1998 BUICK REGAL jacking

If a Tire Goes Flat
10. Then replace the pressure cap. At any time during
this procedure
if coolant begins to flow out of the
filler neck, reinstall the pressure cap. Be sure the
arrows on the pressure cap line
up like this.
11. Check the coolant in the recovery tank. The level in
the coolant recovery tank should be at the HOT
mark when the engine is hot or at the COLD mark
when the engine is cold. It’s
unusual for a tire
to “blow out” while you’re driving,
especially
if you maintain your tires properly. If air goes
out of a tire, it’s much more likely to leak out slowly.
But if you should ever have
a “blowout,” here are a few
tips about what to expect and what to do:
If a front tire fails, the flat tire will create a drag that
pulls the vehicle toward that side. Take your foot off
the
accelerator pedal and grip the steering wheel firmly.
Steer to maintain lane position, and then gently brake to
a stop well out of the traffic lane.
A rear blowout, particularly on a curve, acts much like a
skid and may require the same correction you’d use in a
skid. In any rear blowout, remove your foot from the
accelerator pedal. Get the vehicle under control by
steering
the way you want the vehicle to go. It may be
very bumpy and noisy, but you can still steer. Gently
brake
to a stop -- well off the road if possible.
If
a tire goes flat, the next part shows how to use your
jacking equipment to change a flat tire safely.
5-25
ProCarManuals.com

FRONT VEHICLE
\ \
- REAR EDGE OF FRONT
WHEEL OPENING
3. For jacking at the vehicle’s front location, put the
jack lift head about
6 inches (1 5 cm) from the rear
edge of the front wheel opening or just behind the
two bolts as shown.
FRONT EDGE OF
REAR WHEEL
OPENING
4. For jacking at the vehicle’s rear location, put the jack
lift head about
5 inches (13 em) from the front edge
of the rear wheel opening or just behind the off-set
as shown.
Put the compact spare tire near
you.
5-31
ProCarManuals.com