
sequence with your vehicle’s doors closed and the
ignition key in
RUN:
1.
2.
Press and hold the power door lock switch. While
holding the door lock switch, press and release the
remote keyless entry
(RKE) transmitter lock button.
This will initialize the customization mode. While in
the customization mode, the feature will sound the
number of chimes corresponding to the current
Security Feedback lock mode.
Each additional press of the
RKE transmitter lock button
will cause your vehicle
to advance the lock mode by
one, starting from the current lock mode. If cycled
beyond lock Mode
4, the vehicle will enter lock Mode 1.
During this procedure, the feature will sound the number
of chimes corresponding to the current lock mode,
providing you with feedback. When the door lock
switch is released, the vehicle will remain in the most
recent lock mode.
2-11
ProCarManuals.com

The operating mode of the Security Feedback unlock
feature will be changed when you perform
the following
sequence with your vehicle’s doors closed and the
ignition key
in RUN:
1.
2.
Press and hold the power door unlock switch. While
holding the door unlock switch, press and release the
RKE transmitter unlock button. This will initialize
the customization mode.
While in the customization mode, the feature will
sound the number of chimes corresponding
to the
current unlock mode.
Each additional press of the
RKE transmitter unlock
button will cause your vehicle to advance the unlock
mode by
one, starting from the current unlock mode. If
cycled beyond unlock Mode
4, the vehicle will enter
unlock Mode 1. During this procedure, the feature will
sound the number of chimes corresponding to the
current unlock mode, providing you with feedback.
When the door unlock switch is released,
the vehicle
will remain in
the most recent unlock mode.
Disconnecting the vehicle’s battery for up to a year will
not change the programmed mode of the lock and
unlock Security Feedback features.
Illumination on Remote Activation
This feature provides interior illumination when a
remote keyless entry door unlock command is received
and executed by your vehicle.
Your vehicle’s ignition
must be off for the Illumination
on Remote Activation
feature to work. The interior lamps will illuminate until
your vehicle’s ignition
is turned to RUN or until an
illumination period of
40 seconds has elapsed. If a door
is opened during the illumination period, the timed
illumination will be canceled, and the interior lamps will
remain on since a door is open.
Instant Alarm
This feature allows you to activate an alarm by pressing
a button on the remote keyless entry transmitter. Your
vehicle’s ignition must be off for the Instant Alarm to
work. When you press the special horn button on the
remote keyless entry transmitter, your vehicle’s
headlamps will flash, the horn will honk repeatedly, and
your interior lamps will illuminate, attracting attention if
you need it. The alarm will continue until:
1. You press the alarm button on the RKE transmitter a
second time.
2. The vehicle’s ignition is in RUN.
3. An alarm period of about two minutes has elapsed.
2-12
ProCarManuals.com

TILT-WHEEL TM Adjustable
Steering Column
A tilt steering wheel allows
you to adjust the steering
wheel before
you drive. You
can also raise it to the
highest level to give your
legs more room when you
exit and enter the vehicle.
To tilt the wheel, hold the steering wheel and pull the
lever. Move the steering wheel to a comfortable level,
then release the lever to lock the wheel into place.
Turn SignaYMultifunction Lever
The lever on the left side of the steering column
includes your:
0 Turn Signal and Lane Change Indicator
Headlamp High/Low Beam Changer
0 Windshield Wipers
Windshield Washer
Cruise Control (Option)
0 Flash-to-Pass
2-34
ProCarManuals.com

Turn Signal and Lane Change Indicator
The turn signal has two upward (for right) and two
downward (for left) positions. These positions allow you
to signal a turn or a lane change.
To signal a turn, move the lever all the way up or down.
When the turn is finished, the lever will return
automatically.
An arrow on
the instrument
panel will flash in the
direction
of the turn or
lane change.
To signal a lane change, just raise or lower the lever
until the arrow starts to flash. Hold it there until you
complete your lane change. The lever will return
by
itself when you release it.
If the arrow flashes faster than normal as you signal a
turn or a lane change, a signal bulb may be burned out
and other drivers won’t see your turn signal.
If a bulb is burned out, replace it to help avoid an
accident. If the arrows don’t go on at all when
you
signal a turn, check for burned-out bulbs and then check
the fuse (see “Fuses and Circuit Breakers” in the Index).
A chime will sound if
you leave your turn signal on for
more than
314 mile (1.2 km).
Headlamp High/Low Beam Changer
To change your headlamps
from low beams to high
beams,
or high to low, pull
the multifunction lever all
the way toward you. Then
release it.
When the high beams are on, this light
on the instrument
panel also will be
on.
2-35
ProCarManuals.com

Flash-to-Pass Feature
This feature lets you use your high-beam headlamps to
signal the driver in front of you that you want
to pass. It
works even if your headlamps are off.
To use it, pull the turn signal lever toward you a little,
but not
so far that you hear a click.
If your headlamps are off or
on low beam, your
high-beam headlamps will turn on. They’ll stay on as
long as you hold the lever toward
you and the
high-beam indicator
on the dash will come on. Release
the lever to turn the high-beam headlamps off.
Windshield Wipers
You control the windshield wipers by turning the band
marked
WIPER. For a single wiping cycle, turn the band
to
MIST. Hold it there until the wipers start, then let go.
The wipers will stop after one cycle. If you want more
cycles, hold the band on
MIST longer.
2-36
ProCarManuals.com

Exterior Lamps
The lamp controls are located on the instrument panel.
They control these systems:
0
0
0
a
0
0
0
0
0
Headlamps
Taillamps
Parking Lamps
License Lamps Sidemarker Lamps
Instrument Panel Lights
Courtesy Lamps
Fog Lamps
Cornering Lamps If
you pull the
knob out
halfway, it will turn on your
parking lamps and your
other operating lamps.
If
you pull the knob all the
way out, your headlamps
will then come on.
Push the
knob in all the way to turn off the lamps.
A warning chime will sound
if you open the driver’s
door when you turn the ignition switch to
OFF, LOCK
or ACCESSORY with the lamps on.
2-41
ProCarManuals.com

Daytime Running Lamps / Automatic
Headlamp Control
Daytime Running Lamps (DRL) can make it easier for
others to see the front of your vehicle during the day.
DRL can be helpful in many different driving
conditions, but they can be especially helpful in the
short periods after dawn and before sunset.
A light sensor on top of the instrument panel makes the
DRL work,
so be sure it isn’t covered.
The DRL system will make your front turn signal lamps
come on when:
The ignition is on,
The headlamp switch is off and
The parking brake is released. When
the DRL are on, only your front turn signal lamps
will be
on. The headlamps, taillamps, sidemarker and
other lamps
won’t be on. Your instrument panel won’t
be lit up either.
When it’s dark enough outside, your front turn signal
lamps
will turn off and your vehicle’s headlamps and
parking lamps will turn on.
The other lamps that come
on with your headlamps will also come on.
When it’s bright enough outside, your headlamps will
go
off and your front turn signal lamps will come on.
To idle your vehicle with the DRL off, set the parking
brake while the ignition
is in OFF or LOCK. Then start
your vehicle. The
DRL, headlamps and parking lamps
will stay
off until you release the parking brake.
As with any vehicle, you should turn on the regular
headlamp system when you need it.
ProCarManuals.com

Twilight Sentinel
Twilight Sentinel provides a period of exterior
illumination
as you leave the vicinity of your vehicle.
The feature is activated when your vehicle’s headlamps
are on due to the automatic headlamp control feature
described previously
in this section, and when your
vehicle’s ignition is turned off. Your headlamps will
then remain on until the headlamp switch
is moved from
OFF to the parking lamp position or until a 90 second
illumination period has elapsed.
If you turn off the ignition with the headlamp switch in
the parking lamp or headlamp position, the Twilight
Sentinel cycle will not occur.
You can customize the vehicle to activate the Twilight
Sentinel when your vehicle’s ignition is turned off under
the conditions described above, or you may choose
not
to activate this feature under any conditions. The
enabled/disabled
state of this feature will be toggled
when
you perform the following sequence with the
doors closed and the ignition key
in RUN:
1.
2.
3.
Press and hold the power door lock switch. While
holding the door lock switch, cycle the headlamp
switch
on and then off two times.
Release
the power door lock switch. These
operations must be carried out
in a time period of
less than 10 seconds, followed by a delay period of
no more than 10 seconds.
Then, press and hold
the power door unlock switch.
While holding the door unlock switch, cycle the
headlamp switch
on and then off two times. Release
the courtesy door unlock switch. These operations
must be carried out
in a time period of less than
IO seconds.
After releasing the door unlock switch, a single chime
will be heard if the Twilight Sentinel function has been
disabled; two chimes will be heard if the feature
has
been enabled. Disconnecting the vehicle’s battery for up
to a year will not change the programmed operation of
this feature.
2-43
ProCarManuals.com